材料期刊网

Development of Continuous Casting Technology of Electrical Steel and New Products

WANG Li-tao , DENG Chen-hong , DONG Mei , SHI Li-fa , ZHANG Jian-ping

钢铁研究学报(英文版)

The development of continuous casting technology of electrical steel was analyzed. The technologies and products characteristics of conventional continuous casting, thin slab continuous casting and rolling, middle thin slab continuous casting and rolling and twin-roll thin strip were compared. Conventional continuous casting technology was widely adopted in producing electrical steel; thin slab continuous casting and rolling and middle thin slab continuous casting and rolling technology industrialized electrical steel; and study of twin-roll thin strip casting technology was focused on fundamental experiments.

关键词: electrical steel , thin slab continuous casting and rolling , middle thin slab continuous casting and rolling , twin-roll thin strip

Chen系统的状态变量周期性反馈控制

李开明 , 李亚洲 , 冯维贵 , 林长

量子电子学报 doi:10.3969/j.issn.1007-5461.2007.05.014

采用非线性反馈控制,用附加了带参数的正弦项对Chen系统进行了有效的控制.随着参数k的逐渐增大,系统的动力学行为呈现出一系列的变化.数值研究结果表明:随控制参数的增大,驱动信号的强度渐大,混沌系统由混沌运动到周期轨道,最终到一相点.

关键词: 混沌 , Chen系统 , 不动点 , Lyapunov指数 , 反馈控制

SIF expressions for center cracked strip loaded by uniformly distributed stress acting on central portion of crack - Corrections of Chen's results - Response

International Journal of Fracture

关键词:

Preface to Special Issue on Photocatalysis for celebrating the 20th anniversary of Professor Jimmy C. Yu’s return to Hong Kong and leading photocatalytic research there

催化学报 doi:10.1016/S1872-2067(15)61006-3

关键词:

Ion sputter erosion in metallic glass-A response to "Comment on: Homogeneity of Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass" by L-Y. Chen, Y-W. Zeng, Q-P. Cao, B-J. Park, Y-M. Chen, K. Hono, U. Vainio, Z-L. Zhang, U. Kaiser, X-D. Wang, and J-Z Jiang J. Mater. Res. 24, 3116 (2009)

Journal of Materials Research

The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.

关键词: room-temperature

工艺因素对319铝合金热分析特征值的影响

佟媛媛 , 华勤

上海金属 doi:10.3969/j.issn.1001-7208.2010.03.011

运用热分析技术研究了冷却曲线特征值与319铝合金中化学成分之间的关系,并进行回归分析.结果表明,在不考虑工艺因素的情况下,试样的硅含量与α-Al枝晶生长回升温度TαDENG之间的相关性最大,相关系数r为-0.65,以硅含量可预测α-Al枝晶生长回升温度.在浇注过程中,冷却速度与α-Al枝晶生长回升温度TαDENG密切相关,相关系数为r=-0.72.在相同的冷却条件下,铝合金的浇注温度和浇注量对冷却速度有明显的影响,因此,可以通过调整浇注温度和浇注量,控制铝合金的冷却速度,进而也可预测铝合金中α-Al枝晶生长回升温度TαDENG.

关键词: 319铝合金 , 热分析 , 特征值 , 浇注工艺

第27卷B辑作者索引

金属学报

Volu扣ne 27SeriesB1991AUTHOR INDEX CCAO Guanghan(曹光旱)············……6一B科6CAo weijie(曹卫恋)..················……5一B32oCAO Yilin(曹益林)··················……6一B443CHANG Xin(常听)···············……1一B48CHE Guang邻n(车广灿)·············一6一B科0CHEN Erbao(陈二保)···············……6一B410CHEN Jia....

关键词:

基于二氧化碳封存的超临界两相流动的数值研究

高诚 , 胥蕊娜 , 陈黎 , 姜培学

工程热物理学报

格子Boltzmann方法(LBM)在计算复杂结构物理模型时具有独特优势并在模拟两相流动过程中能够高效清晰捕捉相界面.本文介绍了基于Shan-Chen多相模型的格子Boltzmann方法的理论成果以及基于二氧化碳封存的超临界两相流的模拟研究.结果表明,Shan-Chen模型在模拟两相流时符合Laplace定律,且两相层流时的速度分布和相渗曲线均与理论值吻合.二氧化碳封存过程中,较大的注入速率在提高二氧化碳残余俘获量的同时会降低其化学俘获量.

关键词: 二氧化碳封存 , 超临界两相流 , Shan-Chen模型

Bulk and surface half-metallicity: Metastable zinc-blende TiSb

Journal of Applied Physics

Motivated by the recent experimental fabrication of half-metallic MnSb and CrSb thin films with metastable zinc-blende structure [Aldous et al. Phys. Rev. B 85, 060403(R) (2012); Deng et al. J. Appl. Phys. 99, 093902 (2006)], we investigate the structural, electronic, and magnetic properties of TiSb in both ground-state NiAs and metastable zinc-blende phases by using the first-principles calculations. It is shown that the ground-state NiAs phase is metallic and nonmagnetic, but the metastable zinc-blende phase exhibits half-metallic ferromagnetism with a magnetic moment of 1.00 mu(B) per formula unit. We also reveal that the half-metallicity in bulk ZB TiSb is lost at the Sb-terminated (001) surface due to the appearance of surface states within the gap of the minority-spin channel, but the Ti-terminated (001) surface retains the bulk half-metallicity, which makes ZB TiSb a promising candidate for the possible epitaxial growth of half-metallic thin films or multilayers on semiconductor substrates for spintronic applications. (C) 2012 American Institute of Physics. [http://dx.doi.org/10.1063/1.4739744]

关键词: room-temperature ferromagnetism;molecular-beam epitaxy;crsb;cras;spintronics;state;mnas

A molecular dynamics study of the structural change differences between Au-225 and Au-369 clusters on MgO surfaces at low temperature

Chinese Physics B

The differences in structural change between Au-225 and Au-369 clusters with their (111) facets supported on MgO(100) surfaces at 5 K are studied by using molecular-dynamics simulations with the atomic interchange potentials of the Au/MgO interface. The parameters are obtained from the ab initio energies using the Chen-Mobius inversion method. Analyses of the pair distribution functions show that the two Au clusters use different deformation processes to adjust the distances between the interface atoms, owing to the misfit between the atom distances among the clusters and the substrates. The local structural changes are identified by atomic density profiles.

关键词: interfaces;nanostructures;computer modelling and simulation;molecular;dynamics;local-structure changes;mgo(001) surface;au;adsorption;cu;nanoclusters;dimers;models;ag