材料期刊网

DESIGN OF A/AD_m-BC_n DIRECTIONAL EUTECTIC COMPOSITES

S.P.Li.S.X. Zhao , X.H Yu , M .X. Pan , D.Q.Zhao and X.C.Chen (Institute of Physics Chinese Academy of Sciences , Beijing 100080 , China)O.M Barabash(Institute of Metal Physics , Kiev 252142 , Ukraine)(Manuscript received 9 February 1996)

金属学报(英文版)

Design process of A/ADm-BCn type directional eutectic composites was instanced by investigating Al-Mg-Si-Li and Ni-Mo-C-Al systems in this study by thermoanalysis and directional solidification techniques. It was demonstrated that A(D)-BCn eutectic alloys could be obtained more conveniently by using Smith′s thermoanalysis method to trace change of the eutectic Points of A-BCn induced by addition of components D. A/ADm-BCn directional eutectic composites could be produced from directionally solidified A/ADm-BCn alloys after proper heat treatments if components D have higher solid solubility in components A at high temperature and stable of metastable phases ADm could be formed at room temperature.

关键词: :solidification temperature scale , null , null

二维小角X射线散射法研究PAN基炭纤维内部微孔结构

盛毅 , 张彩红 , 徐耀 , 吕春祥 , 吴刚平 , 吴忠华 , 李志宏

新型炭材料

利用二维小角X射线散射(2D-SAXS)方法,对PAN基炭纤维全部方位角进行微孔结构的研究.样品选取自制炭纤维MHS及日本东丽公司T300,T800产品.结果表明:MHS炭纤维微孔尺寸介于T300与T800之间,长径比t值小于T300和T800.T300中较小微孔(<9.1 nm)和较大微孔(>15.4nm)的含量大于MHS,T800含有大量的微孔短轴小于2nm的小尺寸微孔.MHS炭纤维的界面复杂程度较T300大,而小于T800.炭纤维内部存在由微孔散射导致的密度波动,其波动振幅F值和波动密度n值按MHS、T300和T800依次递减;电子密度波动越小,表明微孔结构越规整,T800的孔结构最规整.炭纤维内各个取向上均有一定结构的微孔分布,但总体上呈现沿纤维轴方向的定向排列.

关键词: SAXS , 炭纤维 , 孔结构 , 分形维数 , 密度波动

聚丙烯腈(PAN)基纤维中微孔的2维小角X射线散射

马骁 , 白瑞成 , 任慕苏 , 孙晋良 , 秦显营 , 吕永根

材料科学与工程学报

应用二维小角X射线散射技术对PAN原丝、预氧丝、碳化丝纤维样品进行表征并采用Fankuchen切线法处理实验数据,得到微孔的平均结构信息.X射线散射集中在探测器平面赤道方向,原丝、预氧丝样品的散射强度相近并小于碳化丝散射强度,表明PAN基纤维在热处理过程中,纤维内部微孔一直沿纤维轴方向择优取向,在预氧化阶段微孔含量和大小基本保持不变,而在碳化阶段将产生大量微孔,并使微孔取向角增大.散射数据均呈现Porod正偏离,说明纤维内部还存在1nm以下的微结构起伏.

关键词: 碳纤维 , 小角X射线散射 , 微孔

同步辐射小角X射线散射研究PAN原丝制备过程中孔结构的演变

王琴 , 梁晓怿 , 吕春祥 , 张睿 , 乔文明 , 詹亮 , 刘鸿鹏 , 凌立成 , 陈中军 , 董宝中

高分子材料科学与工程

采用同步辐射小角X射线散射研究了PAN原丝制备过程中纤维轧结构的演变.结果表明,在水洗工艺中,纤维孔隙较多、较大,孔径分布较宽,近似圆形;在热水牵伸工艺中,纤维孔隙仍较多、较大,孔径分布较宽,近似椭圆形,长轴约17 nm-21 nm.短轴约4 nm～11nm;在干燥致密化工艺中,孔隙急剧减少、减小,孔径分布较窄,沿纤维轴向约7nm～9nm,垂直纤维轴向约2 nm;经过蒸汽牵伸,孔隙又增多、增大,孔径分布变宽,孔隙沿纤维轴向被牵伸得很长,近似梭形;但是随后的松弛热定型又使孔隙减小,孔径分布变窄.

关键词: 聚丙烯腈纤维 , 同步辐射小角X射线散射 , 孔隙结构

Structure, magnetic properties, and magnetostriction of Sm0.88Dy0.12(Fe1-xMx)(2) (M=Mn, Al) (0 <= x <= 0.2)

Journal of Applied Physics

The structure, magnetic properties, and magnetostriction of arc-melted polycrystalline Sm0.88Dy0.12(Fe1-xMx)(2) (M = Mn, Al, 0 less than or equal to x less than or equal to 0.2) alloys were investigated by microscopy, x-ray diffraction, A. C. initial susceptibility, vibrating sample magnetometry, and standard strain gauge techniques. It was found that the matrix consists almost entirely of the MgCu2-type cubic Laves phase, with a small amount of rare-earth rich phase. The lattice parameter increases approximately linearly with increasing x from 0.740 to 0.750 nm for M = Al. For M = Mn the lattice parameter increases by 0.002 8 nm over the same increase in x. The Curie temperature decreases with increasing x from 670 to 410 and 550 K for M = Al and Mn, respectively. The spontaneous magnetostriction, lambda(111), and polycrystalline magnetostriction, lambda(s), both decrease with increasing Al or Mn substitution for Fe from their initial values of -1452 and -1010 ppm, respectively. Premature disappearance of the splitting of the (440) line and changes in the shape of the magnetostriction curves suggest the substitution of Mn for Fe may produce a change in the anisotropy. No such effects were observed for M = Al. The saturation magnetization, M-S, decreases approximately linearly with increasing substitution of Al or Mn. The changes in the magnetization and magnetostriction can be understood on the basis of a decreasing 3d sublattice moment. (C) 1999 American Institute of Physics. [S0021-8979(99)02409-3].

关键词: substitution

MAGNETIC PROPERTIES OF Nd_2(Fe_(1-x)M_x)_(14)B(M=C,Si)ALLOYS

XING Feng JIANG Chao HE Wenwang Department of Physics , Peking University , Beijing , China [Originally published in ACTA METALL SIN (CHINESEEDN) 24 (5) 1988pp B348—B352 , received 22 October 1986:in revised form 8 May 1987]

金属学报(英文版)

The magnetic properties of Nd_2(Fe_(1-x)M_x)_(14)B(M=C and Si) compounds have been investi- gated.Substituting Fe by small amount of metalloid C and Si atoms,the compounds are in tetragonal structure and have uniaxial anisotropy.The substitution of C for part of Fe de- creases the Curie temperature of the compounds and the intrinsic coercivity of bond samples at low temperature.The replacement of Fe by Si makes the Curie temperature increase with a maximum at the vicinity of x=0.15.When the range of the content of Si is 0≤x≤0.10,the coercivity distinctly increases at room temperature.from 62.7 kA/m at x=0 to 138.7kA/m at x=0.06,where the residual magnetization has a maximum:in the mean time the saturation magnetization decreases only by a small amount.

关键词: Nd-Fe-B alloy , null , null

Nd_2(Fe_(1-x)M_x)_(14)B(M=C,Si)合金的磁性

邢峰 , 江潮 , 何文望

金属学报

本文研究了Nd_2(Fe_(1-x)M_x)_(14)B的磁性。少量类金属原子C和Si取代部分Fe,能形成四方结构,且具有单轴各向异性。碳取代Fe,使化合物的Curie温度降低,低温下粘结体样品的内禀矫顽力减少;而Si对Fe的取代可使Curie温度升高,并在x=0.15附近达到极大值。含Si样品在0≤x≤0.10范围内,矫顽力显著增加,室温下从x=0的62.7kA/m增加到x=0.06的138.7 kA/m,并且在x=0.06附近,剩磁有一个极值,饱和磁化强度减少不多。

关键词: Nd-Fe-B合金 , magnetic properties , Curie temperature

MnP_(1-x)M_x系列合金的磁热效应

门德 , 松林 , 伊博乐 , 刘璟芳 , 伊日勒图 , 特古斯

稀有金属 doi:10.3969/j.issn.0258-7076.2010.01.027

研究了1:1型MnP基系列合金MnP_(1-x)M_x(M=Si,Sb,Ge,Zn,Sn)(x=0,0.1)的结构及其磁热效应.室温X射线衍射表明该系列合金的主相结构均为正交MnP结构,空间群为Pnma.在用Ce,Sb,Zn,Sn作为替代元素的合金中存在少量第二相Mn_(5.64) P_3.磁性测量表明该系列合金MnP_(1-x)M_x(M=Si,Sb,Ge,Zn,Sn)(x=0,0.1)的存在由铁磁-顺磁的二级相变.其居里温度T_c分别为286,295,291,295,295 K.通过磁化曲线计算了MnP_(1-x)M_x(M=Si,Sb,Ge,Zn,Sn)(x=0,0.1)合金的最大等温磁熵变-△S_m,均在0.7-1.3 J·kg~(-1)·K~(-1)之间.

关键词: 合金 , 磁制冷 , 磁热效应 , 磁熵变

M_1-M_2-x-y系优势区相图的绘制及其应用

王龙章 , 黄克雄 , 骆如铁 , 姚渝 , 叶大陆 , 陈新民

金属学报

本文讨论了双金属共存体系M_1-M_2-x-y,当两种金属的化合物相互作用生成多金属化合物时,优势区相图的绘制原理、方法及计算机程序。通过绘制Zn-Fe-SO系的优势区相图,分析了ZnO·Fe_2O_3的生成及稳定条件,并说明了其在硫化锌矿焙烧中的指导作用。

关键词: M_1-M_2-x-y体系 , predominance diagram , roasting , zinc sulfide ore

DRAWING PREDOMINANCE DIAGRAM OF M_1—M_2—x—y SYSTEM AND ITS APPLICATION

WANG Longzhang HUANG Kexiong LUO Rutie YAO Yu YE Dalu CHEN Xinmin Central South University of Technology , Changsha , China

金属学报(英文版)

Discussions were made of the principle,method and computer program for drawing the pre- dominance diagrams of the bi-metal co-existed system M_1-M_2-x-y in which the multi-me- tallic compounds may be produced by interaction between compounds of both metals.The formation of zinc ferrite and its stable region have been analyzed through drawing Zn-Fe-S-O system predominance diagrams.The availability of the diagram is given the di- rection to roast the zinc sulfide ore as well.

关键词: system M_1-M_2-x-y , null , null , null