材料期刊网，材料期刊，材料类期刊，材料期刊投稿

Jian ZHANG/Langhong Lou

关键词:

Effect of Withdrawal Rates on Microstructure and Creep Strength of a Single Crystal Superalloy Processed by LMC

Chengbao Liu Jian Shen Jian Zhang Langhong Lou

A nickel base single crystal (SC) superalloy was directionally solidified using liquid metal cooling (LMC) process at various withdrawal rates. The microstructure was refined as increasing the withdrawal rate from 3 to 12 mm/min. However, higher withdrawal rate of 15 mm/min induced the formation of stray grains. Size and volume fraction of the eutectics were found to decrease with the increasing in withdrawal rate. After solution heat treatment at 1250°C, un-dissolved eutectic was observed in specimens. High temperature creep rupture life was observed to be very sensitive to the fraction of these remaining eutectics. Creep rupture tests at 1000°C/235 MPa showed that refined microstructure and low fraction of the remaining eutectic lead to significant improvement of the rupture life.

关键词: Eutectic , single crystal superalloy , liquid-metal-cooling , withdrawal rate

DL-EPR法评价2205双相不锈钢晶间腐蚀敏感性

徐菊良 , 邓博 , 孙涛 , 李劲 , 蒋益明

金属学报 doi:10.3724/SP.J.1037.2009.00598

利用Thermo-Calc软件并结合金相显微镜,定性研究了2205双相不锈钢在800℃下敏化不同时间后的微观组织演变过程.通过研究扫描速率、介质成分、介质温度和试样表面状态优化了双环电化学动电位再活化法(DL-EPR),并用该优化方法研究了2205双相不锈钢晶间腐蚀敏感性.结果表明:DL-EPR法能定量评价σ相对2205双相不锈钢晶间腐蚀敏感性的影响,随敏化时间延长,σ相含量增多,晶jian 腐蚀敏感性也随之增加.腐蚀形貌的观测验证了这一规律,

关键词: 2205双相不锈钢 , DL-EPR , 晶间腐蚀敏感性 , σ相

Ion sputter erosion in metallic glass-A response to "Comment on: Homogeneity of Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass" by L-Y. Chen, Y-W. Zeng, Q-P. Cao, B-J. Park, Y-M. Chen, K. Hono, U. Vainio, Z-L. Zhang, U. Kaiser, X-D. Wang, and J-Z Jiang J. Mater. Res. 24, 3116 (2009)

Journal of Materials Research

The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.

关键词: room-temperature

复合材料层合壳体的三维本构方程

杨宜谦

玻璃钢/复合材料 doi:10.3969/j.issn.1003-0999.1999.04.002

本文推导出了复合材料层合壳体的三维本构方程,修正了Reddy和Liu论文中的错误.

关键词: 复合材料 , 壳体 , 三维本构方程

Broer-Kaup-Kupershmidt方程的新精确解

杨立娟 , 杨琼芬 , 杜先云

量子电子学报 doi:10.3969/j.issn.1007-5461.2012.02.003

CK方法是求解非线性发展方程的一种有效的直接方法.利用推广的CK方法,求得(2+1)维Broer-Kaup-Kupershmidt方程的Backlund公式,从而获得方程的大量新的精确解,推广了Xu和Zhang的结果.

关键词: 非线性发展方程 , Broer-Kaup-Kupershmidt方程 , 精确解 , CK方法 , Backlund变换

Three-dimensional (3D) Ising universality in magnets and critical indices at fluid-fluid phase transition

Phase Transitions

Experimental data for critical exponents in some magnetic materials are compared with recent theoretical results on the three-dimensional (3D) Ising model, as derived by one of us (ZDZ) based on two conjectures [Z.D. Zhang, Conjectures on the exact solution of three-dimensional (3D) simple orthorhombic Ising lattices, Phil. Mag. 87 (2007), pp. 5309-5419]. It is found that critical exponents in some bulk magnetic materials indeed form a 3D Ising universality. Our attention is then focused on the critical indices at fluid-fluid phase transition. We suggest to use Zhang's exponent = 3/8 to fit the experimental data over the wider asymptotic region near the critical point of a fluid-fluid phase transition. The 3D Ising universality should exist for critical indices in a certain class of magnets and at fluid-fluid phase transition.

关键词: magnetically ordered materials;fluid-fluid;phase transitions;order-disorder effects;ferromagnetic curie temperature;liquid critical phenomena;x-ray-scattering;critical exponents;critical-point;coexistence;curves;binary-solutions;ionic-solutions;behavior;equation

Response to the Comment on 'Conjectures on exact solution of three-dimensional (3D) simple orthorhombic Ising lattices'

Philosophical Magazine

The error of Equation (15b) in my article [Z.D. Zhang, Phil. Mag. 87 (2007) p.5309] in the application of the Jordan-Wigner transformation does not affect the validity of the putative exact solution, since the solution is not derived directly from that equation. Other objections of Perk's comment [J.H.H. Perk, Phil. Mag. 89 (2009) p.761] are the same as those in Wu et al.'s comments [F.Y. Wu et al., Phil. Mag. 88 (2008) p.3093; p.3103], which do not stand on solid ground and which I have sought to refute in my previous response [Z.D. Zhang, Phil. Mag. 88 (2008) p.3097]. The conjectured solution can be utilized to understand critical phenomena in various systems, whereas the conjectures are open to rigorous proof.

关键词: 3D Ising model;exact solution;conjecture;critical phenomena;ferromagnetism;magnetic phase transition;model;analyticity

聚醛/蒙脱土纳米复合材料非等温结晶动力学研究

徐卫兵 , 戈明亮 , 何平笙

应用化学 doi:10.3969/j.issn.1000-0518.2001.09.011

用熔融插层法制备聚甲醛/蒙脱土纳米复合材料,用X射线衍射研究聚甲醛及复合材料的微观结构,表明复合材料是纳米复合材料.用DSC法研究其非等温结晶行为,对所得数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚甲醛及聚甲醛/有机蒙脱土纳米复合材料的结晶活化能分别为334.6和196.9 kJ/mol,说明有机蒙脱土的加入,降低了聚甲醛的结晶活化能,且t1/z缩短,起到了异相成核的作用.

关键词: 聚甲醛 , 蒙脱土 , 纳米复合材料 , 非等温结晶动力学

聚丙烯/凹凸棒土纳米复合材料的非等温结晶动力学

王平华 , 徐国永

应用化学 doi:10.3969/j.issn.1000-0518.2004.08.007

用熔融复合法制备聚丙烯/凹凸棒土纳米复合材料,用DSC法研究其非等温结晶行为,对所得的数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚丙烯及聚丙烯/凹凸棒土纳米复合材料的结晶活化能分别为194.1和162.8 kJ/mol,表明凹凸棒土的加入,降低了聚丙烯的结晶活化能,且t1/2缩短,起到了异相成核作用.

关键词: 聚丙烯 , 凹凸棒土 , 纳米复合材料 , 非等温结晶动力学

材料期刊网