WANG Xiao-dong
,
LI Fei
,
JIANG Zheng-yi
钢铁研究学报(英文版)
Non-uniformity of temperature distribution across strip width direction is the ultimate reason why the flatness defect occurs on the strip after cooling process although the strip is flat at the exit of finishing mill. One thermal, microstructural and mechanical coupling analysis model for predicting flatness change of steel strip during the run-out table cooling process was established using ABAQUS finite element software. K Esaka phase transformation kinetics model was employed to calculate the phase transformation, and coupled with temperature calculation using the user subroutine program HETVAL. Elasto-plasticity constitutive equations of steel material, in which conventional elastic and plastic strains, thermal strain, phase transformation strain and transformation induced plastic strain were considered, were derived and programmed in the user subroutine program UMAT. The conclusion that flatness of steel strip will develop to edge wave defect under the functions of the differential thermal and microstructural behaviors across strip width during the run-out table cooling procedure was acquired through the analysis results of this model. Calculation results of this analysis model agree well with the actual measurements and observation.
关键词:
hot rolled strip
,
internal stress
,
phase transformation
,
run-out table cooling
,
flatness
王丽
,
吴希文
,
张晨鼎
,
张通
,
简丽
,
武朝军
,
周涛
稀土
doi:10.3969/j.issn.1004-0277.1999.02.003
采用湿渣法研究了0℃时碘化钇(YI3)-乌洛托品氢碘酸盐(C6H12N4.HI)-水(H2O)的三元体系相平衡,绘制了该体系的等温溶解度相图,相图分析结果表明,该体系中有组成为YI3.C6H12N4.HI.14H2O的配合物生成,对所得配合物进行了化学分析、X-射线粉末衍射、红外光谱、差热-热重分析,测定了其密度、晶体轴性,确定了配合物结构中的配位关系.
关键词:
相平衡
,
碘化钇
,
乌洛托品氢碘酸盐
,
配合物
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
宁远涛
贵金属
评述了合金元素对Au的漂白效果和机制，介绍了白色开金的几种色度参数，如CIE-L a*b*色度参数和颜色盒，CIE-LAB-C-H-L米制色度参数和基于CIE-XYZ色度参数的ASTM D1925黄色指数YI，讨论了某些白色开金的色度参数与冶金学特征。基于金合金的漂白效应与合金成分的密切关系，ASTM D1925黄色指数YI为设计白色开金成分提供了基本的指南。
关键词:
金属材料
,
Au合金
,
白色开金
,
色度参数
,
色度图
徐旸
,
汪艳
,
傅轶
合成材料老化与应用
采用多次挤出的方法和氧化诱导期(OIT)方法考察了抗氧剂对聚丙烯热氧稳定性的影响,测定了各次挤出试样的熔体流动速率(MFR)、黄度指数(YI)、力学性能以及氧化诱导期(OIT).实验结果表明:添加由主抗氧剂1010和辅抗氧剂168组成的复合抗氧剂后聚丙烯的熔体流动速率(MFR)、黄度指数(YI)、拉伸强度和冲击强度、氧化诱导期(OIT)与未添加抗氧剂的聚丙烯相比降低明显减缓,说明抗氧剂可有效抑制聚丙烯的老化,延长其使用寿命.
关键词:
聚丙烯
,
抗氧剂
,
热稳定性
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms
A static Monte Carlo simulation program has been used to study the influence of primary and secondary knock-on atoms on the angular distribution and the fractionation, for zero-fluence sputtering of Mo-92-Mo-100. At 10 keV Xe ion energy, calculations show that significant depth-dependent momentum asymmetry exists in the near-surface region, as in Refs. (L.P. Zheng, R.S. Li, M.Y.LI, Nucl. Instr, and Meth. B 100 (1995) 490; L.P. Zheng, M.Y. Li, Nucl. Instr. and Meth. B 114(1996) 28). The calculations also show that at the polar emission angle range between 0 degrees and 90 degrees the probabilities of the sputtered primary knock-on atoms for Mo-92 and Mo-100 are small (6.1% for Mo-92 and 6.6% for Mo-100), especially, between 0 degrees and 30 degrees they are very small (2.5% for Mo-92 and 2.8% for Mo-100). At 0.1 keV Ar ion energy, the calculations show that partial momentum flux ratios, for the primary and the secondary knock-on atoms, deviate far from one, through marker plane 1 (about an atomic layer distance from the surface). (C) 1998 Elsevier Science B.V. All rights reserved.
关键词:
mo-92-mo-100;targets
倪永中
,
徐鸿
材料科学与工程学报
本文提出了一种基于粒子群算法和有限元方法的弹塑性本构方程参数的确定方法,并在此基础上开发了参数自动优化系统CMPI(Constitutive Material Parameter Identification).通过使最小二乘形式的目标函数达到极小值,实现参数的动态寻优;模型参数作为粒子群优化模块的输入,采用应变(应力)控制方法,调用材料非线性有限元模块计算特定参数时的应力(应变)响应,并计算与实验数据的误差,从而实现优化过程.CMPI目前适用于A-F类模型(Chaboehe、Ohno-Wang、Jiang-Sehitoglu)的参数优化,以此为基础,不难扩展到其他材料模型.
关键词:
粒子群
,
材料非线性
,
有限元
,
Ohno-Wang 模型
Physical Review B
An elastic Ising model for CoMnO(6) chain is proposed to explain the ferroelectricity induced by collinear magnetic order in Ca(3)CoMnO(6), and then a mean-field theory with interchain spin interactions based on this model is developed. With inclusion of the dynamics of polarization domains at finite temperature, we address the rationality of our theory by the good agreement of the calculated electric polarization and dielectric susceptibility with the reported data on Ca(3)Co(2-x)Mn(x)O(6) (x approximate to 0.96) [Y. J. Choi, H. T. Yi, S. Lee, Q. Huang, V. Kiryukhin, and S.-W. Cheong, Phys. Rev. Lett. 100, 047601 (2008)], a typical diatomic Ising spin chain system, while the predicted magnetic susceptibility shows some difference from experiment, the reason of which is discussed.
关键词:
calcium compounds;cobalt compounds;dielectric polarisation;ferroelectricity;Ising model;magnetic susceptibility;multiferroics;optical susceptibility;one-dimensional oxides;magnetic-properties;multiferroics;ca3co1+xmn1-xo6
