CAO Mingzhou
,
HAN Dong
,
ZHOU Jing
,
LI Dong Institute of Metal Research
,
Academia Sinica
,
Shenyang
,
China Associate Professor
,
Institute of Metal Research
,
Academia Sinica
,
Shenyang 110015
,
China
金属学报(英文版)
The microstructure of Ti-33wt-% Al-(1.6-4.5)wt-% Mn alloys are composed of γ+α_2 phases,but the volume of x_2-phase is a little.Mn alloying decreases the lattice parameters a and c of γ-phase and the c/a ratio becomes nearly to one,because the atomic radius of Mn is less than the atomic radius of Ti or Al.Mn alloying promotes the formation of twins in γ-phase and increases the ability of plastic deformation of TiAl alloys at room tem- perature.
关键词:
TiAl alloy
,
null
,
null
,
null
YANG Ke
,
CAO Mingzhou
,
WAN Xiaojing
,
SHI Changxu Institute of Metal Research
,
Academia Sinica
,
Shenyang
,
110015
,
China.
材料科学技术(英文)
The model of hydrogen diffusion formerly de- veloped [1] has been applied successfully to the hydrogen permeation experiment results of three kinds of materials,α—Fe,Fe—Ti alloy and Fe—Ti—C alloy by the mathematical fitting method.From the fitting results it was shown that the model can re- fiect well the diffusion of hydrogen in the materials with trapping.The obtained trapping parameters(α and β)can be used to explain well the diffusion of hydrogen in the samples with trapping.
关键词:
hydrogen diffusion
,
null
,
null
,
null
CAO Mingzhou
,
XIE Yingxiu
,
XU ZengjiInstitute of Metal Research
,
Chinese Academy of Sciences
,
Shenyang. China
金属学报(英文版)
The microstructive and compressive properties of Ti50Al48,Mn2 and Ti50Al48Cr2 alloys are studied in this paper. Existence of x-x+y transformation in TiAl alloys is confirmed by metallographic examination, the transformation temperatures of Ti5()Al48 Mn2 and Ti50Al48Cr2 are 1375 and 1373 C , respectively. After treating within x+y phase field, the microstructure of alloys consists of lamellar zones (I) and bulk rp. The volume ratio of L /rp increases with increasing solution treatment temperature. The third alloying elements of Mn and Cr distribute perferentially over x phase at solution treatment temperatures and result in that x2 and r lamellae become thicker. The yield strength of Ti50Al48Mn2 and Ti50Al48Cr2 alloys decreases and the compressibility increases with increasing rp volume fraction.
关键词:
Ti50Al48Mn2
,
null
,
null
邹元爔
,
赵彭年
,
曹兆民
金属学报
利用石灰的加碳还原反应,设计了一个新的研究方法,以直接测定液态高炉型渣中CaO的活度.这一方法的成功,依靠溶剂金属的正确选择以降低熔液中钙的化学位,而使金属钙量提高到可以用化学分析测定的水平.我们估计钙在锡稀溶液中的活度系数很小,可能符合于我们的要求,因此研究了下列反应:CaO+C(石墨)=Ca(锡)+CO(气).以测定液态CaO-SiO_2和CaO-Al_2O_3-SiO_2渣中CaO的活度,在上式中符号下波纹线表示溶于渣中的组分,直线表示溶子金属中的组分,下同.对于CaO-Si0_2系,应用Gibbs-Duhem关系从CaO活度值算出了SiO_2的活度值,并根据一个统计力学模型讨论了活度曲线的形状.从CaO-Al_2O_3-SiO_2系的研究结果,可知在所研究的整个碱度范围內,渣中存在10%Al_2O_3都使CaO的活度增加;当Al_2O_3为20%时,则对CaO活度的影响视碱度不同而异.对Al_2O_3的这种行为,根据炉渣的离子结构理论提出了解释.
关键词:
张子青
,
周继程
,
邹元燨
,
田彦文
金属学报
本文以Sn为溶剂金属,直接用“渣-金属”化学平衡法,在较大组成范围内测定了CaO-Si0_2-Al_2O_3三元熔渣中CaO的活度。成功地用图示推测法推测了较难直接获得实验结果的低CaO浓度范围内CaO的活度。应用本文实验结果和数据分析得到了该渣系中较全面的等CaO活度曲线图,并对Al_2O_3在该渣系中的酸碱性行为进行了探讨。
关键词:
刘彦海
,
段百泉
,
胡希东
耐火材料
doi:10.3969/j.issn.1001-1935.2007.04.012
为了降低真空冶炼用MgO坩埚因MgO的高温不稳定性对冶炼合金造成的影响,同时发挥CaO的脱硫作用,以w(MgO+CaO)>97%的MgO-CaO熟料为原料,在对MgO-CaO熟料进行水化试验和烧结试验研究的基础上,研制了MgO-CaO坩埚,并且与CaO坩埚一起对一种纯金属和同材质的高温合金进行了对比冶炼试验.结果表明:MgO-CaO熟料的抗水化性远高于石灰熟料的;在添加适当种类和数量的烧结助剂后,MgO-CaO熟料的可烧结性明显改善;MgO-CaO坩埚的冶炼效果达到甚至超过了CaO坩埚.
关键词:
真空冶炼
,
坩埚
,
CaO
,
MgO-CaO
游瑞云
,
肖荔人
,
刘欣萍
,
林葱里
,
黄宝铨
,
许兢
,
陈宇
,
陈庆华
材料工程
doi:10.3969/j.issn.1001-4381.2010.06.002
通过熔融共混法制备CaO含量不同的PE/CaO复合材料,借助熔体流动速率仪和AR2000旋转流变仪,对PE/CaO复合材料熔体的流变行为进行研究.结果表明:PE/CaO复合材料的黏流活化能随CaO含量的增加先上升后逐渐下降;当CaO含量(质量分数,下同)≤20%时,复合材料的线性黏弹性与纯PE相近,零剪切黏度变大的幅度较小;当CaO含量≥25%时,复合材料的时间稳定性下降,零剪切黏度明显增大.
关键词:
聚乙烯
,
氧化钙
,
复合材料
,
流变行为