CUI Chengsong
,
FAN Hongbo
,
SHEN Jun
,
JIANG Zuling
,
LI Qingchun(Department of Metallic Materials and Technology
,
Harbin Institute of Technology
,
Harbin 150001
,
China) Manuscript received 26 May 1995
金属学报(英文版)
Al-3.8Li-0.8Mg-0.4Cu-0.13Zr alloy was prepared by a novel spray deposition technique,and its microstructure and tensile properties after various aging treatments have been investigated. The experimental results show that the alloy,under study has very fine equiaxed grains about 5-20μm in diameter and a relative density of(94±3)% on average.Grains in the as-extruded alloy are"brick-like"in morphology,and few oxide particles have been found al the grain boundaries.δ' particles with irregular shape and"δ'-β'"coprecipitates appear in the aged alloy.The coarsening of δ'particles is fast,and the distance between the particles does not widen so obviously as that of IM(ingot-casting method) alloys with increasing aging time.The spray deposited Al-Li alloy.reaches the peak-aged condition in a short time(10 h al 190℃) when the best properties(σb=534 MPa, σ0.2=480 MPa.δ=10%) are obtained.Compared with RSPM(rapid solidification processing method)Al-Li alloy,the ductility of the tested alloy has been obviously.enhanced while a comparable tensile strength is maintained.
关键词:
:spray deposition
,
null
,
null
,
null
,
null
WU Chuansong
,
CAO Zhenning
,
WU Lin Harbin Institute of Technology
,
Harbin
,
China
金属学报(英文版)
A model is established to analyze three-dimensional fluid flow and heat transfer in TICweld pools with full penetration.It considers the deformation of the molten pool surfaceat the condition of full penetrated workpieees,takes the are pressure as the drivingforce of the pool surface deformation,and determines the surface configuration of weldpool based on the dynamic balance of arc pressure,pool gravity and surface tension atdeformed weld pool surface. The SIMPLER algorithm is used to calculate the fluid flowfield and temperature distribution in TIG weld pools of stainless steel workpieces.TIGwelding experiments are made to verify the validity of the model.It shows the calculatedresults by the model are in good agreement with experimental measurements. professor,Dept of Welding Engineering,Harbin Institute of Technology,Harbin 150006,China
关键词:
KEY WORDS TIG weld pool
,
null
,
null
,
null
,
null
