Journal of Applied Physics
Based on the developed multiple-scattering theory [C.-W. Nan and F. S. Jin, Phys. Rev. B 48, 8578 (1993)], an effective-medium theory (EMT) is proposed to treat coupled electromechanical behavior in composite media. The explicit relations for determining effective behavior of piezoelectric composites are derived. To illustrate the technique, numerical results of piezoelectric ceramic/epoxy composites for various particle shapes are presented over the whole range of concentrations. The EMT estimates are shown to be in good agreement with available experimental results. Porous piezoelectric ceramics are also discussed. The EMT predicts a similar critical behavior for heterogeneous piezoelectric materials to recent experiments.
关键词:
electromechanical properties;ceramics
Canying CAI
,
Qibin YANG
,
Hongrong LIU
材料科学技术（英文）
Assuming that the wave function , the Schrodinger equation can be written as . Neglecting the last two terms, an analytical expression of electron dynamical diffraction was derived by Qibin YANG et al. In this paper, the analytical expression is modified by further considering the second-order differential term . When the accelerating voltage is not very high, or the sample is not very thin, the reciprocal vector ɡ is large, the modification of the second-order differential is necessary; otherwise it can be neglected.
关键词:
Electron dynamical diffraction
,
null
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Acta Materialia
In a first report [Jin ZH.. Gumbsch P, Ma E, Albe K, Lu K, Hahn H, et al. Scripta Mater 2006;54:1163], interactions between screw dislocation and coherent twin boundary (CTB) were studied via molecular dynamics simulations for three face-centered cubic (fcc) metals, Cu, Ni and Al. To complement those preliminary results, purely stress-driven interactions between 60 degrees non-screw lattice dislocation and CTB are considered in this paper. Depending on the material and the applied strain, slip has been observed to interact with the boundary in different ways. If a 60 degrees dislocation is forced by an external stress into a CTB, it dissociates into different partial dislocations gliding into the twin as well as along the twin boundary. A sessile dislocation lock may be generated at the CTB if the transited slip is incomplete. The details of the interaction are controlled by the material-dependent energy barriers for the formation of Shockley partial dislocations from the site where the lattice dislocation impinges upon the boundary. (c) 2007 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
关键词:
dislocation;slip;twinning;twin grain boundary;molecular dynamics;molecular-dynamics simulation;grain-boundaries;nanocrystalline;materials;cross-slip;rate sensitivity;deformation;copper;strength;aluminum;fcc
颜慧成
,
郭征
,
张孟亭
,
张洪平
钢铁研究学报
引入变量m(冲量密度)和Yang-Mills型规范变换m=u+gradφ,将原始变量的N-S方程转化为规范-不变量形式,用自由质点法处理Voronoi元,对连铸结晶器弯月面处保护渣流动行为进行数学模拟.输出振动周期内的动态流场,然后结合一组试验数据进行计算,计算结果与实际情况相吻合,进而讨论了渣圈对液渣流动行为的影响,为研究结晶器弯月面处保护渣的行为和铸坯振痕的形成提供了一定的依据.
关键词:
连续铸钢
,
保护渣
,
流动行为
,
数学模拟
章明川
,
张楚
,
林郁郁
,
徐旭常
工程热物理学报
根据快速流化床的基本流动特性、A 型噎塞和 C 型噎塞的特征与定义,建立了一个统一,自恰的快速床模型一分相共存模型.模型以 A 型噎塞的修正Yang公式为‘本构方程',合理预报了快速床的最小固体流率Gsm,以及在固体流率不变的条件下降低操作气速时床层由A型噎塞向C型噎塞的连续过渡.模型中的稀相有效气流速度函数幂次n为可调参数,根据 C 型噎塞速度预报的Yousfi and Gau公式,初步确定模型参数n=4.
关键词:
快速流态化
,
噎塞速度
,
A 型噎塞
,
C 型噎塞
,
分相共存模型
曹春海
,
杨名
,
张世远
,
杨森祖
,
崔旭高
,
尤立星
,
吉争鸣
,
康琳
,
许伟伟
低温物理学报
doi:10.3969/j.issn.1000-3258.2003.03.002
采用Nd0.7Sr0.3MnO3/SrTiO3/YBa2Cu3O7-δ的异质结构,研究了自旋极化准粒子的注入效应.在56μm宽的YBCO膜条上成功地制备了与超导膜条同样宽度但不同长度的六个注入结区,长度L分别为80μm, 40μm, 20μm, 10μm, 5μm和2μm.80nm厚的YBCO薄膜在16K温度下Jc为2×105A/cm2.Iin=0.5mA的自旋电流注入下,随L从80μm逐渐顺次减小时,注入效率η=ΔJc/ΔJin逐渐增大.而当L≤20μm后,η不再增加,达到几乎相同的值(～6).初步分析认为这与自旋极化准粒子在超导膜内的有效自旋扩散长度有关.异质结构中YBCO薄膜的超导电性以及注入窗口的尺寸对获得大的自旋注入效率十分重要.
关键词:
注入效率
,
自旋准粒子
,
巨磁阻
,
异质材料
章明川
,
张楚
工程热物理学报
通过介观机理解析及子模型的优化,对已建立的快速流化床动力学统一模型进行了改进.包括:1)模型参数n和气相速度有效系数F(β)的介观模型确定方法;2)A型噎塞Yang公式摩擦系数的实验再相关;3)Harris团聚物尺寸关联式的无因次重建;4)团聚物空隙率的预报及浓相模型修正.应用所建立的统一模型对垂直并流气-固系统的C型噎塞、快速床提升管上部稀相和下部浓相的固含率、以及向高密度快速床和浓相悬浮上升流的过渡等进行了综合性的预报,并得到文献中数百个不同实验结果很好的验证.
关键词:
快速流化床
,
介观机理解析
,
管壁摩擦系数
,
团聚物尺寸
,
实验验证
