ZHENG Xiao-fei
,
KANG Yong-lin
,
MENG De-liang
,
AN Shou-yong
,
XIA Dian-xiu
钢铁研究学报(英文版)
The effect of cooling (laminar cooling) start temperature on the phase constitution was analyzed by quantitative metallography. The martensite/austenite (M/A) island distribution was fixed by colour metallography. The strength and uniform elongation of the steels were tested with quasi-static tensile testing machine. The in-coordinate deformation of the soft and hard phases was analyzed using FEM. The results indicate that when the cooling start temperature is 690 ℃, the mechanical properties are the best, meeting the requirements of X80 high deformability pipeline steel.
关键词:
high deformability pipeline steel
,
cooling start temperature
,
carbon diffusion
,
in-coordinate deformation
,
M/A island
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms
A static Monte Carlo simulation program has been used to study the influence of primary and secondary knock-on atoms on the angular distribution and the fractionation, for zero-fluence sputtering of Mo-92-Mo-100. At 10 keV Xe ion energy, calculations show that significant depth-dependent momentum asymmetry exists in the near-surface region, as in Refs. (L.P. Zheng, R.S. Li, M.Y.LI, Nucl. Instr, and Meth. B 100 (1995) 490; L.P. Zheng, M.Y. Li, Nucl. Instr. and Meth. B 114(1996) 28). The calculations also show that at the polar emission angle range between 0 degrees and 90 degrees the probabilities of the sputtered primary knock-on atoms for Mo-92 and Mo-100 are small (6.1% for Mo-92 and 6.6% for Mo-100), especially, between 0 degrees and 30 degrees they are very small (2.5% for Mo-92 and 2.8% for Mo-100). At 0.1 keV Ar ion energy, the calculations show that partial momentum flux ratios, for the primary and the secondary knock-on atoms, deviate far from one, through marker plane 1 (about an atomic layer distance from the surface). (C) 1998 Elsevier Science B.V. All rights reserved.
关键词:
mo-92-mo-100;targets
Haihua LIU
金属学报(英文版)
doi:10.1016/S1006-7191(08)60120-9
A novel method was reported to measure the remnant magnetic field in Lorentz mode in a FEI Tecnai F20 transmission electron microscope equipped with a Lorentz lens. The movement of the circle Bloch line of the cross-tie wall in Permalloy is used to measure the remnant magnetic field by tilting the specimen and adjusting the objective lens current. The remnant magnetic field is estimated to be about 17 Oe, in a direction opposite to that of the objective lens magnetic field. The remnant magnetic field can be compensated by adjusting the value of the objective lens current.
关键词:
Lorentz electron microscopy
,
Lorentz lens
,
remnant magnetic field
,
Permalloy
,
cross-tie walls
刘天成
,
卢志超
,
李德仁
,
孙克
,
周少雄
,
卢燕平
功能材料
采用电沉积方法从硫酸盐体系镀液中沉积得到Fe18Ni82合金薄膜.运用扫描电子显微镜(SEM),原子力显微镜(AFM),透射电子显微镜(TEM)和X射线衍射分析(XRD)以及磁测量设备分别对薄膜的表面形貌、显微结构和磁性能进行表征和测量.同时利用万能材料试验机和显微硬度计测量了薄膜的力学性能.结果表明:电沉积制备的Fe18Ni82合金薄膜成分均匀,表面平整、光亮、致密,晶粒大小为40～50 nm.薄膜是以Ni为溶剂原子,Fe为溶质原子的置换型固溶体,只存在单一的fcc相,Fei8Ni82合金薄膜沿(111)面有较强的择优取向.镀态Fei8Ni82合金薄膜在50 Hz交流磁场下,测得其饱和磁感应强度为1.08 T,最低矫顽力为20 A/m.19 μm厚的纳米晶薄膜的断裂应力达到785MPa,显微硬度达到605Hv.
关键词:
铁镍合金
,
薄膜
,
电沉积
,
纳米结构
,
性能
李红
,
孙克
,
李艳萍
,
石毅
,
郭金花
,
卢志超
金属功能材料
提出了采用推杆式热膨胀仪测试非晶合金薄带热膨胀特性的新方法.分析了Fe80Si9B11非晶薄带的热膨胀曲特性和非晶合金晶化过程.根据R.G.Zheng理论分析了结构弛豫中自由体积比变化,发现自由体积比曲线出现双峰.结合晶化前发生相分离的理论分析了这种变化的原因.分析表明:铁基非晶Fe80Si9B11晶化过程中先形成α-Fe(Si)相,再析出Fe3B、二次α-Fe(Si)相.晶化前先发生相分离,自由体积比增大,然后析出结晶相α-Fe(Si),自由体积比降低.随温度升高,B偏聚,自由体积比增大,随后析出Fe3B、二次α-Fe(Si)相,自由体积比降低.
关键词:
铁基非晶薄带
,
热膨胀系数
,
自由体积比
,
结构弛豫
邓联文
,
周亮
,
李慧敏
,
黄生祥
,
丁丽
,
周克省
材料导报
利用ZnFeO4铁氧体材料居里温度对Zn含量敏感的特点,将其作为主成分,通过Cu、Ti离子掺杂技术调整居里温度并提高材料的温度稳定性.采用传统氧化物工艺制备CuTiZn尖晶石铁氧体材料;采用测量起始磁导率的温变曲线间接测量居里温度的方法,获得了CuTiZn磁热铁氧体材料的居里温度.结果表明,Zn含量增加将使居里温度快速下降;材料成分为Cu.0.45Zn0.55Ti0.03Fei.97O4时居里温度为44.9℃,起始磁导率达852.5,且居里温度点磁导率的变化率达50.3/℃,该组分的CuZnTi铁氧体具有良好的自控温灵敏度,可以用作温热疗法磁热材料.
关键词:
CuTiZn铁氧体
,
居里温度
,
磁热效应
,
温热疗法
