JIANG Hai-bing
,
ZHANG Jian-liang
,
FU Jian-xun
,
CHANG Jian
,
LI Jing
钢铁研究学报(英文版)
The properties of mixed coals were studied on the basis of known various properties of the injecting coals in the treatise. The structure of the injecting coals was optimized and put into practical application. It was found that the ignition point was lowered with mixed coals, however, both combustibility and grindability were improved, and explosibility of the mixed coals were decreased as well. Hence, mixed coals injection not only can improve the amount of the injecting coals greatly, but also improve the economical and technical indexes of the blast furnace.
关键词:
blast furnace
,
pulverized coal
,
property
,
injection
FU Jian-xun
,
LI Jing-she
钢铁研究学报(英文版)
The broadening of slab was investigated on the basis of several industrial manufactures of continuous casting. The results show that slab broadening commonly exists in the process of continuous casting. It is found that there are few reports on it until now. In order to find out the reasons of slab broadening, we checked the effect of change of mold size, excepting technological parameters, conditions of soft reduction, and contraction of roll gap on slab broadening. Our examinations exclude the possibility of change of mold size, excepting technological parameters to be the causes of broadening of slab. The broadening of slab probably results from the static pressure of molten steel and the force from driving rolls. At the same time, online observations on three kinds of steel in the process of continuous casting reveal that the average objective ratio of slab broadening ranges from 1.27 % to 3.00 %, and even arrives at 4.4 %. In addition, the width of mold and formulas of calculating the broadening of slab was deduced.
关键词:
continuous casting;slab;broadening;industrial investigation
万小峰
,
张久兴
,
周文元
,
李湘波
,
周美玲
稀有金属材料与工程
研究了FU105大功率广播发射管用碳化镧钼阴极,参照碳化钍钨阴极FU105管的制备工艺,实现了镧钼阴极的碳化以及镧钼阴极FU105管的排气和老炼.通过镧钼阴极FU105管的性能测试,对碳化镧钼阴极的发射能力和稳定性进行了分析.结果认为:FU105管碳化镧钼阴极的发射能力可以达到碳化钍钨阴极的水平,但其稳定性还有待改进.
关键词:
镧钼阴极
,
FU105发射管
,
碳化
,
稀土
钟文远
,
崔永春
,
范春兰
,
胡智兴
,
李玛琳
贵金属
doi:10.3969/j.issn.1004-0676.2004.02.005
为寻求高效低毒的新型顺铂类抗肿瘤药物,用K2PtCl4、乙二胺(en)、氟尿嘧啶(5-Fu)为原料,设计合成了顺铂类似物[pt(en)(5-Fu)2]C12配合物,由元素分析、红外光谱和质谱分析初步证实了其化学结构,用改良MTT、SRB法,选用K562、A549、Bel-7402、BIU-87、Bcap-37细胞株对其进行体外抗肿瘤活性测定.结果表明,所合成的配合物除在浓度为0.01、0.1 μg/mL时对K562细胞株抗肿瘤活性大于顺铂和氟尿嘧啶外,其它情况下的抗肿瘤活性均小于顺铂和氟尿嘧啶.该配合物仍有进一步研究的价值.
关键词:
药学
,
铂(Ⅱ)配合物
,
合成
,
抗肿瘤活性
于跃芹
,
常宪智
,
田红杰
,
许洋
高分子材料科学与工程
选用牛血清蛋白(BSA)和5-氟尿嘧啶(5-FU)为模型药物,以聚天冬氨酸交联温敏性水凝胶为载体材料,采用包埋法制备了载药水凝胶,研究了水凝胶的载药和释药性能.水凝胶对BSA和5-FU的包埋率均大于98%.37℃时,水凝胶中丙烯酸用量越大,BSA的释放率越低;交联剂用量对BSA的释放率无显著影响.25℃时,丙烯酸用量越大,5-FU的释放率越大;交联剂用量越大,5-FU的释放率越小.37℃时,丙烯酸用量越小,5-FU的释放率越大;交联剂用量越大,5-FU的释放率越小.
关键词:
温敏性水凝胶
,
药物缓释
,
5-氟尿嘧啶
,
牛血清蛋白
李和平
,
肖华伍
,
肖子丹
,
阮建明
高分子材料科学与工程
采用交联-聚合法在超声波的作用下,制备了磁性壳聚糖-5-氟尿嘧啶纳米粒(MCN-Fu).透射电子显微镜(TEM) 和红外光谱(IR)等分析结果表明,MCN-Fu粒子外形规整,分散性好,粒径主要在50 nm～60 nm 之间.紫外-可见光谱分析结果表明,MCN-Fu的载药量为21.3%,在磷酸盐缓冲溶液(pH=7.2)中,30 h的累积释药率为67.6%,具有良好缓释性能,并具有良好磁响应性能.
关键词:
磁性
,
壳聚糖
,
氟尿嘧啶
,
纳米粒
,
药物缓释剂
徐菊良
,
邓博
,
孙涛
,
李劲
,
蒋益明
金属学报
doi:10.3724/SP.J.1037.2009.00598
利用Thermo-Calc软件并结合金相显微镜,定性研究了2205双相不锈钢在800℃下敏化不同时间后的微观组织演变过程.通过研究扫描速率、介质成分、介质温度和试样表面状态优化了双环电化学动电位再活化法(DL-EPR),并用该优化方法研究了2205双相不锈钢晶间腐蚀敏感性.结果表明:DL-EPR法能定量评价σ相对2205双相不锈钢晶间腐蚀敏感性的影响,随敏化时间延长,σ相含量增多,晶jian 腐蚀敏感性也随之增加.腐蚀形貌的观测验证了这一规律,
关键词:
2205双相不锈钢
,
DL-EPR
,
晶间腐蚀敏感性
,
σ相
李航
,
袁华
,
仲谦
,
任杰
功能材料
以PLA为载体材料,以5-Fu为模型药物,制备5-Fu/PLA载药微球,通过正交设计优化微球制备工艺.另外,检测了载药微球的回收率、稳定性、缓释性能等物理性质.用紫外分光光度计测定药物含量,激光粒度仪分析粒径. 结果表明,载药微球的平均粒径为(133.2±32.5)nm,平均包封率为(11.3±5.0)%,缓释时间延长至80～100h,具有良好的缓释功能.
关键词:
正交试验法
,
聚乳酸
,
溶剂挥发法
,
体外缓释
吴粦华
,
阮艺斌
,
李爱芳
,
江云宝
功能材料
设计合成了荧光传感分子α-呋喃甲醛缩对苯二甲酰腙(p-PB-Fu),采用1H NMR对其结构进行了表征,应用吸收和荧光光谱初步探讨了在乙腈中其对Cu2+的响应.结果表明,p-PB-Fu与Cu2+存在两个结合过程,首先是其与Cu2+以2:1的方式形成普通配合物;而随着Cu2+的继续加入,所形成的配合物之间通过自簇集而形成金属配位聚合物/寡聚物.光谱数据初步表明后者对Cu2+具有较高的识别选择性.
关键词:
酰腙
,
铜离子
,
荧光传感
,
配位聚合物/寡聚物
