LI Ke-qing
,
NI Wen
,
ZHU Ming
,
ZHENG Mei-juan
,
LI Yuan
钢铁研究学报(英文版)
A laboratory experiment was carried out to extract iron from oolitic iron ore by a deep reduction and magnetic separation technique. The raw coal with fixed carbon of 66.54% was used as the reductant. The iron was successfully extracted from the oolitic iron ore which otherwise is nearly impossible to be separated due to its extremely fine-grain and mosaic nature. The results showed that an iron recovery rate of 90.78% and an iron content of 92.53% of iron concentrate could be obtained by such a technique. The optimized roast temperature is 1200 ℃ and time is 60 min. The subsequent magnetic separation was performed by using a magnetic field intensity of 111 kA·m-1 and a grinding fineness less than 45 μm of 96.19% for the sintered product.
关键词:
oolitic hematite
,
deep reduction
,
magnetic separation
马乾志
,
郭杨龙
,
王艳芹
,
郭耘
,
张志刚
,
卢冠忠
无机材料学报
doi:10.3321/j.issn:1000-324x.2007.05.033
采用TS-1前驱体作硅源和钛源,以十二胺为模板剂,在中性和室温条件下合成了介孔含钛分子筛Ti-HMS-1.采用XRD、TEM、低温N2吸附、FT-IR和UV-Vis等方法对合成的分子筛进行了表征;以苯乙烯的催化氧化反应为模型反应,考察了合成的Ti-HMS-1的催化氧化性能.结果表明,Ti-HMS-1具有"worm-like"介孔结构,但长程有序度较低,孔壁部分含有MFI的次级结构单元,在373K沸水中水煮50h后,Ti-HMS-1仍能较好地保持原有的介孔结构,表明Ti-HMS-1具有较高的水热稳定性.进入分子筛骨架的钛原子为催化剂的活性中心,对于苯乙烯氧化反应,具有较高的催化活性,对产物的选择性与Ti-HMS接近.
关键词:
Ti-HMS-1分子筛
,
合成
,
表征
,
苯乙烯氧化
Journal of Chemical Physics
Based on Mei's embedded atom model [Mei , Phys. Rev. B 43, 4653 (1991)] molecular dynamics simulations have been performed to investigate the rapidly cooling processes of Cu. The atomic transport property, namely the self-diffusion coefficient, is computed in the liquid state, and the results near the melting point of Cu are in good agreement with experimental data and other computational values. The atom diffusion movements during the long period of relaxation have been also studied around the solidification temperature T-c. To describe the complex microstructural evolutions during the rapidly cooling processes and the long relaxation processes, the pair correlation function and the pair analysis technique are used. It is demonstrated that the crystallization of amorphous Cu is caused by the atomic diffusion. (C) 2004 American Institute of Physics.
关键词:
transition-metals;computer-simulation;supercooled-liquid;model;fcc;potentials;diffusion
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms
A static Monte Carlo simulation program has been used to study the influence of primary and secondary knock-on atoms on the angular distribution and the fractionation, for zero-fluence sputtering of Mo-92-Mo-100. At 10 keV Xe ion energy, calculations show that significant depth-dependent momentum asymmetry exists in the near-surface region, as in Refs. (L.P. Zheng, R.S. Li, M.Y.LI, Nucl. Instr, and Meth. B 100 (1995) 490; L.P. Zheng, M.Y. Li, Nucl. Instr. and Meth. B 114(1996) 28). The calculations also show that at the polar emission angle range between 0 degrees and 90 degrees the probabilities of the sputtered primary knock-on atoms for Mo-92 and Mo-100 are small (6.1% for Mo-92 and 6.6% for Mo-100), especially, between 0 degrees and 30 degrees they are very small (2.5% for Mo-92 and 2.8% for Mo-100). At 0.1 keV Ar ion energy, the calculations show that partial momentum flux ratios, for the primary and the secondary knock-on atoms, deviate far from one, through marker plane 1 (about an atomic layer distance from the surface). (C) 1998 Elsevier Science B.V. All rights reserved.
关键词:
mo-92-mo-100;targets
李红
,
孙克
,
李艳萍
,
石毅
,
郭金花
,
卢志超
金属功能材料
提出了采用推杆式热膨胀仪测试非晶合金薄带热膨胀特性的新方法.分析了Fe80Si9B11非晶薄带的热膨胀曲特性和非晶合金晶化过程.根据R.G.Zheng理论分析了结构弛豫中自由体积比变化,发现自由体积比曲线出现双峰.结合晶化前发生相分离的理论分析了这种变化的原因.分析表明:铁基非晶Fe80Si9B11晶化过程中先形成α-Fe(Si)相,再析出Fe3B、二次α-Fe(Si)相.晶化前先发生相分离,自由体积比增大,然后析出结晶相α-Fe(Si),自由体积比降低.随温度升高,B偏聚,自由体积比增大,随后析出Fe3B、二次α-Fe(Si)相,自由体积比降低.
关键词:
铁基非晶薄带
,
热膨胀系数
,
自由体积比
,
结构弛豫
刘守平
,
周上祺
,
王佳眉
,
任勤
腐蚀学报（英文）
用金相显微镜、扫描电镜、X射线衍射仪和X射线能谱仪对天然气井油管悬挂器腐蚀失效进行了检测分析，并对天然气井油管悬挂器用35CrMo钢进行了盐雾试验，结果表明，天然气中的水和CO2是引起腐蚀的主要介质，腐蚀产物主要是FeCO3，高速天然气冲刷和钢中的非金属夹杂加剧了腐蚀的速度.
CORROSION FAILURE ANALYSIS OF AN OIL TUBE USED IN NATURAL GAS WELL
LIU Shou-ping,ZHOU Shang-qi,WANG Jia-mei,REN Qin
Chongqing University
A failed oil tube used in natural gas well was examined by optical microscope,scanning electron microscope ,X-ray diffractometer and X-ray spectrometer.Corrosion behavior of 35CrMo steel samples of the oil tube were investigated by means of salt spray tests in the laboratory.The results show that CO2 and H2O are primary factors in the corrosion of oil tube.The corrosion product is FeCO3,non-metallic inclusions in the steel and erosion of natural gas fluid played an important role in accelerating the corrosion.
oil tube;
natural gas well；
35CrMo steel；
failure analysis；
corrosion
关键词:
悬挂器
,
null
,
null
,
null
李凤娟
,
吕国光
金属世界
doi:10.3969/j.issn.1000-6826.2014.04.14
通过对烧结配料所需原料及对冷烧结矿成品检验采制样方法的分析，找出影响检验结果真实性的因素，采取有效的改进措施，使本钢原料厂一次配料、本钢炼铁厂265 m2烧结二次配料及265 m2烧结系统各项稳定率有了很大的提高，烧结矿实物质量和各项技术质量指标有了很大的进步，保证了高炉的稳定顺行。
提高本钢265 m2冷烧结矿及原料检验代表性的实践
Practice of Improving the 265 m2 Cold Sinter and Raw Material Inspection Representative
供稿|
李凤娟,吕国光/
LI Feng-juan, LV Guo-guang
DOI：10.3969/j.issn.1000-6826.2014.04.14
导读内容
本钢炼铁厂265 m2烧结机生产所需要的含铁原料比较复杂，一次配料料种较多，且烧结含铁原料是由本钢原料厂二车间供料，原料质量的不稳定，会影响烧结矿质量的提高和新一号高炉的强化及高炉技术指标的改善。本钢质量管理中心驻冷烧检查站加强了对烧结配料所需原料及对冷烧结矿成品检验采制样代表性的研究，采取了一些改进措施，达到了良好的效果。含铁料成分稳定率、烧结矿各项质量和技术指标在稳步地提高。下面，对本钢质量管理中心驻冷烧检查站就提高采样及检验过程的准确性所采取的措施和办法进行说明。
烧结矿采样是半自动采样，每两小时采样一次，作为一个批次，来代表整个2h烧结矿的成份。
关键词:
