ZHENG Dong-sheng
,
ZHU Fu-xian
,
LI Yan-mei
,
CHEN Bing-zhang
钢铁研究学报(英文版)
The effect of the run-out table cooling patterns on the microstructure and mechanical properties of Nb microalloyed steel plates was investigated by hot rolling experiment. The results showed that the mixed microstructure containing ferrite, bainite and significant amounts of retained austenite can be obtained through three kinds of cooling patterns on the run-out table under the same hot rolling condition. Three kinds of cooling patterns possess different austenite transformation kinetics, which leads to variations in microconstituent characteristics. The yield strength increases, the tensile strength decreases and the total elongation tends to increase as the cooling patterns Ⅰ, Ⅱ and Ⅲ were applied respectively. The yield strength, the total elongation and the product of tensile strength and ductility reach the maximum values (547 MPa, 37.2% and 28384 MPa·%, respectively) for the steel plate processed by cooling pattern Ⅲ.
关键词:
Nb microalloyed steel
,
hot-rolled multiphase steel
,
cooling pattern
,
microstructure
,
mechanical property
ZHANG Ming-ya
,
ZHU Fu-xian
,
ZHENG Dong-sheng
钢铁研究学报(英文版)
Through the comparison of microstructure for polygonal ferrite (PF) matrix transformation induced plasticity (TRIP) seamless steel tube at different positions before and after tensile rupture, the transformation behavior of retained austenite (RA) was studied. The results showed that there were no yield points in tensile process and the splendid elongation and tensile strength were contributed by the uniform ferrite/bainite grains and the transformation of RA. The stability of RA was to some extent in inverse proportion with the ability of transformation induced plasticity. The coarse retained austenite located in ferrite and ferrite/bainite laths were all transformed into martensite during the tensile process.
关键词:
TRIP steel
,
retained austenite
,
austempering
,
heat treatment
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Physical Review B
In a recent publication [S. Dong et al., Phys. Rev. Lett. 103, 127201 (2009)], two (related) mechanisms were proposed to understand the intrinsic exchange bias present in oxides heterostructures involving G-type antiferromagnetic perovskites. The first mechanism is driven by the Dzyaloshinskii-Moriya interaction, which is a spin-orbit coupling effect. The second is induced by the ferroelectric polarization, and it is only active in heterostructures involving multiferroics. Using the SrRuO(3)/SrMnO(3) superlattice as a model system, density-functional calculations are here performed to verify the two proposals. This proof-of-principle calculation provides convincing evidence that qualitatively supports both proposals.
关键词:
thin-films;weak ferromagnetism;superlattices;anisotropy;bifeo3;srruo3;model
Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms
A static Monte Carlo simulation program has been used to study the influence of primary and secondary knock-on atoms on the angular distribution and the fractionation, for zero-fluence sputtering of Mo-92-Mo-100. At 10 keV Xe ion energy, calculations show that significant depth-dependent momentum asymmetry exists in the near-surface region, as in Refs. (L.P. Zheng, R.S. Li, M.Y.LI, Nucl. Instr, and Meth. B 100 (1995) 490; L.P. Zheng, M.Y. Li, Nucl. Instr. and Meth. B 114(1996) 28). The calculations also show that at the polar emission angle range between 0 degrees and 90 degrees the probabilities of the sputtered primary knock-on atoms for Mo-92 and Mo-100 are small (6.1% for Mo-92 and 6.6% for Mo-100), especially, between 0 degrees and 30 degrees they are very small (2.5% for Mo-92 and 2.8% for Mo-100). At 0.1 keV Ar ion energy, the calculations show that partial momentum flux ratios, for the primary and the secondary knock-on atoms, deviate far from one, through marker plane 1 (about an atomic layer distance from the surface). (C) 1998 Elsevier Science B.V. All rights reserved.
关键词:
mo-92-mo-100;targets
Physical Review B
We reconsider and interpret the mechanical properties of the recently proposed allotrope of carbon, T-carbon [Sheng et al., Phys. Rev. Lett. 106, 155703 (2011)], using density functional theory in combination with different empirical hardness models. In contrast with the early estimation based on Gao et al.'s model, which attributes to T-carbon a high Vickers hardness of 61 GPa comparable to that of superhard cubic boron nitride (c-BN), we find that T-carbon is not a superhard material, since its Vickers hardness does not exceed 10 GPa. Besides providing clear evidence for the absence of superhardness in T-carbon, we discuss the physical reasons behind the failure of Gao et al.'s and Simunek and Vackar's (SV) models in predicting the hardness of T-carbon, residing in their improper treatment of the highly anisotropic distribution of quasi-sp(3)-like C-C hybrids. A possible remedy for the Gao et al. and SV models based on the concept of the superatom is suggested, which indeed yields a Vickers hardness of about 8 GPa.
关键词:
superhard rhenium diboride;elastic-constants;ambient-pressure;metal;borides;crystals;diamond;search;boron
李红
,
孙克
,
李艳萍
,
石毅
,
郭金花
,
卢志超
金属功能材料
提出了采用推杆式热膨胀仪测试非晶合金薄带热膨胀特性的新方法.分析了Fe80Si9B11非晶薄带的热膨胀曲特性和非晶合金晶化过程.根据R.G.Zheng理论分析了结构弛豫中自由体积比变化,发现自由体积比曲线出现双峰.结合晶化前发生相分离的理论分析了这种变化的原因.分析表明:铁基非晶Fe80Si9B11晶化过程中先形成α-Fe(Si)相,再析出Fe3B、二次α-Fe(Si)相.晶化前先发生相分离,自由体积比增大,然后析出结晶相α-Fe(Si),自由体积比降低.随温度升高,B偏聚,自由体积比增大,随后析出Fe3B、二次α-Fe(Si)相,自由体积比降低.
关键词:
铁基非晶薄带
,
热膨胀系数
,
自由体积比
,
结构弛豫
