材料期刊网

Evaluation of Cracking Resistance of CopperBearing Age Hardening Steel Weldment

CHAI Feng , YANG Caifu , SU Hang , ZHANG Yongquan , XU Zhou

钢铁研究学报(英文版)

The weldability of a lowcarbon copperbearing age hardening steel was evaluated using cracking susceptibility calculation, HAZ maximum hardness measurement, and Ygroove cracking evaluation test. The results show that the hardenability characteristics and cold cracking susceptibility of the steel are very low. The results also indicate that a crackfree weldment can be obtained during the welding of this type of steel even at an ambient temperature as low as -5 ℃ as well as in an absolute humidity lower than 4 000 Pa without any preheat treatment. A slight preheat treatment can prevent the joint from cracking when welding is carried out at lower ambient temperature or higher absolute humidity.

关键词: copperbearing age hardening steel;weldability;cracking resistance;Ygroove cracking test

Effect of Magnesium on Inclusion Formation in TiKilled Steels and Microstructural Evolution in Welding Induced CoarseGrained Heat Affected Zone

CHAI Feng , YANG Caifu , SU Hang , ZHANG Yongquan , XU Zhou

钢铁研究学报(英文版)

Effects of Mg on the chemical component and size distribution of Tibearing inclusions favored grain refinement of the welding induced coarsegrained heat affected zone (CGHAZ), with enhanced impact toughness in Tikilled steels, which were examined based on experimental observations and thermodynamic calculations. The results indicated that the chemical constituents of the inclusions gradually varied from the TiO+TiMgO compound oxide to the TiMgO+MgO compound oxide and the singlephase MgO, as the Mg content increased from 0002 3% to 0006%. A trace addition of Mg (approximately 0002%) led to the refinement of Tibearing inclusions by creating the TiMgO compound oxide and provided favorable size distribution of the inclusions for acicular ferrite transformation with a high nucleation rate in the CGHAZ, and a high volume fraction of acicular ferrite was obtained in the CGHAZ with enhanced impact toughness. Otherwise, a high content of Mg (approximately 0006%) produced a singlephase MgO, which was impotent to nucleate an acicular ferrite, and a microstructure comprised of a ferrite side plate and a grain boundary ferrite developed in the CGHAZ. The experimental results were confirmed by thermodynamic calculations.

关键词: nonmetallic inclusion;magnesium;acicular ferrite;coarsegrained heat affected zone (CGHAZ)

Effect of Cold Rolling on Microstructure and Mechanical Properties of AISI 301LN Metastable Austenitic Stainless Steels

HUANG Jun-xia , YE Xiao-ning , XU Zhou

钢铁研究学报(英文版)

The microstructure and mechanical properties evolution of AISI 301LN metastable austenitic stainless steels during cold rolling were investigated. A wide range of cold thickness reduction (10%-80%) was carried out in a four-high rolling mill at ambient temperature. The X-ray and Feritscope MP30 were used to identify the strain-induced α′-martensite phase and its volume fraction, respectively. The microstructure was observed by optical micrograph and the mechanical properties were determined by tensile tests and microhardness. The results show that the strain-induced α′-martensite nucleated at the shear bands intersections and the growth of α′-martensite occurred by the repeated nucleation of new embryos. The volume fraction of strain-induced α′-martensite increased with increasing the cold rolling reduction. In addition, the percentage increased in the tensile strength is the same as that of hardness. The ratio between the average tensile strength and the average microhardness was found to range between 2.82 and 3.17.

关键词: metastable austenitic stainless steel , cold rolling , reduction , strength

Professor XU Zhong-yu and his research activities

新型炭材料

关键词:

On the Indeterminacy in Hardness of Shape Memory Alloys

F.T.Cheng

材料科学技术（英文）

The present communication addresses an interesting problem related to the indeterminacy in hardness of superelastic NiTi reported by Xu et al. The origin of the indeterminacy is attributed to the inadequacy of the conventional Vickers hardness testing measurement which does not record elastic deformation, and thus the indeterminacy may be removed with suitable techniques. Concepts of hardness in relation to deformation are clarified. Recommendations for measuring the hardness of NiTi and other elastic-plastic materials are suggested, together with comments on the advantages and disadvantages of each of these methods.

关键词: Hardness , null , null , null , null , null

LOCAL-STRUCTURE OF THE AXIAL FE3+ CENTER IN THE K+ SITE OF A KTAO3 CRYSTAL

Physical Review B

In order to understand the unusually large value of zero-field splitting D for the axial Fe3+ center in a KTaO3 crystal, Zhou made two assumptions in his recent report [Phys. Rev. B 42, 917 (1990)]. In this Comment we will show that his assumption II is qualitatively reasonable, whereas assumption I is unnecessary and doubtful.

关键词: electric-field;srcl2

Broer-Kaup-Kupershmidt方程的新精确解

杨立娟 , 杨琼芬 , 杜先云

量子电子学报 doi:10.3969/j.issn.1007-5461.2012.02.003

CK方法是求解非线性发展方程的一种有效的直接方法.利用推广的CK方法,求得(2+1)维Broer-Kaup-Kupershmidt方程的Backlund公式,从而获得方程的大量新的精确解,推广了Xu和Zhang的结果.

关键词: 非线性发展方程 , Broer-Kaup-Kupershmidt方程 , 精确解 , CK方法 , Backlund变换

First-principle study of electronic properties of Ti3Si1-xAlxC2 solid solutions

Journal of Physics and Chemistry of Solids

The layered ternary ceramics Ti3SiC2 and Ti3AlC2 are isostructural and can form Ti3Si1-xAlxC2 solid solutions combining the advanced properties of both compounds [H.B. Zhang, Y.C. Zhou, Y.W. Bao, M.S. Li, Improving the oxidation resistance of Ti3SiC2 by forming a Ti3Si0.90Al0.1C2 solid solution, Acta Mater. 52 (2004) 3631-3637; E.D. Wu, J.Y. Wang, H.B. Zhang, Y.C. Zhou, K. Sun, Y.J. Xue, Neutron diffraction studies of Ti3Si0.9Al0.1C2 compound, Mater. Lett. 59 (2005) 2715-2719; J.Y. Wang, Y.C. Zhou, First-principles study of equilibrium properties and electronic structure of Ti3Si0.75Al0.25C2 solid solution, J. Phys.: Condens. Matter 15 (2003) 5959-5968; Y.C. Zhou, J.X. Chen, J.Y. Wang, Strengthening of Ti3AlC2 by incorporation of Si to form Ti3Al1-xSixC2 solid solutions, Acta. Mater. 54 (2006) 1317-1322]. In the present work, the solid solutions of Ti3Si1-xAlxC2 (x = 0, 0.25, 0.33, 0.5, 0.67, 0.75, 1) are investigated by first-principle calculations based on pseudo-potential plan-wave method within the density functional theory framework. The results show that as Al content increases in the solid solution, all the bonds have weakened to certain extents, which lead to an unstable structure both energetically and geometrically. The calculated results are compared and discussed with the reported data for the Ti3Si1-xAlxC2 solid solutions. (c) 2007 Elsevier Ltd. All rights reserved.

关键词: ceramics;ab initio calculations;electronic structure;electrical;conductivity;oxidation behavior;mechanical-properties;ti3sic2;temperature;ti3alc2;air;si

Thermodynamic analyses of strain-induced martensite transformation in Fe-7Mn-1.2C alloy

Jingpei XIE , Yaomin ZHU , Xiaoping WANG

材料科学技术（英文）

The M-s temperature, Delta G(gamma-->alpha), Delta G(gamma-->M) and mechanical energy under a non-severe impact loading in a medium manganese steel (Fe-7Mn-1.2C) have been calculated by means of Xu's Fe-X-C model. The relation between the yield strength of austenite and the driving force for martensite transformation has been established. It is proved that the martensite transformation can take place in a medium manganese steel (Fe-7Mn-1.2C alloy) under a non-severe impact loading.

关键词:

磷在12Cr1MoV钢中非平衡晶界偏聚动力学的实验研究

李莉 , 李庆芬 , 郑磊 , 徐庭栋 , 杜善义

钢铁研究学报

以工业用12Cr1MoV钢为研究对象,通过俄歇电子能谱分析方法(AES),对磷在恒温过程中的非平衡晶界偏聚浓度进行了测定.获得的磷在钢中的非平衡晶界偏聚动力学曲线直接验证了非平衡晶界偏聚动力学理论中的Xu-Song模型.

关键词: 晶界偏聚 , 临界时间 , 扩散 , 钢