材料期刊网

Relationship between Heat Treatment and Corrosion Behavior of Mg-15Y Alloy

XU Hong , DENG Xia , ZHANG Xin , ZHANG Kui , LIU Yanpeng , LI Shaohua

武汉理工大学学报-材料科学版(英文版) doi:10.1007/s11595-015-1230-6

关键词:

Effect of Thermomechanical Processing on Microstructures of TRIP Steel

TANG Zhengyou , DING Hua , DU Linxiu , DING Hao , ZHANG Xin

钢铁研究学报(英文版)

In order to control retained austenite, the effect of hot deformation in the intercritical region on the microstructure of hotrolled transformationinduced plasticity (TRIP) steel was studied on a Gleeble 1500 hot simulator. Compressive strains varying in amounts from 0 to 60% were imposed in the intercritical region, and effects on the formation of polygonal ferrite, carbidefree bainite and retained austenite were determined. With increasing the hot deformation amount and the ferrite content and decreasing the carbidefree bainite content, the volume fraction of retained austenite decreases. Increased dislocation density, grain refinement of ferrite and carbon enrichment are the main factors which control retained austenite stability.

关键词: TRIP steel;intercritical (α+γ) region;hot deformation;retained austenite

Jian ZHANG/Langhong Lou

材料科学技术（英文）

关键词:

ACRT-B法生长的MnxCd1-xIn2Te4晶体的溶质分凝特性

常永勤 , 介万奇 , 郭喜平 , 陈福义 , 安卫军

功能材料

研究了ACRT-B法生长的Mn0.1Cd0.9In2Te4晶体中界面的形状和各组元沿轴向的分布规律及其分凝因数.发现结晶界面为椭球形;采用理想配比生长MnxCd1-xIn2Te4晶体,其4种组元并不按(Mn,Cd):In:Te=1:2:4比例结晶,而是要重新分布;通过数学方法处理实验数据得到Mn,Cd和In的分凝因数在α相区分别为1.286、1.9257和0.7294,在β相区则分别为1.12、1.055和0.985.

关键词: ACRT-B法 , MnxCd1-x In2Te4 , 界面 , 分凝因数

Bridgman法生长的Mn_xCd_1-xIn₂Te₄晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物Mn_xCd_1-xIn₂Te₄晶体.研究了三根晶体中相的形貌、结构、成分和Mn_0.1Cd_0.9In₂Te₄晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β₁,随着生长的进行,形成β相的单相区.在晶锭末端,形成In₂Te₃类面心立方结构化合物.组分x增大后,Mn_xCd_1-xIn₂Te₄晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x^-1-T曲线服从居里-外斯定律,在低温区(<50K)则表现出顺磁增强现象.

关键词: Mn_xCd_1-xIn₂T_e4 , compositional distribution , infrared transmission spectra , mag- netic susceptibility

Bridgman法生长的MnxCd1-xIn2Te4晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报 doi:10.3321/j.issn:1000-324X.2003.02.004

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mno.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里一外斯定律,在低温区(＜50K)则表现出顺磁增强现象.

关键词: MnxCd1-xIn2Te4 , 成分偏析 , 红外透射光谱 , 磁化率

MnxCd1-xIn2 Te4晶体生长研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

功能材料

采用Bridgman法生长四元稀磁化合物半导体Mn0.22Cd0.78In2Te4晶体.当晶体生长到预定长度时,淬火得到固液界面.采用光学显微镜、扫描电镜、X射线衍射仪、ISIS能谱仪以及Leica定量金相分析仪研究了晶体中出现的界面形态、相的形貌和数量以及沿生长方向的相析出规律,并进行了相成分分析.研究发现,淬火得到的Mn0.22 Cd0.78In2Te4晶体中存在两个界面,其中一个为固液相变界面,另一个为由α+β两相区发展到单相β区时的转变界面,二者相对于生长初始端均为凹形;α+β两相区中,β相以条状、花状和近似圆片状形式存在,其中条状β相多分布在晶界处;越接近生长初始端,花状和近似圆片状β相越小,条状β相越细,它们的含量越少;X射线衍射图谱表明,β相为黄铜矿结构,α相为面心立方结构.

关键词: MnxCd1-xIn2Te4 , 相变界面 , β相 , X射线衍射图谱

Composition Distribution in the MnxCd1-xIn2Te4 Ingot Grown by ACRT-B Method

材料科学技术（英文）

关键词:

Ion sputter erosion in metallic glass-A response to "Comment on: Homogeneity of Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass" by L-Y. Chen, Y-W. Zeng, Q-P. Cao, B-J. Park, Y-M. Chen, K. Hono, U. Vainio, Z-L. Zhang, U. Kaiser, X-D. Wang, and J-Z Jiang J. Mater. Res. 24, 3116 (2009)

Journal of Materials Research

The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.

关键词: room-temperature

THERMODYNAMIC PROPERTIES OF ALPHA-HELIX PROTEIN - A SOLITON APPROACH - COMMENT

Physical Review E

We disagree with the deduction of the equations of motion for the Davydov soliton and of the results in the paper by Jia-Xin Xiao et al. [Phys. Rev. A 44, 8375 (1991)]. The weakness and faults of the Davydov theory are also indicated.

关键词: davydov solitons;vibron solitons;molecules;excitation;system