REN Jianshi
,
ZHANG Gongshu Institute of Metal Research
,
Academia Sinica.Shenyang
,
China WANG Zhenshu
,
LIU Gen
,
LIU Shenglin Shanghai University of Technology
,
Shengyang
,
China
金属学报(英文版)
Investigation was made of the sputtering rate in glow discharge lamp with relaion to constituent of 25 different specimens of 6 binary systems.namely,Cr-Fe,Bi-Sb,Cu-Zn, Ag-Cu,Al-Zn and Cd-Sn.by measuring mass loss sfter each sputtering under constant Ar pressure and voltage applicd.The correlation.in general,between sputtering rate and concentration of constituent of these non-intermetallic binary alloys obeys the hyperbolic law under steady state,that may be approximately regarded as linear correlation only on certain special condition if the two components of the alloys with similar sputte ringrates.
关键词:
eathode sputtering
,
null
,
null
,
null
江虹
,
胡小莉
,
刘绍璞
,
秦宗会
,
湛海粼
应用化学
doi:10.3969/j.issn.1000-0518.2003.09.016
在pH值为3.5～6.0,镧(Ⅲ)-依文思蓝(EB)与硫酸新霉素(NEO)、硫酸卡那霉素(KANA)、硫酸庆大霉(GEN)和硫酸妥布霉素(TOB)等氨基糖苷类抗生素反应可生成具有吸收峰和负吸收峰的三元蓝色离子缔合物.其最大吸收波长位于668～674 nm,线性范围从0～1.20×10-5g/mL至0～1.加×10-5g/mL,摩尔吸收光系数(ε)在3.10×104～6.17×104L/(mol@cm)之间;最大负吸收波长位于614～620 nm,线性范围从0～9.00×10-6g/mL至0～1.7×10-5g/mL,摩尔吸收光系数(ε)在4.33×104～1.04×105L/(mol@em).当用正负光吸收叠加时,灵敏度更高.探讨了反应条件、主要分析化学性质及三元缔合物的配合比(LA:EB:GEN=1:2:3).
关键词:
镧(Ⅲ),依文思蓝,氨基糖苷,抗生素,分光光度法
徐卫兵
,
戈明亮
,
何平笙
应用化学
doi:10.3969/j.issn.1000-0518.2001.09.011
用熔融插层法制备聚甲醛/蒙脱土纳米复合材料,用X射线衍射研究聚甲醛及复合材料的微观结构,表明复合材料是纳米复合材料.用DSC法研究其非等温结晶行为,对所得数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚甲醛及聚甲醛/有机蒙脱土纳米复合材料的结晶活化能分别为334.6和196.9 kJ/mol,说明有机蒙脱土的加入,降低了聚甲醛的结晶活化能,且t1/z缩短,起到了异相成核的作用.
关键词:
聚甲醛
,
蒙脱土
,
纳米复合材料
,
非等温结晶动力学
王平华
,
徐国永
应用化学
doi:10.3969/j.issn.1000-0518.2004.08.007
用熔融复合法制备聚丙烯/凹凸棒土纳米复合材料,用DSC法研究其非等温结晶行为,对所得的数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚丙烯及聚丙烯/凹凸棒土纳米复合材料的结晶活化能分别为194.1和162.8 kJ/mol,表明凹凸棒土的加入,降低了聚丙烯的结晶活化能,且t1/2缩短,起到了异相成核作用.
关键词:
聚丙烯
,
凹凸棒土
,
纳米复合材料
,
非等温结晶动力学
Y.L.Yang
,
F.J.Sun
,
D.Zhang
金属学报(英文版)
The formation of Fe-N compounds by laser nitriding in an atmospheric ambient was reported.By CW-CO2 laser irradiation on pure ferrite iron in the atmospheric am-bient,Fe-N compounds (including Fe2N,Fe3N and Fe4N) are formed as a result of a laser-enhanced and temperature-enhanced reactions.The samples were analyzed with X-ray diffraction.It is found that the laser power density,scanning speed and nitro-gen temperature are the main factors influencing the formation of Fe-N compounds.Nitrogen can be activated by pre-heating at some temperature.Nitrogen activation and sample surface melting by CW-CO2 laser greatly enhance the reaction between the sample surface and nitrogen beam.After annealing at 500℃ for Sh,some Fe2N and Fe3N converted into more stable Fe4N.
关键词:
laser nitriding
,
null
,
null
Scripta Materialia
A recent comment on a previously published paper addressed the invalid explanation of the off diagonal interdiflusion coefficients of the beta-Ni(Al,Cr) phase in the Ni-Cr-Al system according to the symmetric property of the thermodynamic matrix. In this paper, the experimental data presented by Hou et al. was reanalyzed and the interdiffusion coefficient matrix was estimated again. The results of the analysis have been discussed in terms of a brief reply to the comments of Liu and Liang. (C) 2010 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
关键词:
Diffusion;Intermetallic compound;Ni-Cr-Al
邓超
,
邵玮
,
李春忠
高分子材料科学与工程
采用元机纳米锑掺杂二氧化锡(ATO)和有机聚醚酯(PEE)协同提高聚时苯二甲酸乙二酯(PET)的抗静电性能,合成了聚对苯二甲酸乙二酯-聚醚酯/锑掺杂二氧化锡纳米复合材料(PET-PEE/ATO).使用Czawa方程和Liu-Mo方程研究了PET-PEE/ATO纳米复合材料的非等温结晶过程.Ozawa方程研究发现,在非等温结晶过程中,PET、PET-PEE、PET/ATO、PET-PEE/ATO的成核性能依次提高.Liu-Mo方程发现,ATO和PEE的加入分别促进了异相成核作用和加快了结晶生长,PET-PEE/ATO结晶成核性能最好,结晶速率最快.
关键词:
聚对苯二甲酸乙二酯
,
有机聚醚酯
,
无机纳米锑掺杂二氧化锡
,
纳米复合材料
,
非等温结晶动力学
K. Mii (Sumitomo Metal Industries
,
Ltd.
,
1-t-3 Otemachi
,
Tokyo 100
,
Japan)M Amano (National Research Institute for Metals
,
1-2-1 Sengen
,
Tsukuba 305
,
Japan)
金属学报(英文版)
The R & D of hydrogen absorbing alloys in Japan started in the early 1970s.Many alloys such as TiMm1.5 based alloys, Fe-Ti-O alloys (e.g. FeTi1.15 O0.024) andthe(mischmetal)Ni5 based alloys (e.g. MmNi4.5 Cr0.46 Mn0.04) were developed by the early 1980s. The application of these alloys to hydrogen storage, heat storage, heat pump, hydrogen purification and motor vehicles has been tried in many iaboratories,and the various techniques for using hydrogen absorbing alloys have been developed.The standarkization of evaluation methods for hydrogen absorbing alloys has been promoted by the Ministry of International Trade and Industry (MITI), and four of them were established as Japanese Industrial Standard (JIS).Alloys for Ni-Metal Hydride batteries have been extensively investigated since 1987in Japun. Mm-Ni-Co-Al-Mn alloys (e.g. MmNi3.55 Co0.75Al0.9Mn0.4) have been devel-oped and commereialized since 1990. The amount of production of small-size Ni-MH batteries in 1995 was about three hundred milliion in number and about one hundred billion yen. The R & D for higher enerpy-density Ni-MH batteries is intensively in progress.MITI and STA (Science and Technology Agency) have promoted the R & D of hydro-gen absorbing alloys in Japan by carrying out the national projects such as Sunshine Program (MITI: 1974-1993) and Utilization of Wind Engeray (STA 1980-1985). The New Sunshine Program (MITI 1993-2020) have started in 1993. This program con-tains the application of hydrogen absorbing alloys to Economical- Enerpy- City System and to We-NET (International Clean Energy System of Technology Utilizing Hydro-gen: World Energy Network.
关键词:
hydrogen absorbing alloy
,
null
,
null
,
null
