材料期刊网

Effect of Niobium on Isothermal Transformation of Austenite to Ferrite in HSLA LowCarbon Steel

CAO Jianchun , LIU Qingyou , YONG Qilong , SUN Xinjun

钢铁研究学报(英文版)

Using thermomechanical simulation experiment, the kinetics of the isothermal transformation of austenite to ferrite in two HSLA lowcarbon steels containing different amounts of niobium was investigated under the conditions of both deformation and undeformation. The results of optical microstructure observation and quantitative metallography analysis showed that the kinetics of the isothermal transformation of austenite to ferrite in lower niobium steel with and without deformation suggests a stage mechanism, wherein there exists a linear relationship between the logarithms of holding time and ferrite volume fraction according to Avrami equation, whereas the isothermal transformation of austenite to ferrite in high niobium steel proceeds via a two stage mechanism according to micrographs, wherein, the nucleation rate of ferrite in the initial stage of transformation is low, and in the second stage, the rate of transformation is high and the transformation of residual austenite to ferrite is rapidly complete. Using carbon extraction replica TEM, niobium carbide precipitation for different holding time was investigated and the results suggested that NbC precipitation and the presence of solute niobium would influence the transformation of austenite to ferrite. The mechanism of the effect of niobium on the isothermal transformation was discussed.

关键词: niobium;transformation;ferrite;austenite

Effect of Dissolved and Precipitated Niobium in Microalloyed Steel on Deformation Induced Ferrite Transformation (DIFT)

LIU Qingyou , DENG Suhuai , SUN Xinjun , DONG Han , WENG Yuqing

钢铁研究学报(英文版)

Hot deformation processing was designed to study the effects of niobium (Nb) on DIFT. A prestrain of 051 at 880 ℃ for different isothermal time was used for adjusting the deformed austenite constitution and Nb existing state, followed by a secondary heavy deformation at 780 ℃ for inducing the ferrite transformation. The volume fraction and grain size of deformation induced ferrite (DIF) obtained at different isothermal time between double hits were investigated. It was found that Nb dissolved in austenite is adverse to DIFT; however, the precipitation of Nb is beneficial to DIFT. As Nb plays the role in the conventional TMCP, Nb retards the recrystallization of deformed austenite and enhances the deformation stored energy in the multipass deformation, and in result, Nb promotes DIFT.

关键词: niobium;precipitation;recrystallization;deformation induced ferrite transformation

Mechanism of Austenite Evolution During Deformation of UltraHigh Carbon Steel

ZHANG Shulan , SUN Xinjun , DONG Han

钢铁研究学报(英文版)

The mechanism of transformation of austenite to cementite and pearlite during the deformation of ultrahigh carbon steel was discussed. The results indicate that the pearlite and cementite can be induced by deformation between Acm to Arcm. The transformation during deformation is still considered as a diffusioncontrolled process. With the increase of time and reduction, the pearlite fraction increased. At the beginning of the transformation, the pearlite was lamelliform. When the rate of reduction was increased to 70%, some of the induced lamellar pearlite was broken up under deformation.

关键词: ultrahigh carbon steel;microstructure;deformation;transformation

ACRT-B法生长的MnxCd1-xIn2Te4晶体的溶质分凝特性

常永勤 , 介万奇 , 郭喜平 , 陈福义 , 安卫军

功能材料

研究了ACRT-B法生长的Mn0.1Cd0.9In2Te4晶体中界面的形状和各组元沿轴向的分布规律及其分凝因数.发现结晶界面为椭球形;采用理想配比生长MnxCd1-xIn2Te4晶体,其4种组元并不按(Mn,Cd):In:Te=1:2:4比例结晶,而是要重新分布;通过数学方法处理实验数据得到Mn,Cd和In的分凝因数在α相区分别为1.286、1.9257和0.7294,在β相区则分别为1.12、1.055和0.985.

关键词: ACRT-B法 , MnxCd1-x In2Te4 , 界面 , 分凝因数

Bridgman法生长的Mn_xCd_1-xIn₂Te₄晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物Mn_xCd_1-xIn₂Te₄晶体.研究了三根晶体中相的形貌、结构、成分和Mn_0.1Cd_0.9In₂Te₄晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β₁,随着生长的进行,形成β相的单相区.在晶锭末端,形成In₂Te₃类面心立方结构化合物.组分x增大后,Mn_xCd_1-xIn₂Te₄晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x^-1-T曲线服从居里-外斯定律,在低温区(<50K)则表现出顺磁增强现象.

关键词: Mn_xCd_1-xIn₂T_e4 , compositional distribution , infrared transmission spectra , mag- netic susceptibility

Bridgman法生长的MnxCd1-xIn2Te4晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报 doi:10.3321/j.issn:1000-324X.2003.02.004

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mno.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里一外斯定律,在低温区(＜50K)则表现出顺磁增强现象.

关键词: MnxCd1-xIn2Te4 , 成分偏析 , 红外透射光谱 , 磁化率

钛等金属的SUN-Z-R复合技术

吴全兴

钛工业进展 doi:10.3969/j.issn.1009-9964.2001.02.008

关键词:

MnxCd1-xIn2 Te4晶体生长研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

功能材料

采用Bridgman法生长四元稀磁化合物半导体Mn0.22Cd0.78In2Te4晶体.当晶体生长到预定长度时,淬火得到固液界面.采用光学显微镜、扫描电镜、X射线衍射仪、ISIS能谱仪以及Leica定量金相分析仪研究了晶体中出现的界面形态、相的形貌和数量以及沿生长方向的相析出规律,并进行了相成分分析.研究发现,淬火得到的Mn0.22 Cd0.78In2Te4晶体中存在两个界面,其中一个为固液相变界面,另一个为由α+β两相区发展到单相β区时的转变界面,二者相对于生长初始端均为凹形;α+β两相区中,β相以条状、花状和近似圆片状形式存在,其中条状β相多分布在晶界处;越接近生长初始端,花状和近似圆片状β相越小,条状β相越细,它们的含量越少;X射线衍射图谱表明,β相为黄铜矿结构,α相为面心立方结构.

关键词: MnxCd1-xIn2Te4 , 相变界面 , β相 , X射线衍射图谱

Composition Distribution in the MnxCd1-xIn2Te4 Ingot Grown by ACRT-B Method

材料科学技术（英文）

关键词:

THERMODYNAMIC PROPERTIES OF ALPHA-HELIX PROTEIN - A SOLITON APPROACH - COMMENT

Physical Review E

We disagree with the deduction of the equations of motion for the Davydov soliton and of the results in the paper by Jia-Xin Xiao et al. [Phys. Rev. A 44, 8375 (1991)]. The weakness and faults of the Davydov theory are also indicated.

关键词: davydov solitons;vibron solitons;molecules;excitation;system