Z. Li
,
Y.L. Yand
,
J.K Xi
,
J.X. Qu and H. S. Shao (Department of Materials Engineering
,
Luoyang institute of Technology
,
Luoyang 471039
,
China)(Beijing Graduate School
,
China University of Mining and Technology
,
Beijing 100083
,
China)
金属学报(英文版)
Annealing treatment has a strong effect on mechanical Properties of cold worked tungsten-nickel-iron heavy alloys. A 93W-4.5Ni-2.5Fe alloy swaged 15% was annealed from 500 to 1350℃ to investigate the changes in microstructure and their effects on mechanical properties. Recrystallization of W particles takes place during annealing treatments above 800℃ and the microhardnesses reduces rapidly. High density of dislocations in the, matrix phase after annealing treatment at 1350℃ suggests that recrystallization of the matrix phase has not taken place. A small decrease in microhardness of the matrix phase is caused by recovery during the annealing treatments.The changes in mechanical properties of swaged and annealed 93W-4.5 Ni-2.SFe alloy are mainly due to the changes in microstructure of W particles because of their recrystallization.
关键词:
: 93 W-4.5 Ni-2. 5 Fe alloy
,
null
,
null
Z. Li
,
S.F. Tian
,
X.G. Zhao
,
Z.K. Liang
,
L.P. Ren
,
G.F.Mi and M.G. Yan(Bejing Institute of Aeronautical Materials
,
Beijing 100095
,
China Manuscript received 26 August 1996)
金属学报(英文版)
In this paper,part of the research and development work in the field of spray formed superalloys at BIAM of China is briefly summarized. With an experimental spray forming facility,whose melting capacity is suitable for making disk and columnar shaped integral-dense and clean Ni-base superalloy preforms with low oxygen content,fine grain, uniform chemistry and improved forgeability, a series of Ni-base superalloys have been spray atomized and deposited, among which three alloys have been chosen for microstructural and mechanical properties evaluation.
关键词:
:spray forming
,
null
,
null
Z. Li
,
G.Q. Zhang
,
Z.H. Zhang
,
S.F. Tian
金属学报(英文版)
In order to evaluate the deformation characteristics of spray formed superalloy GH742
and determine the appropriate forging procedure of the alloy on this basis, the influence
of deformation temperature and strain rate on the ductility of spray formed GH742
was investigated by using the Gleeble-3500 thermal-mechanical testing machine. It is
shown that the forgeability of spray formed GH742 is better than conventional GH742
by ingot metallurgy because of refined grain structure and enhanced chemical homo-geneity of spray formed GH742. In the temperature range of 1020 to 1100℃, the
ductility of spray formed GH742 is dependent on the deformation temperature and is
increased linearly in proportion to the increment of deformation temperature, which
is more than 40% at 1020℃ and more than 60% at the temperature between 1100
and 1140℃. Furthermore, the results indicate the flow stress is affected considerably
by the deformation temperature and strain rate. In the temperature range of 1020 to
1140℃, the maximum flow stress of spray formed GH742 increases with the increment
of strain rate and decreases with the increment of the deformation temperature.
关键词:
spray forming
,
null
,
null
,
null
