M.M.El-Sayed Seleman
,
Xudong SUN
,
Liang ZUO
,
K.A.Khalil
材料科学技术（英文）
Alumina-(0 similar to 20 vol. pct) iron composites were fabricated by hot-pressing of well-mixed-alumina and iron powders at 1400 degreesC and 30 MPa for 30 min. Hot-pressed bodies with nearly theoretical density were obtained for addition up to 10 vol. pct Fe, but relative density decreased gradually with further increase in Fe addition. The materials exhibit a homogeneous dispersion of Fe. Fracture strength of the composites exhibits a maximum value of 604 MPa at 15 vol. pct Fe, which is 1.5 times that of alumina alone. Fracture toughness increases with the increase in Fe content, reaching 7.5 MPa.m(1/2) at 20 vol. pct Fe. The theoretical values of fracture toughness was calculated and compared with the experimental one. Toughening mechanisms of the composites are also discussed.
关键词:
M.M.El-Sayed Seleman
,
Xudong SUN
,
Liang ZUO
材料科学技术（英文）
Thermal shock behaviour was investigated for two morphologically different composites comprising an alumina matrix and 20 vol. pct Fe particles for a wide range of quenching temperature differences (∆T=100~800°C) and compared to a monolithic alumina. The retained strength and critical quenching temperature difference, ∆Tc, of the two composites were a significant improvement over the values for the respective monolithic alumina. Crack lengths and densities were shown to be greater for the alumina than for the two composites at all quenching temperature differences. The thermal shock resistance parameters for monolithic alumina and the two composites were calculated according to their mechanical and physical properties. The calculated results agree well with the experimental one and indicate possible explanations for the differences in thermal shock behaviour.
关键词:
Alumina-iron composite
,
null
,
null
M.M.El-Sayed Seleman
,
Xudong SUN
,
Liang ZUO
材料科学技术（英文）
Two morphologically different composites comprising an alumina matrix and 20 vol. pct Fe particles have been fabricated by hot pressing technique. Two kinds of microstructures, i.e. a dispersive distribution of Fe particles and a network distribution of Fe particles in alumina matrix, have been produced. Both composites are tougher than the virgin alumina matrix. The fracture toughness of the composite with a network microstructure is much higher than the composite with a microstructure of dispersed particles. For the particulate dispersion microstructure, the main limitation to the toughening is the lack of plastic deformation of the ductile Fe due to the pull out of Fe particles, indicating weak bonding at the Al2O3/Fe interface. For the network microstructure composite, the gauge length of the ductile phase is much larger, allowing the ductile Fe to be stretched to failure between the crack faces. The weak bonding at Al2O3/Fe interface can promote partial debonding and contribute further to toughening in the network microstructure composite.
关键词:
刘勤
,
周善佑
材料研究学报
超塑性m-δ关系曲线可以分为m_L=m_(max)和m_L=m_(min)两大类型。均可由下面的C.L.(刘勤)m-σ方程表示:σ(%)=〔cε~(m-m_0)-1〕×100当σ=σ_0=0时,m=m_0≠0,C=C_0=κ_0/κ_0=1。当σ=σ_1(σ_(11),σ_(12),σ_(13),…,)时,m=m_1(m_(11),m_(12),m_(13),…),C=C_1(C_(11),C_(12),C_(13),…)=κ_1(κ_(11),κ_(12),κ_(13),…)/κ_0,当σ=σ_F时,m=m_F,C=C_F=κ_F/κ_0。对C 值进行“规划”,得到的C_1~(σ_O-σ_L)-(m_L=m_(max)),C_2~(σ_F-σ_L)-(m_L=m_(min)),C_3~(m_0-m_L)-(m_L=m_(max)和C_4~(m_F-m_L)-(m_L=m_(min))四种类型的“规划”方程分别对m_L=m_(max)和m_L=m_(min)型m-σ曲线适用。若m-σ曲线属简单的下降式,C 及其“规划”值均可近似地取1。否则,C-σ关系是应加以研究的问题。m 和k 值对σ值的效应可以分为动态(直接)和静态(间接)两种。最后的σ值是两种效应的综合结果。(注:m 和κ值见基本方程σ=κε~m)
关键词:
齐召庆
,
汪宏涛
,
薛明
功能材料
doi:10.3969/j.issn.1001-9731.2016.02.010
采用改进的非接触式混凝土收缩测定仪及标靶,研究了m(M)/m(P)比值(MgO与KH2PO4的质量比)对磷酸镁水泥石自收缩行为的影响,运用八通道微量量热仪、压汞仪、X射线衍射仪、扫描电子显微镜及能谱仪等分析手段,分析了m(M)/m(P)比值对磷酸镁水泥石自收缩的作用机理.结果表明,磷酸镁水泥石的自收缩呈现出3个阶段的特征,即早期的迅速收缩阶段、微膨胀阶段、收缩缓慢发展阶段.随着m(M)/m(P)比值的增大,由于磷酸镁水泥石的水化放热量降低,水泥石内部孔隙率增大,水化产物结晶度降低,水泥石结构疏松,所以,自收缩率减小.
关键词:
磷酸镁水泥
,
自收缩
,
m(M)/m(P)比值
Tesshu Miyahara
材料科学技术（英文）
Magnetic stripe is one of the major applications of magnetic materials. As a key component of the present card technologies magnetic stripes play reliable components for electronic data interchange in worldwide electronic payment systems such as financial cards, transit tickets and phone cards, etc. Magnetic stripes are available in various coercivity materials, widths, lengths, structures and colors with each types of transferable, lamination and pressure sensitive magnetic tapes of Deuton-M. Manufacturing process, structure and characteristics of Deuton-M magnetic tape and sheet are described.
关键词:
卞进田
,
孙晓泉
,
聂劲松
量子电子学报
doi:10.3969/j.issn.1007-5461.2008.02.019
为了得到2.7 μm波段可调谐激光辐射,设计了信号光单谐振荡KTP光参量振荡器(OPO),给出了KTP OPO II(B)类相位匹配方式下的角度调谐曲线、有效非线性系数.KTP晶体切割角为θ=62°,ψ=0°,有效非线性系数为-2.97 pm/V.利用该KTP OPO实现了2.6～2.8 μm波段范围可调谐激光输出,用脉宽为16 ns的基模高斯光束1.064 μm激光泵浦得到了最大能量578 μJ,能量转换效率达1.7%.
关键词:
非线性光学
,
可调谐红外激光
,
单谐振光参量振荡器
,
KTP
,
角度调谐
,
相位匹配
Journal of Physics-Condensed Matter
We investigated the stable (0001) surfaces of M(2)AlC (M = Ti, V and Cr) using the first-principles plane-wave pseudopotential total energy method. Four possible (0001) terminations were considered by breaking the M-Al and M-C bonds. The corresponding surface energies were calculated and compared. The Al-and M(C)-terminated (0001) surfaces demonstrated better stability than the C- and M(Al)-terminated surfaces by their much lower surface energies. In addition, the stability of surfaces was predicted under various chemical environments as a function of chemical potentials. We further investigated the character of surface relaxations. The electronic structures of the stable Al- and M(C)-terminated surfaces were analyzed.
关键词:
ab-initio calculations;ti3sic2 thin-films;electronic-structure;elastic stiffness;al;deposition;cr2alc;simulation;adhesion;solids
