Y.P.Jiang
,
Z.F.Yue
金属学报(英文版)
A unit cell model is applied to study the creep damage behavior after fiber fractures in the fiber-reinforced composites at high temperature. The user subroutine CREEP has been programmed for ABA QUS. The fiber breakage results in a new crack. The results show that the stress concentration factor resulted from the fiber breakage increases with the creep time. The creep damage takes place near the crack, and then grows in the matrix along a certain angle, up to the total failure. The influences of the ratio of modulus of the fiber to the matrix (Ef/Em) on the creep deformation, damage and stress distributions have been studied. With the increasing Ef/Em, the damage in the matrix increases. Analysis on the different ductility of matrix shows that the creep damage of low ductile matrix composites is higher than high ductile matrix composites.
关键词:
composites
,
null
,
null
B.Zhao
,
B.X.Xu
,
J.Liu
,
Z.F.Yue
金属学报(英文版)
Indentation creep behavior with cylindrical flat indenters on the thermal barrier coating (TBC) was studied by finite element method (FEM). On the constant applied indentation creep stress, there is a steady creep rate for each case studied for different creep properties of the TBC system. The steady creep depth rate depends on the applied indentation creep stress and size of the indenters as well as the creep properties of the bond coat of the TBC and the substrate. The possibilities to determine the creep properties of a thermal barrier system from indention creep testing were discussed. As an example, with two different size indenters, the creep properties of bond coat of the TBC system can be derived by an inverse FEM method. This study not only provides a numerical method to obtain the creep properties of the TBC system, but also extends the application of indentation creep method with cylindrical flat indenters.
关键词:
thermal barrier coating (TBC) system
,
null
,
null
Q.M.Yu
,
Z.F.Yue
金属学报(英文版)
Numerical calculations of creep damage development and life behavior of circular notched specimens of nickel-base single crystal had been performed. The creep stress distributions depend on the specimen geometry. For a small notch radius, von Mises stress has an especial distribution. The damage distribution is greatly influenced by the notch depth, notch radius as well as notch type. The creep crack initiation place is different for each notched specimen. The characteristics of notch strengthening and notch weakening depend on the notch radius and notch type. For the same notch type, the creep rupture lives decrease with the decreasing of notch radius. A creep life model has been presented for the multiaxial stress states based on the crystallographic slip system theory.
关键词:
creep
,
null
,
null
X.J.Shao
,
Y.P.Jiang
,
Z.F.Yue
金属学报(英文版)
A 3-D micro cell model with multi-fibers has been presented to study the effects of breakage of single fiber on the whole creep behavior of fiber reinforced composites by finite element method (FEM). Before the fiber breakage, the stresses of all fibers are identical. With the creep time increasing, stress in fiber increases but stress in matrix decreases. It is assumed that the fiber breakage occurs when the stress in fiber reaches a critical value. The stress redistribution resulted from the breakage of fiber has been obtained. The influence on the axial stress of the broken fiber is local. The stress in the all fiber sections is not uniform. There is a local stress concentration in the matrix. And this stress concentration in the matrix is more and more serious with the creep deformation. The stress transference of the loading due to the fiber breakage has been studies numerically. It is found that the fibers near to the broken fiber will take over more loading.
关键词:
fiber reinforced composites
,
null
,
null
