欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(26)
  • 图书()
  • 专利()
  • 新闻()

Investigation on Co-Combustion Kinetics of Anthracite and Waste Plastics by Thermogravimetric Analysis

LIU Zheng-jian , REN Shan , ZHANG Jian-liang , LIU Wei-jian , XING Xiang-dong , SU Bu-xin

钢铁研究学报(英文版)

In order to effectively recycle resource for the benefit of the global environment, the utilization of waste plastics as auxiliary injectant for blast furnaces is becoming increasingly important. Combustion kinetics of plastics-coal blends with 0, 10%, 20% and 40% waste plastics (WP) are investigated separately by thermogravimetric analysis (TGA) from ambient temperature to 900 ℃ in air atmosphere. These blends are combusted at the heating rates of 5, 10 and 20 ℃/min. The results indicate that, with the increase of waste plastics content, the combustion processes of blends could be divided into one stage, two stages and three stages. The waste plastics content and heating rates have important effects on the main combustion processes of blends. With the increase of waste plastics content, the ignition temperature and the final combustion temperature of blends tend to decrease, while the combustion reaction becomes fiercer. With the increase of the heating rate, the ignition temperature, the mass loss rate of the peaks and the final combustion temperature of blends combustion tend to increase. The Flynn-Wall-Ozawa (FWO) iso-conversional method is used for the kinetic analysis of the main combustion process. The results indicate that, when the waste plastics content varied from 0 to 40%, the values of activation energy increase from 126.05 to 184.12 kJ /mol.

关键词: waste plastics , anthracite , co-combustion kinetics , TGA , iso-conversional method

复合材料层合壳体的三维本构方程

杨宜谦

玻璃钢/复合材料 doi:10.3969/j.issn.1003-0999.1999.04.002

本文推导出了复合材料层合壳体的三维本构方程,修正了Reddy和Liu论文中的错误.

关键词: 复合材料 , 壳体 , 三维本构方程

3 0CrMnSi 2A钢飞机主梁疲劳断裂分析

马康民 , 宣建光 , 康进兴

材料工程 doi:10.3969/j.issn.1001-4381.2001.10.012

用扫描电镜观察了某型飞机机翼主梁的疲劳断口,用疲劳条带估算了裂纹扩展寿命,并用Zheng-Hirt公式估算出裂纹尖端应力强度因子范围,估算结果与实验测定值十分接近,从而为研究老龄飞机的使用寿命,进行了有益的探索.

关键词: 机翼主梁 , 30crMnSiNi2A , 疲劳裂纹扩展寿命

1998 COMPREHENSIVE TABLE OF CONTENTS

中国腐蚀与防护学报

N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat(6)Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac(13)SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch&tllsth Of ThlollY68 Oil ITOll ID H....

关键词:

Monte Carlo simulation of angular distribution and fractionation in the zero-fluence isotope sputtering

Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms

A static Monte Carlo simulation program has been used to study the influence of primary and secondary knock-on atoms on the angular distribution and the fractionation, for zero-fluence sputtering of Mo-92-Mo-100. At 10 keV Xe ion energy, calculations show that significant depth-dependent momentum asymmetry exists in the near-surface region, as in Refs. (L.P. Zheng, R.S. Li, M.Y.LI, Nucl. Instr, and Meth. B 100 (1995) 490; L.P. Zheng, M.Y. Li, Nucl. Instr. and Meth. B 114(1996) 28). The calculations also show that at the polar emission angle range between 0 degrees and 90 degrees the probabilities of the sputtered primary knock-on atoms for Mo-92 and Mo-100 are small (6.1% for Mo-92 and 6.6% for Mo-100), especially, between 0 degrees and 30 degrees they are very small (2.5% for Mo-92 and 2.8% for Mo-100). At 0.1 keV Ar ion energy, the calculations show that partial momentum flux ratios, for the primary and the secondary knock-on atoms, deviate far from one, through marker plane 1 (about an atomic layer distance from the surface). (C) 1998 Elsevier Science B.V. All rights reserved.

关键词: mo-92-mo-100;targets

DL-EPR法评价2205双相不锈钢晶间腐蚀敏感性

徐菊良 , 邓博 , 孙涛 , 李劲 , 蒋益明

金属学报 doi:10.3724/SP.J.1037.2009.00598

利用Thermo-Calc软件并结合金相显微镜,定性研究了2205双相不锈钢在800℃下敏化不同时间后的微观组织演变过程.通过研究扫描速率、介质成分、介质温度和试样表面状态优化了双环电化学动电位再活化法(DL-EPR),并用该优化方法研究了2205双相不锈钢晶间腐蚀敏感性.结果表明:DL-EPR法能定量评价σ相对2205双相不锈钢晶间腐蚀敏感性的影响,随敏化时间延长,σ相含量增多,晶jian 腐蚀敏感性也随之增加.腐蚀形貌的观测验证了这一规律,

关键词: 2205双相不锈钢 , DL-EPR , 晶间腐蚀敏感性 , σ相

聚醛/蒙脱土纳米复合材料非等温结晶动力学研究

徐卫兵 , 戈明亮 , 何平笙

应用化学 doi:10.3969/j.issn.1000-0518.2001.09.011

用熔融插层法制备聚甲醛/蒙脱土纳米复合材料,用X射线衍射研究聚甲醛及复合材料的微观结构,表明复合材料是纳米复合材料.用DSC法研究其非等温结晶行为,对所得数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚甲醛及聚甲醛/有机蒙脱土纳米复合材料的结晶活化能分别为334.6和196.9 kJ/mol,说明有机蒙脱土的加入,降低了聚甲醛的结晶活化能,且t1/z缩短,起到了异相成核的作用.

关键词: 聚甲醛 , 蒙脱土 , 纳米复合材料 , 非等温结晶动力学

聚丙烯/凹凸棒土纳米复合材料的非等温结晶动力学

王平华 , 徐国永

应用化学 doi:10.3969/j.issn.1000-0518.2004.08.007

用熔融复合法制备聚丙烯/凹凸棒土纳米复合材料,用DSC法研究其非等温结晶行为,对所得的数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚丙烯及聚丙烯/凹凸棒土纳米复合材料的结晶活化能分别为194.1和162.8 kJ/mol,表明凹凸棒土的加入,降低了聚丙烯的结晶活化能,且t1/2缩短,起到了异相成核作用.

关键词: 聚丙烯 , 凹凸棒土 , 纳米复合材料 , 非等温结晶动力学

Reply to Comments on "Interdiffusion in the beta phase region of the Ni-Al-Cr system"

Scripta Materialia

A recent comment on a previously published paper addressed the invalid explanation of the off diagonal interdiflusion coefficients of the beta-Ni(Al,Cr) phase in the Ni-Cr-Al system according to the symmetric property of the thermodynamic matrix. In this paper, the experimental data presented by Hou et al. was reanalyzed and the interdiffusion coefficient matrix was estimated again. The results of the analysis have been discussed in terms of a brief reply to the comments of Liu and Liang. (C) 2010 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

关键词: Diffusion;Intermetallic compound;Ni-Cr-Al

  • 首页
  • 上一页
  • 1
  • 2
  • 3
  • 下一页
  • 末页
  • 共3页
  • 跳转 Go

出版年份

刊物分类

相关作者

相关热词