Electrochimica Acta
Electrically conducting polypyrrole (Ppy) coatings doped with sodium dodecylsulfate (SDS) have been deposited on 1Cr18Ni9Ti stainless steel by anodic polymerization from aqueous solutions of pyrrole and sodium dodecylsulfate. The corrosion behavior of Ppy coated steel was investigated in 0.3 M HCl aqueous solution at room temperature by a combination of electrochemical measurement techniques and scanning electron microscopy. The steel is in active state at the open circuit potential and suffers from pitting corrosion when the polarization potential is higher than 210 mV versus SCE. The Ppy coating can increase the corrosion potential of the steel by more than 600 mV versus SCE, and the pitting corrosion potential by more than 500 mV versus SCE. Fifty-day exposure experiments indicated that the Ppy coating shows high stability, and can inhibit effectively the corrosion of the steel. (C) 2005 Elsevier Ltd. All rights reserved.
关键词:
polypyrrole coatings;stainless steel;HCl solution;corrosion;electrochemistry;acid sulfate-solutions;pem fuel-cell;mild-steel;films;behavior;electrochemistry;resistance;iron
Corrosion Science
The early stages of the evolution of atmospheric corrosion of carbon steels exposed in both a laboratory simulated and a natural atmosphere environment in Shenyang have been observed by in situ scanning electron microscopy. In the case of laboratory cyclic wet-dry tests, even though the chloride content level is very low, filiform corrosion is initiated in the early stage. The filiform corrosion grows in random directions, forming a network of ridges. White nodules nucleate and grow on the ridges during continued corrosion and eventually connect with each other to form the initial corrosion scale. Pits were also found on the surface beneath corrosion products. In the case of a natural atmospheric environment, both filiform corrosion and other localized corrosion, such as pitting and inter-granular attack take place in the initial stage. It is obvious that there is variety of localized corrosion in the initial stage of atmospheric corrosion. (C) 2007 Elsevier Ltd. All rights reserved.
关键词:
steel;atmospheric corrosion;initial stage;localized corrosion;in-situ;iron;electrolyte;thickness
Materials and Corrosion-Werkstoffe Und Korrosion
Galvanic anodic protection (GAP) of stainless steels by doped polypyrrole (PPy) was investigated using chemically synthesized PPy. Separate PPy powder-pressed electrodes with different surface areas were prepared. Electrochemical properties of PPy electrodes were studied by open circuit potentials (OCPs) and potentiostatic polarization. PPy powder-pressed electrodes were coupled with 410-stainless steel electrodes in different concentrations of sulfuric acid solutions, 5 M phosphoric acid solution, and industrial phosphoric acid solution (5 M phosphoric acid + 0.05% chloride ion). Remarkable shift of OCP to the positive direction and sharp decrease of corrosion rate were observed during the coupling experiments, which implies that 410-stainless steel was transferred to passive state. Results also showed that PPy electrode with sufficient surface area can provide corrosion protection to 410-stainless steel electrode in highly corrosive acid solution. Based on the experiment results, GAP provided by PPy and PANi (synthesized under similar conditions) was compared.
关键词:
galvanic anodic protection;organic metal polyaniline;coated;mild-steel;conducting polymers;doped polyaniline;ferrous-metals;carbon-steel;coatings;iron;passivation
F. Lu and WJ. van Ooij( Beijing Institute of Aeronautical Materials
,
P.O. Box 81-5
,
Beijing 100095
,
China)( Department of Materials Science and Engineering
,
University of Cincinnati
,
Cincinnati
,
OH 45221-0012
,
U.S.A.)
金属学报(英文版)
Zn-Al couple's galvanic coeeosion was a serious problem in acdic ainc sulfate solution .In this paper, a new pretreatment or a coating for Al was developed and tested to protect the Al effectively form corrosion when connected to pure Zinc at electroplating potential,and exposed to an acdic sulfate solution.Corrosion measurement techniques(Galvanic corrosion and DC)were used to investigate galvanic corrosion between Al cathode and Zn anode.It was found out that Al alloy purity and electroplating potential have a large effect on galvanic corrsion between Zn-Al couples.EIS,salt spray test and immersion test were performed to evaluate the method for Al cathodes in zinc electrolyte,BTSE silane pretreatment and polyurethane coating displayed better corrosion protection.Calculation showed the Al dissolution rate is small enough for Al cathode to be used in zinc plants.BTSE treatment or BTSE plus polyurethane coating has the best corrosion performance,and willprotect the Al cathode effectively in zinc electrolysis
关键词:
Al-Zn couple
,
null
Materials Chemistry and Physics
The corrosion behaviour of CortenA weathering steel has been investigated using a laboratory accelerated test that involved cyclic wet/dry conditions in Qinghai salt lake water diluted 30 times The characteristics of the rust layers on tested samples were observed by SEM and EPMA analyzed by IRS and XRD and studied by polarization and EIS measurements The weight loss was almost linear indicating that the rust layer had no retarding effect on the corrosion process The crystalline components of the rust layers consisted primarily of beta-FeOOH magnetite (Fe(3)O(4)) and gamma-FeOOH As the corrosion proceeded the amount of beta-FeOOH decreased while that of magnetite and gamma-FeOOH increased XRD EDAX and EPMA indicated that the complex corrosion products magnesioferrite (MgFe(2)O(4)) and iowaite (Mg(4)Fe(OH)(8)OCl 4H(2)O) probably existed in the rust layer in which case they will have had an important Influence on the protectiveness of the rust layer The results of electrochemical measurements showed that the rust layer exhibited high reduction reactivity which facilitated the corrosion of weathering steel in the wetting process The large rust capacitance and small rust resistance indicated that the rust layer had a loose and porous structure which provided poor protection (c) 2010 Elsevier B V All rights reserved
关键词:
Elements;Corrosion test;Electrochemical techniques;Electron probe;low-alloy steels;atmospheric corrosion;carbon-steel;electrochemical;impedance;room-temperature;rust layers;iron;mechanism;products;environment
Polymers for Advanced Technologies
A corrosion protection coating from polyimide/polyaniline (PI/PAn) blend was prepared by solution blending and the anti-corrosion property of this coating was studied with electrochemical impedance spectroscopy technique. The results show that PAn can react with PI to form chemical bonds between these two polymers and these bonds keep these two polymers as a miscible system. The corrosion protection property of this coating increases with a growth in the PAn component and an excellent anti-corrosion effect emerges when the PAn content reaches 10-15%. The reason why PAn can improve the anti-corrosion property is that PI/PAn blend can form a dense and non-porous polymer film that would prevent some corrupting components from access to the underlying steel surface. And also, PAn may serve as a corrosion inhibiting agent to scavenge any protons and foster a local basic surface environment. Copyright (C) 2001 John Wiley Sons, Ltd.
关键词:
polyaniline;polyimide;corrosion;EIS
Corrosion Science
Potential and current distributions in a cathodically protected crevice between a simulated coating and segmented mild steel electrodes were measured in dilute NaCl solutions. The distributions became more uniform with time due to an increase in solution conductivity and depletion of dissolved oxygen in the crevice. Generally, a negative shift of control potential and an increase in initial solution conductivity and crevice thickness resulted in a higher polarization level on the steel. However, if the control potential is too negative, the polarization level may be lower than that under a suitable control potential because of hydrogen evolution. On the basis of these results, a mechanism of cathodic protection against crevice corrosion in high-resistivity environments was proposed. (C) 2002 Elsevier Science Ltd. All rights reserved.
关键词:
cathodic protection;crevice corrosion;potential distribution;current;distribution;mild steel;dilute NaCl solution;coatings
F.Lu
,
Q.P.Zhong
金属学报(英文版)
Galvanic compatibility between graphite epoxy composite materials (GECM) and LY12CZ aluminum alloy was evaluated in different atmospheric corrosion environ-ments and by laboratory electrochemical measurements.Open circuit potential elec-trochemical measurements showed a relatively large potemtial difference about 1 volt between the GECM and LY12CZ aluminum alloy,and this difference provided the driving force for galvanic corrosion of the LY12CZ aluminum alloy as an anode. Having been exposed for 1,3or 5years in Beijing,Tuandao and Wanning station,GECM/LY12CZ couples showed significant losses of strength and elongation.Protec-tive coatings and non-conductive barriers breaking the galvanic corrosion circuit were evaluated under the same atmospheric corrosive conditions.Epoxy primer paint,glass cloth barriers and LY12CZ anodizing were effective in glvanic corrosion control for GECM/LY12CZ couples.
关键词:
galvanic corrosion
,
null
,
null
