A.ARACENA
,
O.JEREZ
,
C.ANTONUCCI
中国有色金属学报(英文版)
doi:10.1016/S1003-6326(16)64117-1
采用热重分析方法,利用1.3 mL陶瓷坩埚(内径11mm,高14 mm),在不同气体流速下研究方锑矿在中性气氛中和煅烧(550～615℃)/熔解(660～1100℃)温度下的挥发动力学.分析颗粒尺寸的影响.部分反应样品的失重分析和X射线衍射分析结果以及热力学研究表明,在整个温度范围内,方锑矿不形成其他化合物,直接以Sb4O6的形式挥发.在煅烧温度下,Sb2O3的挥发动力学方程可用X=kappt描述.挥发反应受表面化学反应控制,活化能为193.0 kJ/mol.根据方锑矿在溶解温度下的挥发反应动力学方程呈线性关系的特点,确定了挥发反应的动力学常数,得到表面积为8.171×l0-5m2的挥发反应的活化能为73.9 kJ/mol.
关键词:
方锑矿
,
挥发速率
,
煅烧温度
,
熔解温度
,
动力学
Author S.R. Zhou
,
S.R. Qiao
,
S.H. Bai and C.S. Tian Faculty 401
,
Northwestern Polytechnical University
,
Xian 710072
,
ChinaManuscript received 18 October 1998
金属学报(英文版)
The tensile properties of three different carbonfiberreinforced carbon composites (C/C), mat C/C, 2D laminate and 4D C/C, were investigated under the combined influence of temperature and loading rate. From the experiments the following could be concluded: loading rate between 10-1-10 mm/min was valid; the fracture stress of the three kinds of C/C composites increased with increasing temperature in the range from room temperature to 1900, and the initial modulus of 2D laminate C/C composites increased with the increase of temperature up to 2000.
关键词:
tensile testing
,
null
,
null
,
null
孙乐
,
方向青
,
孟广慧
材料科学与工程学报
doi:10.14136/j.cnki.issn 1673-2812.2016.05.027
通过化学气相渗透(CVI)、树脂浸渍/碳化(I/C)的工艺制成多孔的C/C预制件,采用气体压力浸渗方法向预制体中渗入铜,制备出C/C-Cu复合材料.以高密度C/C复合材料(1.9g/cm3)作为对比样,在MM-200型磨损试验机上对其摩擦磨损性能进行测试,并对其微观结构和摩擦磨损机理进行分析.研究结果表明:C/C-Cu的摩擦系数比C/C复合材料的低,这主要与摩擦表面的摩擦膜有关,铜在摩擦力带动下填充摩擦表面的凹坑,并与碳材料共同形成摩擦膜,摩擦膜的碳含量越高,润滑效果越好.当C/C预制件密度为1.59 g/cm3时,C/C-Cu的摩擦系数和磨损量均小于C/C复合材料,摩擦磨损性能良好.
关键词:
C/C-Cu
,
摩擦磨损
,
摩擦膜
Physical Review B
We report the electronic transport properties of a composite system comprising zero dimensional superconducting NbC(C) nanocapsules and carbon nanofiber matrix. DC susceptibility measurements of the nanocomposite indicate that the critical temperature (T-C) of NbC nanocrystals is 10.7 K. The temperature dependence of electrical resistivity of the specimen pellet follows the Mott's T-1/4 law in a temperature range between T-C of NbC and 300 K, owing to a strong degree of structural disorder in the carbon matrix. Below the T-C of NbC, when the change of its electrostatic energy Delta E is far greater than the thermal energy, an electron will be localized on an isolated NbC nanocrystal at very low temperatures, leading to "Coulomb Blockade." As a result, a collective behavior of the single-electron tunneling effect takes place in a three-dimensional granular superconductors' network composed of the NbC/carbon/NbC tunneling junctions. The superconducting gap of NbC crystals is not found in the current-voltage curves, due to the suppression of surface superconductivity through the contact between NbC and carbon shells.
关键词:
zero-dimensional superconductor;granular metal-films;particles;conduction;nanocapsules;percolation;samples
材料科学技术（英文）
Oxidation behavior of C/C-SiC gradient matrix composites and C/C composites were compared in stationary air. The results show that oxidation threshold of C-SiC materials increases with the amount of SiC particles in the codeposition matrix. Oxidation rate of C/C-SiC gradient matrix composites is significantly lower than that of C/C material. The micro-oxidation process was observed by SEM.
关键词:
carbon carbon composites
Jingyi DENG
,
Wenchuan LIU
,
Haifeng DU
,
Huiming CHEN
,
Yiyi LI
材料科学技术（英文）
Oxidation behavior of C/C-SiC gradient matrix composites and C/C composites were compared in stationary air. The results show that oxidation threshold of C-SiC materials increases with the amount of SiC particles in the codeposition matrix. Oxidation rate of C/C-SiC gradient matrix composites is significantly lower than that of C/C material. The micro-oxidation process was observed by SEM.
关键词:
李波
,
崔园园
,
李爱军
,
周春节
,
张家宝
,
白瑞成
上海金属
综述了C/C-SiC摩擦材料的研究现状,以及C/C-SiC摩擦材料的发展历程.详细分析C/C-SiC摩擦材料的摩擦磨损性能影响因素及机理,介绍了C/C-SiC摩擦材料的改性及应用现状,并对未来的研究重点进行了展望.
关键词:
C/C-SiC摩擦材料
,
摩擦磨损性能
,
机理
,
改性
ZHOU Qianli DU Ting Central Iron and Steel Research Institute
,
Ministry of Metallurgical Industry
,
Beijing
,
China DU Ting Senior Engineer
,
Laboratory No.16
,
Central Iron and Steel Research Institute
,
Ministry of Metallurgical Industry
,
No.76 Xueyuannanlu
,
Beijing
,
China
金属学报(英文版)
The influence of Sb on the C solubility in liquid Fe was measured under 1300,1400 and 1500℃.The C solubility decreases with the increase of Sb content in liquid Fe.The tem- perature dependences of the first order interaction coefficients in C-saturated liquid Fe were determined as follows: *e_C~(Sb)=11.309/T+0.0025 *e_(Sb)~C=128.023/T-0.0219 The temperature dependences of interaction coefficients between Sb and C in dilute liquid Fe were given to be: e_C~(Sb)=14.204/T+0.025 e_(Sb)~C=120.541/T+0.227 ε_C~(Sb)=ε_(Sb)~C=6026.75/T+11.958 The interaction coefficients at 1600℃ are *e_C~(Sb)=0.0085,e_C~(Sb)=0.033,*e_(Sb)~C=0.295, ε_C~(Sb)=ε_(Sb)~C=15.36.The first order interaction coefficients vary slightly with the temperature.
关键词:
Fe-C-Sb solution
,
null
,
null
,
null
