LIU Guang-ming
,
DI Hong-shuang
,
ZHOU Cun-long
,
LI Hong-cui
,
LIU Jiang
钢铁研究学报(英文版)
In order to lucubrate the rolling characteristic of the two stands reversible cold rolling mill and establish the tension and thickness control strategy, the steady-state characteristic simulating program was established using the steady-state continuous rolling theory. The influences of each factor on exit thickness under different tension control methods were analyzed. The results show that, the influence of the entry stand gap on exit thickness is significant and it changes little with different tension control methods. As a result, the entry stand gap can be used as the main control method of exit thickness, whereas rolling speed of any stand and roll gap of the exit stand can be used to adjust the inter-stand tension. The results are beneficial for thickness and tension control of the two stands reversible cold rolling mill.
关键词:
two stand
,
reversible cold rolling
,
thickness
,
tension
,
control strategy
WANG Xiao-nan
,
DI Hong-shuang
,
ZHANG Chi
,
DU Lin-xiu
,
DONG Xue-xin
钢铁研究学报(英文版)
CO2-shielded welding experiments of newly developed, 780 MPa super-high strength heavy-duty truck crossbeam steel were conducted, and the microstructure, microhardness, mechanical properties, and impact toughness of the welded joint were studied. The evolution of the microstructure of the welded joint occurred as follows: welding seam (acicular ferrite+proeutectoid ferrite)→fusion zone (granular bainite-long strip M/A island)→coarse grain zone (granular bainite-long strip or short bar M/A island)→fine grain zone (ferrite+pearlite+blocky M/A island)→mixed grained zone (ferrite+granular bainite+blocky M/A island)→base metal (proeutectoid ferrite+granular bainite-blocky or granular M/A island). Increasing the density of the grain boundaries can effectively improve the impact toughness, and the blocky M/A island hindered crack propagation more effectively than the long strip M/A island. The new hot-rolled 780 MPa super-high strength steel had excellent weldability. The welding technology was applied under the following conditions: welding voltage was 20 to 21 V, welding current was 200 to 210 A, and the gas flow rate was 25 L/min.
关键词:
super-high strength steel
,
crossbeam steel
,
weldability
,
M/A island
,
impact toughness
