ZHOU Guanghong
,
DING Hongyan
,
ZHOU Fei
,
ZHANG Yue
钢铁研究学报(英文版)
NiPnano Al2O3 composite coatings were deposited by electroless plating, and their microstructures were observed by SEM (scanning electron microscope). The microhardness and the wear resistance of the NiPnano Al2O3 composite coatings were measured using microhardness tester and blockonring tribometer, respectively, and the comparison with those of NiP coatings or NiPmicro Al2O3 coating was given. The influences of aging temperature on their hardness and wear resistance were analyzed. The results showed that the nano Al2O3 particles were distributed uniformly in the NiPAl2O3 coatings. Among three kinds of NiP based coatings, the hardness and wear resistance of NiPnano Al2O3 coatings were largest, and the maximum values could be obtained at 400 ℃. This indicated that the precipitation of nano Al2O3 particles would improve the hardness and wear resistance of the NiP coatings.
关键词:
composite coating;nano Al2O3;aging treatment;mechanical property
Physical Review B
In order to understand the unusually large value of zero-field splitting D for the axial Fe3+ center in a KTaO3 crystal, Zhou made two assumptions in his recent report [Phys. Rev. B 42, 917 (1990)]. In this Comment we will show that his assumption II is qualitatively reasonable, whereas assumption I is unnecessary and doubtful.
关键词:
electric-field;srcl2
Journal of Physics and Chemistry of Solids
The layered ternary ceramics Ti3SiC2 and Ti3AlC2 are isostructural and can form Ti3Si1-xAlxC2 solid solutions combining the advanced properties of both compounds [H.B. Zhang, Y.C. Zhou, Y.W. Bao, M.S. Li, Improving the oxidation resistance of Ti3SiC2 by forming a Ti3Si0.90Al0.1C2 solid solution, Acta Mater. 52 (2004) 3631-3637; E.D. Wu, J.Y. Wang, H.B. Zhang, Y.C. Zhou, K. Sun, Y.J. Xue, Neutron diffraction studies of Ti3Si0.9Al0.1C2 compound, Mater. Lett. 59 (2005) 2715-2719; J.Y. Wang, Y.C. Zhou, First-principles study of equilibrium properties and electronic structure of Ti3Si0.75Al0.25C2 solid solution, J. Phys.: Condens. Matter 15 (2003) 5959-5968; Y.C. Zhou, J.X. Chen, J.Y. Wang, Strengthening of Ti3AlC2 by incorporation of Si to form Ti3Al1-xSixC2 solid solutions, Acta. Mater. 54 (2006) 1317-1322]. In the present work, the solid solutions of Ti3Si1-xAlxC2 (x = 0, 0.25, 0.33, 0.5, 0.67, 0.75, 1) are investigated by first-principle calculations based on pseudo-potential plan-wave method within the density functional theory framework. The results show that as Al content increases in the solid solution, all the bonds have weakened to certain extents, which lead to an unstable structure both energetically and geometrically. The calculated results are compared and discussed with the reported data for the Ti3Si1-xAlxC2 solid solutions. (c) 2007 Elsevier Ltd. All rights reserved.
关键词:
ceramics;ab initio calculations;electronic structure;electrical;conductivity;oxidation behavior;mechanical-properties;ti3sic2;temperature;ti3alc2;air;si
Haihua LIU
金属学报(英文版)
doi:10.1016/S1006-7191(08)60120-9
A novel method was reported to measure the remnant magnetic field in Lorentz mode in a FEI Tecnai F20 transmission electron microscope equipped with a Lorentz lens. The movement of the circle Bloch line of the cross-tie wall in Permalloy is used to measure the remnant magnetic field by tilting the specimen and adjusting the objective lens current. The remnant magnetic field is estimated to be about 17 Oe, in a direction opposite to that of the objective lens magnetic field. The remnant magnetic field can be compensated by adjusting the value of the objective lens current.
关键词:
Lorentz electron microscopy
,
Lorentz lens
,
remnant magnetic field
,
Permalloy
,
cross-tie walls
ZHOU Jiankun LIU Xianghuai CHEN Youshan WANG Xi ZHENG Zhihong HUANG Wei ZOU Shichang Shanghai Institute of Metallurgy
,
Academia Sinica
,
Shanghai
,
China
金属学报(英文版)
The TiN films were synthesized with an alternate process of depositing titanium from a E-gun evaporation source and 40 keV N~+ bombarding onto the target.It is shown from the composi- tion analysis and structure investigations using RBS,AES,TEM,XPS and X-ray diffraction spectrum that the formed fihns are mainly composed of TiN phase with grain size of 30—40 nm and without preferred orientation,the nitrogen content in the film is much less than that in case without N~+ bombarding,and an intermixed region about 40 nm thick exists between the film and the substrate.The films exhibt high microhardness and low friction. ZHOU Jiankun,Ion Beam Laboratory,Shanghai Institute of Metallurgy,Academia Sinica, Shanghai 200050,China
关键词:
TiN film
,
null
刘天成
,
卢志超
,
李德仁
,
孙克
,
周少雄
,
卢燕平
功能材料
采用电沉积方法从硫酸盐体系镀液中沉积得到Fe18Ni82合金薄膜.运用扫描电子显微镜(SEM),原子力显微镜(AFM),透射电子显微镜(TEM)和X射线衍射分析(XRD)以及磁测量设备分别对薄膜的表面形貌、显微结构和磁性能进行表征和测量.同时利用万能材料试验机和显微硬度计测量了薄膜的力学性能.结果表明:电沉积制备的Fe18Ni82合金薄膜成分均匀,表面平整、光亮、致密,晶粒大小为40～50 nm.薄膜是以Ni为溶剂原子,Fe为溶质原子的置换型固溶体,只存在单一的fcc相,Fei8Ni82合金薄膜沿(111)面有较强的择优取向.镀态Fei8Ni82合金薄膜在50 Hz交流磁场下,测得其饱和磁感应强度为1.08 T,最低矫顽力为20 A/m.19 μm厚的纳米晶薄膜的断裂应力达到785MPa,显微硬度达到605Hv.
关键词:
铁镍合金
,
薄膜
,
电沉积
,
纳米结构
,
性能
邓联文
,
周亮
,
李慧敏
,
黄生祥
,
丁丽
,
周克省
材料导报
利用ZnFeO4铁氧体材料居里温度对Zn含量敏感的特点,将其作为主成分,通过Cu、Ti离子掺杂技术调整居里温度并提高材料的温度稳定性.采用传统氧化物工艺制备CuTiZn尖晶石铁氧体材料;采用测量起始磁导率的温变曲线间接测量居里温度的方法,获得了CuTiZn磁热铁氧体材料的居里温度.结果表明,Zn含量增加将使居里温度快速下降;材料成分为Cu.0.45Zn0.55Ti0.03Fei.97O4时居里温度为44.9℃,起始磁导率达852.5,且居里温度点磁导率的变化率达50.3/℃,该组分的CuZnTi铁氧体具有良好的自控温灵敏度,可以用作温热疗法磁热材料.
关键词:
CuTiZn铁氧体
,
居里温度
,
磁热效应
,
温热疗法
马建勋
,
严密
,
赵传礼
,
肖洪博
,
文玉华
,
杨德仁
材料科学与工程学报
doi:10.3969/j.issn.1673-2812.2005.02.023
本文研究了Sm含量,凝固速度及Nb和Zr元素的添加对Sm-Fe合金微观组织及氮化后Sm2Fei7Nx合金磁性能的影响.研究结果表明:采用真空感应炉熔炼Sm-Fe合金,当Sm的补偿量大于10wt%时,合金铸锭组织中出现大量的富Sm相,这将导致氮化后磁体磁性能的恶化;提高铸锭的冷却速度及添加Nb和Zr等元素可以有效地细化铸锭中α-Fe相的晶粒,减少均匀化退火后α-Fe相的数量,提高磁性能.
关键词:
微观组织
,
Sm2Fei7Nx
,
磁性能
Physical Review B
The assignment of the absorption spectrum of Y3Fe5O12 (YIG) made by Scott et al. [Phys. Rev. B 10, 971 (1974)] is shown to be incorrect and a new one is made by diagonalizing the complete cubic crystal-field matrices for d5 ions, involving spin-orbit interaction, given by Zhou et al. [Phys. Rev. B 44, 7499 (1991)]. The Racah parameters B and C, the crystal-field parameter Dq, and the spin-orbit coupling coefficient zeta are determined (in units of cm-1) as B = 783.3(530), C = 2928(3220), Dq = 1336(1300), zeta = 395 for octahedral Fe3+, and B = 606.1(705), C = 2696(2730), Dq = -1117.3(560), zeta = 335 for tetrahedral Fe3+, where the numerals in parentheses are the values adopted by Scott et al. Furthermore, the cubic zero-field splitting parameter a of Fe3+ in YIG is calculated to be a(oct) = 156 X 10(-4) cm-1 and a(tet) = 58.6 X 10(-4) cm-1. The value for a(oct) differs from the value of 189 X 10(-4) cm-1 found for Fe3+ in Y3Ga5O12:Fe3+. These results support speculations made by Geschwind [Phys. Rev. 121, 363 (1961)].
关键词:
fe3+;mn2+
