WANG Fuhui
,
LOU Hanyi
,
WU Weitao Corrosion Science Laboratory
,
Institute of Corrosion and Protection of Metals
,
Academia Sinica
,
Shenyang
,
China research assistant
,
Institute of Corrosion and Protection of Metats
,
Academia Sinica
,
Shenyang 110015
,
China
金属学报(英文版)
The influence of defects on the oxidation, hot corrosion and thermal shock properties of sputtered Co-30Cr-6Al-0.5Y coatings was investigated.The results indicated that the nodular defects reduced the properties of the coatings.For the oxidation,the nodular defects resulted in the severe internal oxidation of aluminium,as a result,the pure alu mina scale could not form at very high temperature such as at 1 100℃.For the hot corrosion,the nodular defects served as the short-path for the diffusion of sulfur into the coating and the substrate,and caused the sulfidation,of the specimen.Moreover,the nodular defects became the crack source during the thermal shock test and decreased the thermal shock resistance.
关键词:
CoCrAlY coating
,
null
,
null
,
null
,
null
F. Lu and WJ. van Ooij( Beijing Institute of Aeronautical Materials
,
P.O. Box 81-5
,
Beijing 100095
,
China)( Department of Materials Science and Engineering
,
University of Cincinnati
,
Cincinnati
,
OH 45221-0012
,
U.S.A.)
金属学报(英文版)
Zn-Al couple's galvanic coeeosion was a serious problem in acdic ainc sulfate solution .In this paper, a new pretreatment or a coating for Al was developed and tested to protect the Al effectively form corrosion when connected to pure Zinc at electroplating potential,and exposed to an acdic sulfate solution.Corrosion measurement techniques(Galvanic corrosion and DC)were used to investigate galvanic corrosion between Al cathode and Zn anode.It was found out that Al alloy purity and electroplating potential have a large effect on galvanic corrsion between Zn-Al couples.EIS,salt spray test and immersion test were performed to evaluate the method for Al cathodes in zinc electrolyte,BTSE silane pretreatment and polyurethane coating displayed better corrosion protection.Calculation showed the Al dissolution rate is small enough for Al cathode to be used in zinc plants.BTSE treatment or BTSE plus polyurethane coating has the best corrosion performance,and willprotect the Al cathode effectively in zinc electrolysis
关键词:
Al-Zn couple
,
null
Polymers for Advanced Technologies
A corrosion protection coating from polyimide/polyaniline (PI/PAn) blend was prepared by solution blending and the anti-corrosion property of this coating was studied with electrochemical impedance spectroscopy technique. The results show that PAn can react with PI to form chemical bonds between these two polymers and these bonds keep these two polymers as a miscible system. The corrosion protection property of this coating increases with a growth in the PAn component and an excellent anti-corrosion effect emerges when the PAn content reaches 10-15%. The reason why PAn can improve the anti-corrosion property is that PI/PAn blend can form a dense and non-porous polymer film that would prevent some corrupting components from access to the underlying steel surface. And also, PAn may serve as a corrosion inhibiting agent to scavenge any protons and foster a local basic surface environment. Copyright (C) 2001 John Wiley Sons, Ltd.
关键词:
polyaniline;polyimide;corrosion;EIS
Materials and Corrosion-Werkstoffe Und Korrosion
Galvanic anodic protection (GAP) of stainless steels by doped polypyrrole (PPy) was investigated using chemically synthesized PPy. Separate PPy powder-pressed electrodes with different surface areas were prepared. Electrochemical properties of PPy electrodes were studied by open circuit potentials (OCPs) and potentiostatic polarization. PPy powder-pressed electrodes were coupled with 410-stainless steel electrodes in different concentrations of sulfuric acid solutions, 5 M phosphoric acid solution, and industrial phosphoric acid solution (5 M phosphoric acid + 0.05% chloride ion). Remarkable shift of OCP to the positive direction and sharp decrease of corrosion rate were observed during the coupling experiments, which implies that 410-stainless steel was transferred to passive state. Results also showed that PPy electrode with sufficient surface area can provide corrosion protection to 410-stainless steel electrode in highly corrosive acid solution. Based on the experiment results, GAP provided by PPy and PANi (synthesized under similar conditions) was compared.
关键词:
galvanic anodic protection;organic metal polyaniline;coated;mild-steel;conducting polymers;doped polyaniline;ferrous-metals;carbon-steel;coatings;iron;passivation
Corrosion Science
Potential and current distributions in a cathodically protected crevice between a simulated coating and segmented mild steel electrodes were measured in dilute NaCl solutions. The distributions became more uniform with time due to an increase in solution conductivity and depletion of dissolved oxygen in the crevice. Generally, a negative shift of control potential and an increase in initial solution conductivity and crevice thickness resulted in a higher polarization level on the steel. However, if the control potential is too negative, the polarization level may be lower than that under a suitable control potential because of hydrogen evolution. On the basis of these results, a mechanism of cathodic protection against crevice corrosion in high-resistivity environments was proposed. (C) 2002 Elsevier Science Ltd. All rights reserved.
关键词:
cathodic protection;crevice corrosion;potential distribution;current;distribution;mild steel;dilute NaCl solution;coatings
Chunlin HE
,
Changsheng LIU
,
Fengqin LI
,
Qingkui CAI
,
Zhiming SHI
,
Liqing CHEN
,
Jing BI
材料科学技术（英）
The corrosion resistance of 2024 Al and SiC particle reinforced 2024 Al metal matrix composite (SiCp/2024Al MMC) in 3.5% NaCl solution was investigated with electrochemical method and immersion test, and the corrosion protection of sulfuric acid anodized coatings on both materials was evaluated by electrochemical impedance spectroscopy. The results showed that the SiCp/2024Al MMC is more susceptible to corrosion than its matrix alloy in 3.5% NaCl. For 2024Al, the anodized coating provides excellent corrosion resistance to 3.5% NaCl.The anodized coating on the SiCp/2024Al provides satisfactory corrosion protection, but it is not as effective as that for 2024Al because the structure of the anodized layer is affected by the SiC particulates.
关键词:
2024 Al
,
null
,
null
,
null
International Journal of Electrochemical Science
A novel Ti/Zr based chemical conversion coating was developed for improving the corrosion resistance of electrogalvanized steel using fluotitanate acid, fluozirconate acid and hydrofluoric acid, etc. The surface morphology was investigated by SEM. Coating composition was analyzed using XPS and FTIR. EIS and potentiodynamic polarization curves were used to evaluate the corrosion behavior. The results showed that the conversion coating was compact with the thickness of about 500 nm, and had a uniform amorphous composition that consisted of nanoscale complicated oxides or hydroxides and zinc fluorides. The Ti/Zr based conversion coating exhibited a relatively better protection for the electrogalvanized steel because the corrosion current (I(corr)) was about two orders of magnitude lower than the zinc coating substrate. EIS results indicated that the corrosion reaction of the prepared conversion coating was mixed-controlled by charge transition and diffusion charge during its three corrosion stages.
关键词:
Non-chromium;Ti/Zr based conversion coating;nanoscale;Corrosion;resistance;Electrogalvanized steel;galvanized steel;magnesium alloys;ti-o;xps;behavior;films;surface;silane;nanoparticles;deposition
