TIAN Hong-yu
,
CHEN Fu-rong
,
XIE Rui-jun
,
et al>
钢铁研究学报(英文版)
Hot-metal ladle is an important part in continuous casting production line and its stress distribution has direct influence on its life. In the process of design and calibration of the large sized hot-metal ladle, it’s of great significance to determine the stress distribution of each part of the ladle for safely and reliably running the device. Based on 100t hot-metal ladle which is designed by Baotou Iron & Steel Group, a simulation of stress field was made by finite element software ANSYS 10.0 in the different dumping angles. Through modeling, loading, restricting and calculating, strain and stress field distribution of the hot-metal ladle were acquired. Finally, an assessment of strength and stiffness was made on the hot-metal ladle. The results show that in the process of tipping for the hot-metal ladle, maximum stress is 137MPa, maximum strain is only 0.681‰, maximum stress and strain have appeared in the stiffener plate which is located at the bottom of the trunnion, and strength and stiffness are qualified. The method which is convenient and practical, reasonable and reliable provides theoretical evidence for checking analysis and further optimal design of the hot-metal ladle.
关键词:
hot-metal ladle;stress field;finite element analysis
万小峰
,
张久兴
,
周文元
,
李湘波
,
周美玲
稀有金属材料与工程
研究了FU105大功率广播发射管用碳化镧钼阴极,参照碳化钍钨阴极FU105管的制备工艺,实现了镧钼阴极的碳化以及镧钼阴极FU105管的排气和老炼.通过镧钼阴极FU105管的性能测试,对碳化镧钼阴极的发射能力和稳定性进行了分析.结果认为:FU105管碳化镧钼阴极的发射能力可以达到碳化钍钨阴极的水平,但其稳定性还有待改进.
关键词:
镧钼阴极
,
FU105发射管
,
碳化
,
稀土
李开明
,
李亚洲
,
冯维贵
,
林长
量子电子学报
doi:10.3969/j.issn.1007-5461.2007.05.014
采用非线性反馈控制,用附加了带参数的正弦项对Chen系统进行了有效的控制.随着参数k的逐渐增大,系统的动力学行为呈现出一系列的变化.数值研究结果表明:随控制参数的增大,驱动信号的强度渐大,混沌系统由混沌运动到周期轨道,最终到一相点.
关键词:
混沌
,
Chen系统
,
不动点
,
Lyapunov指数
,
反馈控制
钟文远
,
崔永春
,
范春兰
,
胡智兴
,
李玛琳
贵金属
doi:10.3969/j.issn.1004-0676.2004.02.005
为寻求高效低毒的新型顺铂类抗肿瘤药物,用K2PtCl4、乙二胺(en)、氟尿嘧啶(5-Fu)为原料,设计合成了顺铂类似物[pt(en)(5-Fu)2]C12配合物,由元素分析、红外光谱和质谱分析初步证实了其化学结构,用改良MTT、SRB法,选用K562、A549、Bel-7402、BIU-87、Bcap-37细胞株对其进行体外抗肿瘤活性测定.结果表明,所合成的配合物除在浓度为0.01、0.1 μg/mL时对K562细胞株抗肿瘤活性大于顺铂和氟尿嘧啶外,其它情况下的抗肿瘤活性均小于顺铂和氟尿嘧啶.该配合物仍有进一步研究的价值.
关键词:
药学
,
铂(Ⅱ)配合物
,
合成
,
抗肿瘤活性
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
于跃芹
,
常宪智
,
田红杰
,
许洋
高分子材料科学与工程
选用牛血清蛋白(BSA)和5-氟尿嘧啶(5-FU)为模型药物,以聚天冬氨酸交联温敏性水凝胶为载体材料,采用包埋法制备了载药水凝胶,研究了水凝胶的载药和释药性能.水凝胶对BSA和5-FU的包埋率均大于98%.37℃时,水凝胶中丙烯酸用量越大,BSA的释放率越低;交联剂用量对BSA的释放率无显著影响.25℃时,丙烯酸用量越大,5-FU的释放率越大;交联剂用量越大,5-FU的释放率越小.37℃时,丙烯酸用量越小,5-FU的释放率越大;交联剂用量越大,5-FU的释放率越小.
关键词:
温敏性水凝胶
,
药物缓释
,
5-氟尿嘧啶
,
牛血清蛋白
李和平
,
肖华伍
,
肖子丹
,
阮建明
高分子材料科学与工程
采用交联-聚合法在超声波的作用下,制备了磁性壳聚糖-5-氟尿嘧啶纳米粒(MCN-Fu).透射电子显微镜(TEM) 和红外光谱(IR)等分析结果表明,MCN-Fu粒子外形规整,分散性好,粒径主要在50 nm～60 nm 之间.紫外-可见光谱分析结果表明,MCN-Fu的载药量为21.3%,在磷酸盐缓冲溶液(pH=7.2)中,30 h的累积释药率为67.6%,具有良好缓释性能,并具有良好磁响应性能.
关键词:
磁性
,
壳聚糖
,
氟尿嘧啶
,
纳米粒
,
药物缓释剂
金属学报
Volu扣ne 27SeriesB1991AUTHOR INDEX CCAO Guanghan(曹光旱)············……6一B科6CAo weijie(曹卫恋)..················……5一B32oCAO Yilin(曹益林)··················……6一B443CHANG Xin(常听)···············……1一B48CHE Guang邻n(车广灿)·············一6一B科0CHEN Erbao(陈二保)···············……6一B410CHEN Jia....
关键词:
李航
,
袁华
,
仲谦
,
任杰
功能材料
以PLA为载体材料,以5-Fu为模型药物,制备5-Fu/PLA载药微球,通过正交设计优化微球制备工艺.另外,检测了载药微球的回收率、稳定性、缓释性能等物理性质.用紫外分光光度计测定药物含量,激光粒度仪分析粒径. 结果表明,载药微球的平均粒径为(133.2±32.5)nm,平均包封率为(11.3±5.0)%,缓释时间延长至80～100h,具有良好的缓释功能.
关键词:
正交试验法
,
聚乳酸
,
溶剂挥发法
,
体外缓释
