WANG Xiao-nan
,
DI Hong-shuang
,
ZHANG Chi
,
DU Lin-xiu
,
DONG Xue-xin
钢铁研究学报(英文版)
CO2-shielded welding experiments of newly developed, 780 MPa super-high strength heavy-duty truck crossbeam steel were conducted, and the microstructure, microhardness, mechanical properties, and impact toughness of the welded joint were studied. The evolution of the microstructure of the welded joint occurred as follows: welding seam (acicular ferrite+proeutectoid ferrite)→fusion zone (granular bainite-long strip M/A island)→coarse grain zone (granular bainite-long strip or short bar M/A island)→fine grain zone (ferrite+pearlite+blocky M/A island)→mixed grained zone (ferrite+granular bainite+blocky M/A island)→base metal (proeutectoid ferrite+granular bainite-blocky or granular M/A island). Increasing the density of the grain boundaries can effectively improve the impact toughness, and the blocky M/A island hindered crack propagation more effectively than the long strip M/A island. The new hot-rolled 780 MPa super-high strength steel had excellent weldability. The welding technology was applied under the following conditions: welding voltage was 20 to 21 V, welding current was 200 to 210 A, and the gas flow rate was 25 L/min.
关键词:
super-high strength steel
,
crossbeam steel
,
weldability
,
M/A island
,
impact toughness
常永勤
,
介万奇
,
郭喜平
,
陈福义
,
安卫军
功能材料
研究了ACRT-B法生长的Mn0.1Cd0.9In2Te4晶体中界面的形状和各组元沿轴向的分布规律及其分凝因数.发现结晶界面为椭球形;采用理想配比生长MnxCd1-xIn2Te4晶体,其4种组元并不按(Mn,Cd):In:Te=1:2:4比例结晶,而是要重新分布;通过数学方法处理实验数据得到Mn,Cd和In的分凝因数在α相区分别为1.286、1.9257和0.7294,在β相区则分别为1.12、1.055和0.985.
关键词:
ACRT-B法
,
MnxCd1-x In2Te4
,
界面
,
分凝因数
常永勤
,
安卫军
,
郭喜平
,
介万奇
无机材料学报
采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mn0.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里-外斯定律,在低温区(<50K)则表现出顺磁增强现象.
关键词:
MnxCd1-xIn2Te4
,
compositional distribution
,
infrared transmission spectra
,
mag- netic susceptibility
常永勤
,
安卫军
,
郭喜平
,
介万奇
无机材料学报
doi:10.3321/j.issn:1000-324X.2003.02.004
采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mno.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里一外斯定律,在低温区(＜50K)则表现出顺磁增强现象.
关键词:
MnxCd1-xIn2Te4
,
成分偏析
,
红外透射光谱
,
磁化率
常永勤
,
安卫军
,
郭喜平
,
介万奇
功能材料
采用Bridgman法生长四元稀磁化合物半导体Mn0.22Cd0.78In2Te4晶体.当晶体生长到预定长度时,淬火得到固液界面.采用光学显微镜、扫描电镜、X射线衍射仪、ISIS能谱仪以及Leica定量金相分析仪研究了晶体中出现的界面形态、相的形貌和数量以及沿生长方向的相析出规律,并进行了相成分分析.研究发现,淬火得到的Mn0.22 Cd0.78In2Te4晶体中存在两个界面,其中一个为固液相变界面,另一个为由α+β两相区发展到单相β区时的转变界面,二者相对于生长初始端均为凹形;α+β两相区中,β相以条状、花状和近似圆片状形式存在,其中条状β相多分布在晶界处;越接近生长初始端,花状和近似圆片状β相越小,条状β相越细,它们的含量越少;X射线衍射图谱表明,β相为黄铜矿结构,α相为面心立方结构.
关键词:
MnxCd1-xIn2Te4
,
相变界面
,
β相
,
X射线衍射图谱
Jing TIAN
,
Xiang XUE
,
Yuebing ZHANG
,
Yalong GAO
,
Luzhi LIU
,
Qin SUN
,
Shiyou YUAN
材料科学技术（英文）
By adopting the solid modeling software SoldEdge and the enmeshment software SRIFCast as the pre-processing platform, a Ni based alloy turbine blade was three-dimensionally modeled and automatically enmeshed. A software code for numerical simulation of fluid flow and heat transfer was developed. The Xue criterion and Niyama criterion were used to predict the position of the shrinkage defects occurring in the solidification processes of the turbine blade. The results showed that both Xue and Niyama criteria could precisely predict the shrinkage defects in the Ni based alloy turbine blade. This indicates that numerical simulation is a significant tool in improving casting quality.
关键词:
Farook ADAM*, Kei Lin SEK
催化学报
doi:10.1016/S1872-2067(11)60453-1
Indium incorporated silica samples with different indium contents were synthesized using a template free sol-gel method. The silica used was extracted from rice husk (RH) and the resulting catalyst was labeled as RH-xIn (x=5%,10%,15%, and 20%). From the N2 adsorption analysis the presence of type IV isotherm in RH-blank and RH-xIn indicated the mesoporous nature of the catalysts. In the XRD pattern, a broad band at ca.2θ=25° was observed for all the catalysts which showed them to be amorphous. TEM micrographs revealed that the material is composed of nanoparticles. Friedel-Craft benzoylation of toluene was carried out using the RH-xIn catalyst. The optimum conditions for the benzoylation of toluene were determined and at 373 K,100%conversion and 89%selectivity for the para-product (i.e.4-methylbenzophenone) were obtained.
关键词:
rice husk
,
sol-gel
,
indium
,
Friedel-Craft benzoylation
,
Toluene
Physical Review B
In a recent publication [S. Dong et al., Phys. Rev. Lett. 103, 127201 (2009)], two (related) mechanisms were proposed to understand the intrinsic exchange bias present in oxides heterostructures involving G-type antiferromagnetic perovskites. The first mechanism is driven by the Dzyaloshinskii-Moriya interaction, which is a spin-orbit coupling effect. The second is induced by the ferroelectric polarization, and it is only active in heterostructures involving multiferroics. Using the SrRuO(3)/SrMnO(3) superlattice as a model system, density-functional calculations are here performed to verify the two proposals. This proof-of-principle calculation provides convincing evidence that qualitatively supports both proposals.
关键词:
thin-films;weak ferromagnetism;superlattices;anisotropy;bifeo3;srruo3;model
