欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(21)
  • 图书()
  • 专利()
  • 新闻()

Microstructure transformation behaviour of 610MPa HSLA Steel Plate for 150,000 m3 Oil Storage Tank Construction

SUN Wei-hua , WANG Guo-dong

钢铁研究学报(英文版)

Static and dynamic continuous cooling transformation (CCT) on 610MPa HSLA Steel Plate for 150,000 m3 Oil Storage Tank Construction were carried out on a MMS200 thermo-mechanical simulation system. It has found that with cooling rate increases pre-eutectoid ferrite, pearlite, granular bainite and lathing bainite will appear in the transformed microstructure. In comparison with static CCT, the transforming points of acicular ferrite, granular bainite and lathing bainite in the dynamic CCT curve shift to the left proving an increased acicular ferrite and bainite transformation area.

关键词: steel plate for oil storage;microstructure transformation;CCT-curve;non-quenching and tempering

ION HEATING PROCESS DURING PLASMA IMMERSION ION IMPLANTATION

X.B. Tian , X.F. Wang , A.G. Liu , L.P. Wang , S. Y. Wang , B. Y. Tang and P. K. Chu 1)Advanced Welding Production & Technology National Key Laboratory , Harbin Institute of Technology , Harbin 150001 , China 2)Department of Physics & Materials Science , City University of Hong Kong , China

金属学报(英文版)

The research on plasma immersion ion implantation has been conducted for a little over ten years. Much is needed to investigate including processing technlogy, plasma sheath dynamics, interaction of plasma and surface, etc. Of the processing methods elavated temperature technique is usually used in PIII to produce a thick modified layer by means of the thermal diffusion. Meanwhile plasma ion heating is more recently developed by Ronghua Wei et al[1]. Therefore the temeperature is a critical parameter in plasma ion processing. In this paper we present the theoretical model and analysize the effect of imlantation voltage, plasma density, ion mass,etc on the temperature rise.

关键词: plasma immersion ion implantation , null , null

介观LC电路在时变电源作用下量子态的演化

夏小建

量子电子学报 doi:10.3969/j.issn.1007-5461.2009.06.010

采用Wei-Norman方法,求出含时变电压源的介观LC电路随时间演化的精确解,应用相空间准概率分布函数,研究了时变电源作用下介观LC电路相干态的量子特性,结果表明此函数是一个二维运动的Gauss波包,其中心电量和磁通呈余弦和正弦变化.

关键词: 量子光学 , LC回路 , 介观电路 , 相干态 , 量子态演化 , 相空间的准概率分布函数

CFRP双剪单钉连接接头强度分析

崔海涛 , 温卫东

宇航材料工艺 doi:10.3969/j.issn.1007-2330.2004.04.011

双剪连接接头是复合材料结构连接设计的主要环节.针对T300/KH304复合材料层合板的双剪连接形式,分析了单钉连接情况下的接头强度,并采用Yamada-Sun准则预测了该层合板结构双剪连接接头的破坏载荷.结果表明:该接头的破坏模式主要呈现为挤压破坏;Yamada-Sun准则可以较好地预测该结构的破坏载荷;所预测的接头的破坏载荷及破坏模式,试验结果与数值分析结果比较一致.

关键词: 复合材料层合板 , 双剪连接接头 , 强度分析 , 有限元法

NiO/FeCo磁性多层膜的高频磁性

李玉伟 , 陈继红 , 唐东明 , 张豹山 , 鹿牧 , 陆怀先

功能材料与器件学报 doi:10.3969/j.issn.1007-4252.2010.02.011

制备了一系列具有铁磁/反铁磁交换偏置作用的[NiO/Fe65Co35]10多层膜,使用振动样品磁强计(VSM)测量了样品的静磁参数,利用微带线法测量了样品4GHz-10GHz的磁谱,首次制备并测得了自然共振频率(fr)在6GHz以上,最高到f=9.6GHz的薄膜样品.结果表明交换偏置场(Hex)、各向异性场(Hua)、以及矫顽力(Hc)随铁磁层厚度(tFM)增大而减小;基于Landau-Lifishitz (L-L)方程对静磁参量和磁谱进行了比较,发现样品自然共振频率较L-L方程计算值偏大30%以上.

关键词: 铁磁 , 反铁磁 , 交换偏置场 , 各向异性场 , 交换耦合能密度 , 自然共振频率

Oxidation of Alloying Elements during ESR of Stainless Steel

WEI Jihe Xi'an Institute of Metallurgy and Construction Engineering , China.

材料科学技术(英文)

The oxidation of alloying elements during the ESR of stainless steel has been studied. The model previously developed by WEI and Mitchell for the chemical reactions and mass transfer processes during ESR was applied to the remelting of the high Cr steel 1Cr18Ni9(Ti).The laboratory data for the unsteady state A.C.ESR were analyzed and dealt with by the model.When the remelting process reached a steady state,an oxidant(Fe_2O_3 powder)or a deoxidant(Ca-Si powder or metallic Ca)was added to the slag bath.The results showed that this model is applicable to the remelting of stainless steel rather precisely, and it is expected that the model may offer a reliable basis for the control of composition during practical ESR of high alloy steel. Also,the oxidation of Cr in the steel must be noticed when its content is high;but it is entirely possible to adjust the Cr content of ingot within a considerable range,using a special technique by means of the slag-metal reactions during the remelting.

关键词: ESR , null , null , null , null

高压下合成气层流火焰传播特性的实验研究

周镇 , 艾育华 , 孔文俊

工程热物理学报

本文利用双腔泄压式定压燃烧弹,研究了高压下典型IGCC合成气的层流火焰传播特性,得到了不同压力(0.1~1 MPa)和不同当量比下(0.6~3.0)合成气的层流火焰传播速度和Markstein长度.实验结果表明,层流火焰传播速度随当量比先增加后减少,随压力的增加而减小.Davis和Sun机理能较好地预测高压下合成气层流火焰的传播速度.Markstein长度随当量比的增加而增加,随压力的增加而减小.

关键词: 合成气 , 球形火焰 , 层流火焰传播速度 , Markstein长度

  • 首页
  • 上一页
  • 1
  • 2
  • 3
  • 下一页
  • 末页
  • 共3页
  • 跳转 Go

出版年份

刊物分类

相关作者

相关热词