材料期刊网

INFLUENCE OF AUSTENITE STRENGTHENING ON MARTENSITIC TRANSFORMATION IN Fe-Mn-C ALLOYS

PAN Mu XU Zuyao (T.Y.Hsu) Shanghai Jiaotong University , Shanghai , China XU Zuy(T.Y.Hsu) , Professor , Dept.of Materials Science , Shanghai Jiaotong University , Huashan Road , Shanghai 200030 , China

金属学报(英文版)

The M_s temperature and the yield strength of austenite at M_s temperature have been meas- ured for five Fe-Mn-C alloys.The experimental results show that there is a linear relation- ship between them.The effect of the solution strengthening of austenite on martensite morphology is also studied.It is pointed out that there is a characteristic temperature T_c in austenite strengthening.Martensite morphology is mainly of dislocated laths when M_s>T_c, and is mainly of twinned plates when M_s<T_c.A theoretical analysis is given which is in good agreement with experimental results.

关键词: Fe-Mn-C alloy , null , null

基于(火积)耗散率最小的T-Y形肋片构形优化

冯辉君 , 陈林根 , 谢志辉 , 孙丰瑞

工程热物理学报

基于构形理论,以导热和对流换热总(火积)耗散率最小为优化目标,对T-Y形肋片进行构形优化,得到同时考虑导热和对流换热(火积)耗散性能的T-Y形肋片最优构形.结果表明:存在最佳单元级直肋和中部空腔高度和长度比使得T-Y形肋片无量纲当量热阻取得二次最小值.增大肋片高度和长度比和肋片占比有助于提高T-Y形肋片整体传热性能.T-Y形肋片与T形肋片相比,T-Y形肋片二次最小无量纲当量热阻降低32.33％,此时T-Y形肋片温度梯度场更均匀,整体传热性能得到明显提高.

关键词: 构形理论 , (火积)耗散率最小 , T-Y形肋片 , 对流换热 , 广义热力学优化

Further development of NdFeB magnet industry in China

Yang LUO

材料科学技术（英文）

Due to continued growth in key markets, a broadening of application base and performance improvements, the market demands of NdFeB magnet increased steadily in 1998, and the global output of sintered NdFeB magnet exceeded 10,000 t, in spite of the economic recession in Asia. In 1998 China produced 3,850 t sintered NdFeB block magnet, with an annual growth rate of +22% over the output in 1997.

关键词:

Introduction to atmospheric corrosion research in China

Science and Technology of Advanced Materials

In this paper, we introduce the research on atmospheric corrosion in China. We describe the climate characteristics and the classification of atmospheric corrosivity across the whole country. We also describe the rusting evolution under simulated wet/dry cyclic conditions. (C) 2007 NIMS and Elsevier Ltd. All rights reserved.

关键词: atmospheric corrosion;corrosivity;rusting evolution;weathering steels;rust;mechanism;so2;o-3;no2

Recent Advances of Laser Coating Technology in China

LIANG Yong LI Ruiguo Institute of Metal Research , Academia Sinica , Shenyang 110015 , ChinaInstitute of Corrosion and Protection of Metals , Aademia Sinica , Shenyang , 110015 , China

材料科学技术（英文）

Recent advances in laser coating technology including laser cladding,laser surface alloying and laser vapour deposition in China are reviewed in this paper.

关键词: laser , null , null , null , null

AA6061-T6铝合金表面纳米Y2 O3改性硅烷膜的耐蚀性

张明明 , 李文超 , 张圣麟

腐蚀与防护

采用动电位极化曲线，电化学阻抗谱（EIS）和中性盐雾试验（NSS）研究了溶液中加入不同含量纳米Y2 O3对铝合金AA6061-T6表面硅烷膜耐蚀性的影响，采用扫描电镜（SEM）对其形貌进行了观察。结果表明，在1，2-双-三乙氧基硅烷（BTSE）溶液中加入少量纳米Y2 O3可提高硅烷膜在3．5％ NaCl溶液中的耐蚀性。硅烷膜对铝合金的保护只起到物理屏障作用。纳米Y2 O3抑制了电化学腐蚀过程中阴极还原反应的发生，但不影响电极反应的动力特征。SEM表明在BTSE硅烷溶液中添加10～20 mg/L的纳米Y2 O3后，硅烷膜表面变得平滑致密。

关键词: 硅烷膜 , 纳米Y2 O3 , 耐蚀性能 , 铝合金

Development of Cast Superalloys for Gas Turbines in China

CHEN Rongzhang CHEN Wanhua Institute of Aeronautic Materials , Beijing 100095 , China.

材料科学技术（英文）

As in other countries,significant achievements in the research of cast superalloys for many years have also been obtained in China.These results are important contribu- tion to the development of aero and land-based gas tur- bine engines.

关键词: cast superalloy , null

纳米Y2O3预处理对T91钢抗高温水蒸汽氧化的影响

刘光明 , 张都清 , 任善平

表面技术 doi:10.16490/j.cnki.issn.1001-3660.2015.12.017

目的 研究纳米Y2 O3 预处理对T91钢抗水蒸汽氧化性能的影响,分析稀土元素作用的机理及长期氧化后的失效机制. 方法 采用将Y2 O3、铝粉、粘结剂制备成料浆涂覆于T91钢表面,并在720 ℃水蒸汽中预处理48 h. 预处理样品和空白样品同时置于在700 ℃高温水蒸汽中氧化,获取循环氧化动力学曲线并进行对比,检验预处理对提高材料抗高温水蒸汽腐蚀的效果. 对氧化的样品采用XRD、SEM/EDS对氧化物结构、形貌、成分进行分析. 结果 预处理后在样品表面形成了含Y2 O3 的富铬氧化物薄膜. 在高温水蒸汽环境的氧化过程中,试样处理600 h时,质量增加轻微,仅为0. 152 g/cm2. 但在600 h后质量增加明显,预处理膜层逐渐退化,表面出现Fe2 O3 突出物. 空白样在腐蚀初期即明显增加,氧化70 h后,质量增加达12. 17 mg/cm2 ,氧化过程中可见氧化产物的剥落,氧化膜附着力差. 结论 纳米Y2 O3预处理可提高T91钢抗水蒸汽氧化性能,但随着氧化时间延长,富铬氧化膜将逐渐退化.

关键词: 纳米Y2O3 , T91钢 , 预处理 , 水蒸汽 , 高温氧化 , 富铬氧化膜

R&D STATUS ON INTERMETALLICS IN CHINA

CHEN Guoliang(State Key Laboratory for Advanced Metals and Materials University of Science and Technology Beijing Beijing 100083 , China)SHI Changxu (Academia Sinica , Beijing 100864 , China)

金属学报(英文版)

This paper briefiy introduces the R&D of intermetallics in China. R&D on intermetallics in a national scale in China began near ten years ago. The investigation in past years focused on the fundamental research and materials development. A significant progress has been made. Various components that made of Ti3Al Ni3Al, TiAl and Fe3Al have been successfully manufactured Some of them have been evaluted. It is expected that some intermetallic alloys will be produced in an industrial scale in the near future.

关键词: :intermetallic alloys , null , null , null

Mg-9Gd-4Y-0.6Zr合金挤压T5态的高温组织与力学性能

肖阳 , 张新明 , 陈健美 , 蒋浩

中国有色金属学报

研究了Mg-9Gd-4Y-0.6Zr合金挤压T5态在250～400℃之间的高温组织与力学性能. 结果表明:该合金具有非常优异的高温力学性能,其力学性能明显优于WE54;该合金在250、300、350和400℃时的抗拉伸强度分别为348、262、150和62MPa;该合金在400℃拉伸时还具有粗晶超塑性,晶界上有再结晶的细晶,晶内有大量孪晶同时共存.

关键词: Mg-Gd-Y-Zr合金 , 耐热镁合金 , 高温力学性能 , T5态 , 粗晶超塑性