Xiaodong WANG
,
Baoxu HUANG
,
Yonghua RONG
,
Li WANG
,
null
,
null
,
null
,
null
材料科学技术（英文）
Transformation induced plasticity (TRIP) steels combine high strength and excellent ductility, making them suited for application in crash-relevant parts in the automotive industry. However, the high Si contents in the conventional TRIP steel will generate surface defects on the hot rolled strip, which is difficult to process in continuous galvanizing lines. In order to solve the above problem the TRIP steel with the addition of Al replacing majority of Si was designed. In the present paper, the volume fraction of various phases in a C-Mn-Si-Al-Cr TRIP steel was determined by metallographic examination and X-ray diffraction analysis, and the multi-phase microstructures were characterized using an atomic force microscope based on their height difference. Tensile tests were performed at different temperatures ranging from -40℃ to 90℃. The results show that transition temperature MSσ in the present TRIP steel cannot be determined due to its lower volume fraction of retained austenite, different from the conventional TRIP steel. While the yield stress and tensile strength at different temperatures are higher than those of the conventional TRIP steel, which is attributed to the addition of Cr. In order to evaluate the effect of martensitic transformation on the total elongation, the sample without retained austenite obtained by quenching in liquid nitrogen was carried out under tensile test. The results indicate that the elongation of the original sample containing 9% retained austenite is about 20% higher than that of the sample quenched in liquid nitrogen, which demonstrates that the retained austenite plays an important role in improving the elongation of the TRIP steel.
关键词:
TRIP steel
,
steel
,
mechanical
,
properties
,
retaine
Xiaodong WANG
,
Riguang JIN and Hangquan LI (Beijing University of Chemical Technology
,
Beijing
,
100029
,
China)
材料科学技术（英文）
In this study, the blends of polypropylene (PP) and ultrahigh molecular weight polyethylene (UHMWPE) were prepared by the four-and twin-screw extruders, and ethylene-propylene-diene monomer (EPDM), as the third component, was added to the binary blends. The mechanical.thermal, morphological and rheological properties of these two blends have been investigated.For the materials blended by the four-screw extruder, a 15 wt-% content of UHMWPE corresponds to a maximum lzod impact strength, and the miscibility enhancement effect of EPDM on PP/UHMWPE blends is very remarkable. Mechanical and thermal properties demonstrate that melt blending by the four-screw extruder is a better prcessing method for PP/UHMWPF blends than that by the twin-screw extruder. A co-continuous structure was observed in blends through TEM, and a novel "linear interpenetrating" toughening mechanism is proposed on the basis of this research work
关键词:
Xiaodong WANG
,
Hangquan LI
,
Riguang JIN
材料科学技术（英文）
The miscibility and phase behavior of the blends of polyoxymethylene (POM)/Novolak were investigated by the cloud point method, which showed that the POM/Novolak blends exhibited a lower critical solution temperature. The melting point of POM decreased when diluted with Novolak. From the melting temperature depression of POM, a negative interaction parameter (chi) between POM and Novolak was obtained. The IR spectrum revealed that the miscibility between POM and Novolak was caused by the specific interaction between the OH groups of Novolak and the ether oxygen atoms of POM. The morphology of the blends investigated by polarized light microscopy showed that the size of spherulites of POM was sharply decreased by its mixing with Novolak. This suggests that Novolak be used as a compatibilizer for POM.
关键词:
