LI Lin
,
DE COOMAN B C
,
LIU Rendong
,
VLEUGELS J
,
ZHANG Mei
,
SHI Wen
钢铁研究学报(英文版)
A new type of transformation induced plasticity (TRIP) steel with not only high strength and high ductility but also superior welding and galvanizing properties was designed and developed recently. Low carbon and low silicon content were preliminarily selected with the aim of meeting the requirements of superior quality in both welding and galvanizing. Phosphorus was chosen as one of the alloying elements, because it could reduce carbon activity in cementite and increase the stability of austenite. In addition, the possibility of phosphorus segregating at grain boundary was also discussed by thermodynamics as well as kinetics. Phase diagram was estimated at high temperature and the composition of the steel was then selected in the hyperperitectic range to avoid problems, which might occur in sheet steel continuous casting. Phase diagram in the intercritical temperature was estimated for the steel to obtain the starting temperature of fast cooling. For understanding the minimum rate of fast cooling, pearlite growth kinetics was calculated with selfdeveloped diffusion coefficients of elements in grain boundary. Overaging temperature was determined through the calculation of T0 temperature by both equilibrium and paraequilibrium assumptions, which was different from the current determination, which is only based on an equilibrium estimation.
关键词:
TRIP steel;design;thermodynamics;kinetics;weldability;galvanization property
TANG Xu-long
,
ZHANG Zuo-tai
,
GUO Min
,
ZHANG Mei
,
WANG Xi-dong
钢铁研究学报(英文版)
The present paper is aimed at recycling of coal ash and blast furnace slag to produce mineral wool. Considering the mineralogical constitutions of coal ash and blast furnace slag, the primary quaternary slag compositions of CaO-SiO2-MgO-Al2O3 with basicity (mass ratio of CaO to SiO2) ranging from 05 to 09 and alumina ranging from 5% to 20% were investigated through a rotating cylinder method. The experimental results indicated that the viscosities decreased with increasing basicity above the liquidus temperature, and increased with increasing alumina content, and the maximum values were reached and as the alumina content was 20%, followed by the decrease with further increasing alumina content due to its amphoteric behavior. The amphoteric behavior of Al2O3 also performed in the relationship between viscosity and non-bridging oxygen per tetrahedrally-coordinated atom (NBO/T), and the viscosities decreased with increasing the NBO/T except the slag with a basicity 05 and Al2O3 20% which have a low NBO/T value and a low viscosity than others.-
关键词:
viscosity
,
mineral wool
,
NBO/T
,
slag-
ZHANG Mei
,
LI Lin
,
FU Renyu
,
ZHANG Jicheng
,
WAN Zi
钢铁研究学报(英文版)
Transformation induced plasticity (TRIP) steel exhibited high or rather high carbon equivalent (CE) because of its chemical composition, which was a particularly detrimental factor affecting weldability of steels. Thus the weldability of a TRIP steel (grade 600) containing (in mass percent, %) 011C119Si167Mn was extensively studied. The mechanical properties and impact toughness of butt joint, the welding crack susceptibility of weld and heat affected zone (HAZ) for tee joint, control thermal severity (CTS) of the welded joint, and Y shape 60° butt joint were measured after the gas metal arc welding (GMAW) test. The tensile strength of the weld was higher than 700 MPa. Both in the fusion zone (FZ) and HAZ for butt joint, the impact toughness was much higher than 27 J, either at room temperature or at -20 ℃, indicating good low temperature impact ductility of the weld of TRIP 600 steel. In addition, welding crack susceptibility tests revealed that weldments were free of surface crack and other imperfection. All experimental results of this steel showed fairly good weldability. For application, the crossmember in automobile made of this steel exhibited excellent weldability, and fatigue and durability tests were also accomplished for crossmember assembly.
关键词:
TRIP steel;weldability;welding crack susceptibility;mechanical property;impact toughness
马乾志
,
郭杨龙
,
王艳芹
,
郭耘
,
张志刚
,
卢冠忠
无机材料学报
doi:10.3321/j.issn:1000-324x.2007.05.033
采用TS-1前驱体作硅源和钛源,以十二胺为模板剂,在中性和室温条件下合成了介孔含钛分子筛Ti-HMS-1.采用XRD、TEM、低温N2吸附、FT-IR和UV-Vis等方法对合成的分子筛进行了表征;以苯乙烯的催化氧化反应为模型反应,考察了合成的Ti-HMS-1的催化氧化性能.结果表明,Ti-HMS-1具有"worm-like"介孔结构,但长程有序度较低,孔壁部分含有MFI的次级结构单元,在373K沸水中水煮50h后,Ti-HMS-1仍能较好地保持原有的介孔结构,表明Ti-HMS-1具有较高的水热稳定性.进入分子筛骨架的钛原子为催化剂的活性中心,对于苯乙烯氧化反应,具有较高的催化活性,对产物的选择性与Ti-HMS接近.
关键词:
Ti-HMS-1分子筛
,
合成
,
表征
,
苯乙烯氧化
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
Journal of Chemical Physics
Based on Mei's embedded atom model [Mei , Phys. Rev. B 43, 4653 (1991)] molecular dynamics simulations have been performed to investigate the rapidly cooling processes of Cu. The atomic transport property, namely the self-diffusion coefficient, is computed in the liquid state, and the results near the melting point of Cu are in good agreement with experimental data and other computational values. The atom diffusion movements during the long period of relaxation have been also studied around the solidification temperature T-c. To describe the complex microstructural evolutions during the rapidly cooling processes and the long relaxation processes, the pair correlation function and the pair analysis technique are used. It is demonstrated that the crystallization of amorphous Cu is caused by the atomic diffusion. (C) 2004 American Institute of Physics.
关键词:
transition-metals;computer-simulation;supercooled-liquid;model;fcc;potentials;diffusion
Philosophical Magazine
The error of Equation (15b) in my article [Z.D. Zhang, Phil. Mag. 87 (2007) p.5309] in the application of the Jordan-Wigner transformation does not affect the validity of the putative exact solution, since the solution is not derived directly from that equation. Other objections of Perk's comment [J.H.H. Perk, Phil. Mag. 89 (2009) p.761] are the same as those in Wu et al.'s comments [F.Y. Wu et al., Phil. Mag. 88 (2008) p.3093; p.3103], which do not stand on solid ground and which I have sought to refute in my previous response [Z.D. Zhang, Phil. Mag. 88 (2008) p.3097]. The conjectured solution can be utilized to understand critical phenomena in various systems, whereas the conjectures are open to rigorous proof.
关键词:
3D Ising model;exact solution;conjecture;critical phenomena;ferromagnetism;magnetic phase transition;model;analyticity
