Yuan LIU
,
Jingjie GUO
,
Yanqing SU
,
Hongsheng DING
,
Jun JIA
材料科学技术（英文）
Melt spinning rapid solidification technique was employed to fabricate homogeneous Al-In immiscible alloys and their final microstructures and morphologies were investigated. There existed a transition of columnar Al grain®equiaxed grain for the thicker ribbon, butonly columnar Al grain for the thinner ribbon throughout the thickness. In the columnar grain field, most of the fine In particles was distributed within the cells, but a minority of bigger In particles or short rods was perpendicularly distributed at the grain boundaries. In the equiaxed grain field, the fine In particles were located in Al grains and coarser particles were situated at the boundaries. The average particle size increased with increasing distance from the chilled surface throughout the ribbon. At the same wheel speed (same cooling rate), the average particle size increased with raising In content. At the same composition condition, the average particle size decreased with increasing wheel speed and/or decreasing ejection temperature.
关键词:
Al-In immiscible alloy
,
null
,
null
Yuan LIU
,
Yanxiang LI
,
Jingjie GUO
,
Jun JIA
材料科学技术（英文）
Immiscible alloys are attractive for their valuable physical and mechanical properties. In this paper, Al-In immiscible alloy is prepared by melt spinning process and its morphological evolution is studied at various indium contents. The results show that the morphologies of the matrix phase depend on the indium content. Different morphologies lead to different distribution of the second phase particles. Due to a particular solidification mechanism of immiscible alloys, even under the melt spinning rapid solidification condition, it is still impossible to produce homogeneous Al-In hypomonotectic alloy ribbons. But for Al-In hypermonotectic alloys, there is almost no segregation of the second phase throughout the cross section of the ribbons.
关键词:
Immiscible alloys
,
null
,
null
Yuan LIU
材料科学技术（英文）
The effect of gas pressures on the mean pore size, the porosity and the pore size distribution of lotus-type porous magnesium fabricated with Gasar process were investigated. The theoretical analysis and the experimental results all indicate that there exists an optimal ratio of the partial pressures of hydrogen pH2 to argon pAr for producing lotus-type structures with narrower pore size distribution and smaller pore size. The effect of solidification mode on the pore size distribution and pore size was also discussed.
关键词:
Porous metal
,
null
,
null
徐卫兵
,
戈明亮
,
何平笙
应用化学
doi:10.3969/j.issn.1000-0518.2001.09.011
用熔融插层法制备聚甲醛/蒙脱土纳米复合材料,用X射线衍射研究聚甲醛及复合材料的微观结构,表明复合材料是纳米复合材料.用DSC法研究其非等温结晶行为,对所得数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚甲醛及聚甲醛/有机蒙脱土纳米复合材料的结晶活化能分别为334.6和196.9 kJ/mol,说明有机蒙脱土的加入,降低了聚甲醛的结晶活化能,且t1/z缩短,起到了异相成核的作用.
关键词:
聚甲醛
,
蒙脱土
,
纳米复合材料
,
非等温结晶动力学
王平华
,
徐国永
应用化学
doi:10.3969/j.issn.1000-0518.2004.08.007
用熔融复合法制备聚丙烯/凹凸棒土纳米复合材料,用DSC法研究其非等温结晶行为,对所得的数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚丙烯及聚丙烯/凹凸棒土纳米复合材料的结晶活化能分别为194.1和162.8 kJ/mol,表明凹凸棒土的加入,降低了聚丙烯的结晶活化能,且t1/2缩短,起到了异相成核作用.
关键词:
聚丙烯
,
凹凸棒土
,
纳米复合材料
,
非等温结晶动力学
Transactions of Nonferrous Metals Society of China
A new process for the hydrometallurgy of refractory gold concentrates was presented. The process comprises grinding-leaching, intensified alkaline leaching (IAL), cyanidation and adsorption. In a stirring-type pulverizing-leaching tower mill, the concentrate is ground to <35. 6 μm of 95. 5 % while simultaneously leached by NaOH of 12 kg/t, then carried out intensified alkaline leaching for 48 h by NaOH of 108 kg/t in enhanced agitation tanks with the pulp concentration of 40% solids at the environmental temperature of 9. 5 &SIM; 13. 5 &DEG;C and the environmental pressure of 10(5) Pa. The oxidation rate of As is 94. 9%, and 47. 6% for S. The total consumption of NaOH is only 20% of that theoretically calculated under the conditions of full oxidation at the same oxidation rates of arsenic to arsenate and sulfur to sulfate. The gold leaching rate by NaCN in 24 h is increased from 9. 2% before pretreatment to 94. 2%. The consumption of NaCN is 7. 5 kg/t, which is one times less than that before pretreatment. The extraction cost of gold is about 422 Yuan/t.
关键词:
refractory gold concentrates;grinding-leaching;intensified alkaline;leaching (IAL);pretreatment;common temperature and pressure
Scripta Materialia
A recent comment on a previously published paper addressed the invalid explanation of the off diagonal interdiflusion coefficients of the beta-Ni(Al,Cr) phase in the Ni-Cr-Al system according to the symmetric property of the thermodynamic matrix. In this paper, the experimental data presented by Hou et al. was reanalyzed and the interdiffusion coefficient matrix was estimated again. The results of the analysis have been discussed in terms of a brief reply to the comments of Liu and Liang. (C) 2010 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
关键词:
Diffusion;Intermetallic compound;Ni-Cr-Al
邓超
,
邵玮
,
李春忠
高分子材料科学与工程
采用元机纳米锑掺杂二氧化锡(ATO)和有机聚醚酯(PEE)协同提高聚时苯二甲酸乙二酯(PET)的抗静电性能,合成了聚对苯二甲酸乙二酯-聚醚酯/锑掺杂二氧化锡纳米复合材料(PET-PEE/ATO).使用Czawa方程和Liu-Mo方程研究了PET-PEE/ATO纳米复合材料的非等温结晶过程.Ozawa方程研究发现,在非等温结晶过程中,PET、PET-PEE、PET/ATO、PET-PEE/ATO的成核性能依次提高.Liu-Mo方程发现,ATO和PEE的加入分别促进了异相成核作用和加快了结晶生长,PET-PEE/ATO结晶成核性能最好,结晶速率最快.
关键词:
聚对苯二甲酸乙二酯
,
有机聚醚酯
,
无机纳米锑掺杂二氧化锡
,
纳米复合材料
,
非等温结晶动力学
王浩
,
刘国权
金属学报
doi:10.3321/j.issn:0412-1961.2008.07.001
以MacPherson-Srolovitz提出的三维个体晶粒长大拓扑依赖速率方程以及三维晶粒组织的晶粒尺寸-晶粒面数间的抛物线型统计关系为基础,导出了相应的描述三维准稳态晶粒尺寸分布的函数族.采用纯Fe实验数据以及顶点法、基元演化法.相场模型和Monte Carlo法进行了验证,结果表明,函数族中峰值左偏的函数适合三维准稳态晶粒尺寸分布的定量表述.将该函数与Liu等提出的2种三维准稳态晶粒尺寸分布函数进行的对比表明:此3种函数的解析表达形式有所不同,但其曲线图在一定条件下相互吻合.此外,MacPherson-Srolovitz三维拓扑依赖速率方程、Hillert三维速率方程及Yu-Liu三维速率方程尽管表达形式不同均能较好地反映三维正常晶粒长大的动力学规律.
关键词:
三维晶粒长大
,
准稳态晶粒尺寸分布
,
长大速率方程
,
计算机仿真
