王大伟
,
赵全亮
,
曹茂盛
,
崔岩
,
ZHANG Shu-Jun
无机材料学报
doi:10.3724/SP.J.1077.2014.12717
采用两步钶铁矿前驱体工艺制备了PbSnO3-Pb(Mg1/3Nb2/3)O3-PbTiO3(PSn-PMN-PT)三元系压电陶瓷,研究了Sn含量的变化对PSn-PMN-PT三元系压电陶瓷结构和性能的影响.XRD结果表明,所选成分均处于三方相和四方相共存的准同型相界上,当Sn含量减少时,PSn-PMN-PT的XRD图谱基本没有发生变化,而当Sn含量增加时,在XRD图谱中逐渐出现烧绿石相.电性能研究表明,缺失少量Sn可以提高PSn-PMN-PT的压电、介电和铁电性能,减小损耗;而添加过量Sn明显损害其压电和铁电性能,增加损耗.缺失0.2mol％Sn的PSn-PMN-PT具有最佳的压电和铁电性能,d33:～530 pC/N,kp:～56.4％,Qm:～570,εr:～3070,tanδ:～0.32％,Pr:～28.9 μC/cm2,EC:～8 kV/cm.
关键词:
压电陶瓷
,
PbSnO3-Pb(Mg1/3Nb2/3)O3-PbTiO3
,
压电性能
,
准同型相界
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
张鸿冰
,
倪乐民
,
徐祖耀
金属学报
经 LFG(ΔG~(γ→a))-Mogutnov(ΔG_(Fe)~(γ→a))、徐祖耀(Shu-A)(ΔG~(γ→a))-Orr-Chipman(ΔG_(Fe)~(γ→a))、徐祖耀(Shu-B)(ΔG~(γ→a))-Orr-Chipman(ΔG_(Fe)~(γ→a))组合,均可算得 Fe-Mn-C 合金的 Ms 温度且与实验值十分符合.所得结果经数学处理,得 Fe-Mn-C 系 Ms 与成分的关系为:Ms(K)=817.4-7513.4xc-4141.9x_(Mn)-32083.5x_Cx_(Mn)(LFG)Ms(K)=829.9-7580.5x_C-4166.0x_(Mn)-15727.8x_Cx_(Mn)(SHU-A)Ms(K)=829.2-7276.1x_C-2915.4x_(Mn)-43825.7x_Cx_(Mn)(SHU-B)其线性相关系数均大于0.992.C 和 Mn 浓度均使合金的 Ms 线性地降低,而碳的作用几乎是Mn 的两倍.处理中引入了合金元素交互作用项(x_Cx_(Mn)),表明 C,Mn 相互加剧对 Ms 的影响。随含 C,Mn 量的增加,相变驱动力均单调地增加,而不存在奇异点.Ms 和相变驱动力的计算值均依赖于ΔG_(Fe)~(γ→a)项.
关键词:
Philosophical Magazine
The error of Equation (15b) in my article [Z.D. Zhang, Phil. Mag. 87 (2007) p.5309] in the application of the Jordan-Wigner transformation does not affect the validity of the putative exact solution, since the solution is not derived directly from that equation. Other objections of Perk's comment [J.H.H. Perk, Phil. Mag. 89 (2009) p.761] are the same as those in Wu et al.'s comments [F.Y. Wu et al., Phil. Mag. 88 (2008) p.3093; p.3103], which do not stand on solid ground and which I have sought to refute in my previous response [Z.D. Zhang, Phil. Mag. 88 (2008) p.3097]. The conjectured solution can be utilized to understand critical phenomena in various systems, whereas the conjectures are open to rigorous proof.
关键词:
3D Ising model;exact solution;conjecture;critical phenomena;ferromagnetism;magnetic phase transition;model;analyticity
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Journal of Materials Processing Technology
The crystallization temperatures and other thermal properties have been measured systematically for two ternary Cu-Ni-P and two quaternary Cu-Ni-Sn-P amorphous systems. The dependence of crystallization temperature on the composition for the four alloy systems can not be described basically by the usual used Naka rule. The Gibbs free energy of crystallization can be calculated for the alloy systems with the model proposed by Shu et al. Using the calculated free energy of crystallization, it is still not possible to properly describe all of the crystallization temperatures of the alloy systems. However, it has been found that the correlation between the crystallization temperature and the content of the alloy systems can be reasonably explained by the nucleation and growth rates of a new phase for the classical theory of phase transformation. It has been established that the classical theory of phase transformation can be used to describe the thermal stability of the Cu-based amorphous alloys during their crystallization process. (C) 1999 Published by Elsevier Science S.A. All rights reserved.
关键词:
thermal stability;amorphous alloys;Cu-P based alloy systems;classical;theory of phase transformation;solid-liquid interface;structural model;glasses
