Suzhen LUO
,
Yugui ZHENG
,
Wei LIU
,
Heming JING
,
Zhiming YAO
,
Wei KE
材料科学技术（英文）
The cavitation erosion (CE) behavior of CrMnN ferrite-austenite duplex stainless steel in distilled water and 3% NaCl solution was investigated by using a magnetostrictive-induced CE facility. The damaged surfaces were observed by scanning electron microscope (SEM). It was found that the CE resistance of CrMnN steel was higher than that of 0Cr13Ni5Mo steel. The mass loss rate of CrMnN steel in distilled water was similar to that in 3% NaCl except at the early stage of CE. The failure mode of ferrite phase was brittle fracture, which had adverse effect on the resistance to CE, while the failure of austenite phase was a ductile failure in CrMnN steel. The excellent resistance to CE was related to the good mechanical properties of austenitic phase and the consumption of CE energy by plastic deformation involving slip and twinning.
关键词:
Cavitation erosion
,
null
,
null
Xinguo ZHAO
,
Zhidong ZHANG
,
Zhijun GUO
,
Wei LIU
,
Dianyu GENG
,
Baozhi CUI
材料科学技术（英文）
The alloy with nominal composition Sm-2(Fe0.94Ti0.06)(l7) is prepared by are-melting, hydrogenation and nitrogenation processes. The Sm-2(Fe0.94Ti0.06)(17) alloy has a single phase of Sm-3(Fe, Ti)(29) with the Nd-3(Fe, Ti)(29)-type structure. The corresponding hydride phase with the same phase structure of the parent alloy was formed after a hydrogen decrepitation (HD) process at 300 degrees C. The hydrogenation at 800 degrees C mainly shows a HDDR process. The HD and nitrogenation at 500 degrees C result in increasing the Curie temperature of the alloy by 72 degrees C and by 158 degrees C due to lattice expansions, respectively. The anisotropic and isotropic Sm-3(Fe, Ti)(29)Ny magnets are obtained after HD, HDDR and the consequent nitrogenation, respectively. The optimum magnetic properties of Sm-3(Fe, Ti)(29)Ny powders achieved in the above two processes are: (i) B-r=0.82 T, H-i(c)=4.48 kA/cm, (BH)(max)=54.3 kJ/m(3), (ii) B-r=0.68 T, H-i(c)=8.14 kA/cm, (BH)(max)=66.4 kJ/m(3).
关键词:
Dianyu GENG
,
Zhidong ZHANG
,
Baozhi CUI
,
Zhijun GUO
,
Wei LIU
,
Xinguo ZHAO
材料科学技术（英文）
The structure and magnetic properties of SmyFe(100-1.5)yC(0.5y)(y=8 similar to 20) alloys prepared by mechanical alloying (MA) from Sm, Fe and graphite have been investigated systematically. In order to improve hard magnetic properties of the alloys prepared by mechanical alloying, a new method consisting of re-milling and re-annealing was developed. After being re-milled and re-annealed, the Curie temperature T-C of the Sm-Fe-C alloys changes. The T-C of 2:17 phase increases, whereas the T-C of 2:14:1 phase decreases. After being re-annealed at low temperatures, the grain sizes of hard phases are smaller than those in the alloys annealed at high temperatures. The effects of Co or Ti substitution for Fe are studied.
关键词:
Jian ZHANG
,
Xiaokai SUN
,
Wei LIU
,
Baozhi CUI
,
Xinguo ZHAO
,
Zhidong ZHANG
材料科学技术（英文）
Structure and magnetic properties of the nanocomposite magnets prepared by mechanical alloying procedure with composition 55 wt pct Nd (Fe0.92B0.08)5.5+45 wt pct a-Fe, 55 wt pct Nd(Fe0.8-xCo0.12Nbx B0.08)5.5+45 wt pct a-Fe (x=0.00, 0.01, 0.03) and 55 wt pct (Nd0.9Dy0.1) (Fe0.77Co0.12Nb0.03B0.08)5.5+45 wt pct a-Fe were studied. It was found that substitution of Co for Fe could significantly improve the permanent magnetic properties of the nanocomposite magnets and typically, the maximum magnetic energy product was increased from 104.8 kJ/m3 (13.1 MGOe) to 141.6 kJ/m3 (17.7 MGOe). In contrast to the case of conventional nominally single-phase magnets, the addition of Nb results in promoting the growth of a-Fe grain and is thus unfavorable for the improvement of permanent magnetic properties of the nanocomposites. Although the addition of Dy can increase the coercivity of the magnets, the increase of magnetic anisotropy of hard phase leads to decrease of the critical grain size of soft phase. Additionally it causes the difficulty of preparing the nanocomposites because it is more difficult to control the grain size of soft phase to meet the requirement of appropriate exchange coupling between hard and soft grains.
关键词:
Dingkang XIONG
,
Xiaokai SUN
,
Liangyue XIONG
,
Wei LIU
,
Tong ZHAO
,
Zhidong ZHANG
材料科学技术（英文）
Positron annihilation behaviors have been studied in the single phase Nd2Fe14B magnet and the nanocomposite Nd2Fe14B/alpha -Fe magnet, prepared by melt spinning. The results showed that the number of vacancy-cluster at grain boundaries increases with increasing annealing temperature for the both types of magnets. The increase of this kind of defect can improve the coercivity of the single-phase magnet. Conversely, the increase of vacancy-cluster amount leads to decreasing of the coercivity for the nanocomposite magnet. It implies that the mechanism of dominant magnetic hardening for the two types of magnets is different, and the domain walls pinning mechanism in the single-phase magnet and the reversal magnetization nucleation mechanism in the nanocomposite magnet operate, respectively.
关键词:
Haifei YAO
,
Jialin SUN
,
Wei LIU
,
Hongsan SUN
材料科学技术（英文）
The effect of an external magnetic field on the preparation of silver nanowires was studied. The silver nanowires were synthesized using solid electrolyte RbAg4I5 thin films by applying both a direct current (DC) electric field and a magnetic field. The RbAg4I5 thin films, which were prepared by deposition at room temperature and atmospheric pressure on a NaCl substrate, were used for the transfer of Ag+ ions between two Ag electrodes during the preparation process. When only the DC electric field is applied, the silver ions migrate toward the cathode. On the edge of the silver film at the cathode the Ag+ ions congregate to form aligned nanowires. If the magnetic field is also applied perpendicular to the DC electric field, the morphology of the nanowires can be controlled by rotating the sample in the magnetic field. Experimental results show that the growth of the silver nanowires is determined by the Ag+ ionic flux.
关键词:
Silver nanowires
,
固体电解质
,
磁场
