欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(18)
  • 图书()
  • 专利()
  • 新闻()

Corrosion Behaviors of Steel A3 Exposed to Thiobacillus Ferrooxidans

Jianhua LIU , Xin LIANG , Songmei LI

材料科学技术(英文)

The corrosion behaviors of steel A3 in synergistic action of Thiobacillus ferrooxidans (T.f) and electrochemically accelerated corrosion were studied by electrochemical, microbiology and surface analysis methods. The open circuit potential (Eocp) and electrochemical impedance spectroscopy (EIS) of the steel A3 electrodes were measured in leathen culture medium without and with T.f (simply called T.f solution in the following paper) in immersion electrode way at the time of the 2nd, 5th, 10th, 20th and 30th days, respectively. It was found that Eocp of the electrode for immersion in leathen culture medium shifted negatively with the immersion time while that for immersion in T.f solutions shifted negatively, then positively and finally negatively. On the 20th day, the corrosion of steel A3 for immersion in culture medium was in pitting initiation stage while that for immersion in T.f solutions was in pitting growth stage. It was found that the corrosion of steel A3 was accelerated by T.f. The morphology of corrosion product of steel A3 immersion in T.f solutions observed through scanning electron microscopy (SEM) transformed from solid globules to tabular plates and to spongy globules and plates.

关键词: Microbiologically influenced corrosion , null , null , null

ACRT-B法生长的MnxCd1-xIn2Te4晶体的溶质分凝特性

常永勤 , 介万奇 , 郭喜平 , 陈福义 , 安卫军

功能材料

研究了ACRT-B法生长的Mn0.1Cd0.9In2Te4晶体中界面的形状和各组元沿轴向的分布规律及其分凝因数.发现结晶界面为椭球形;采用理想配比生长MnxCd1-xIn2Te4晶体,其4种组元并不按(Mn,Cd):In:Te=1:2:4比例结晶,而是要重新分布;通过数学方法处理实验数据得到Mn,Cd和In的分凝因数在α相区分别为1.286、1.9257和0.7294,在β相区则分别为1.12、1.055和0.985.

关键词: ACRT-B法 , MnxCd1-x In2Te4 , 界面 , 分凝因数

Bridgman法生长的MnxCd1-xIn2Te4晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mn0.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里-外斯定律,在低温区(<50K)则表现出顺磁增强现象.

关键词: MnxCd1-xIn2Te4 , compositional distribution , infrared transmission spectra , mag- netic susceptibility

Bridgman法生长的MnxCd1-xIn2Te4晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报 doi:10.3321/j.issn:1000-324X.2003.02.004

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mno.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里一外斯定律,在低温区(<50K)则表现出顺磁增强现象.

关键词: MnxCd1-xIn2Te4 , 成分偏析 , 红外透射光谱 , 磁化率

MnxCd1-xIn2 Te4晶体生长研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

功能材料

采用Bridgman法生长四元稀磁化合物半导体Mn0.22Cd0.78In2Te4晶体.当晶体生长到预定长度时,淬火得到固液界面.采用光学显微镜、扫描电镜、X射线衍射仪、ISIS能谱仪以及Leica定量金相分析仪研究了晶体中出现的界面形态、相的形貌和数量以及沿生长方向的相析出规律,并进行了相成分分析.研究发现,淬火得到的Mn0.22 Cd0.78In2Te4晶体中存在两个界面,其中一个为固液相变界面,另一个为由α+β两相区发展到单相β区时的转变界面,二者相对于生长初始端均为凹形;α+β两相区中,β相以条状、花状和近似圆片状形式存在,其中条状β相多分布在晶界处;越接近生长初始端,花状和近似圆片状β相越小,条状β相越细,它们的含量越少;X射线衍射图谱表明,β相为黄铜矿结构,α相为面心立方结构.

关键词: MnxCd1-xIn2Te4 , 相变界面 , β相 , X射线衍射图谱

THERMODYNAMIC PROPERTIES OF ALPHA-HELIX PROTEIN - A SOLITON APPROACH - COMMENT

Physical Review E

We disagree with the deduction of the equations of motion for the Davydov soliton and of the results in the paper by Jia-Xin Xiao et al. [Phys. Rev. A 44, 8375 (1991)]. The weakness and faults of the Davydov theory are also indicated.

关键词: davydov solitons;vibron solitons;molecules;excitation;system

Heterogenization of Indium for the Friedel-Craft Benzoylation of Toluene

Farook ADAM*, Kei Lin SEK

催化学报 doi:10.1016/S1872-2067(11)60453-1

Indium incorporated silica samples with different indium contents were synthesized using a template free sol-gel method. The silica used was extracted from rice husk (RH) and the resulting catalyst was labeled as RH-xIn (x=5%,10%,15%, and 20%). From the N2 adsorption analysis the presence of type IV isotherm in RH-blank and RH-xIn indicated the mesoporous nature of the catalysts. In the XRD pattern, a broad band at ca.2θ=25° was observed for all the catalysts which showed them to be amorphous. TEM micrographs revealed that the material is composed of nanoparticles. Friedel-Craft benzoylation of toluene was carried out using the RH-xIn catalyst. The optimum conditions for the benzoylation of toluene were determined and at 373 K,100%conversion and 89%selectivity for the para-product (i.e.4-methylbenzophenone) were obtained.

关键词: rice husk , sol-gel , indium , Friedel-Craft benzoylation , Toluene

形状记忆合金的本构关系

王振清 , 周博 , 梁文彦

金属学报

利用DSC(示差扫描热量分析)热流-温度曲线和马氏体体积分数与自由能增量间的微分关系,建立了一个新的余弦型形状记忆合金马氏体相变模型。在Tanaka和Liang研究的基础上,推导了一个新的形状记忆合金本构方程。研究表明:Liang建立的马氏体相变模型和本构方程分别为本文建立的马氏体相变模型和本构方程所描述的一种特殊情况;本文建立的马氏体相变模型和本构方程比Liang及其它现存马氏体相变模型和本构方程能更准确地描述形状记忆合金的相变行为和力学行为。

关键词: DSC , Shape Memory Alloy , Martensitic transformation model , Constitutive equation

形状记忆合金的本构关系

王振清 , 周博 , 梁文彦

金属学报 doi:10.3321/j.issn:0412-1961.2007.11.017

利用DSC分析了热流-温度曲线和马氏体体积分数与自由能增量间的微分关系,建立了一个新的余弦型形状记忆合金马氏体相变模型;推导了一个新的形状记忆合金本构方程.研究表明:Liang和Rogers的马氏体相变模型和本构方程分别为本文建立的马氏体相变模型和本构方程所描述的一种特殊情况;本文建立的马氏体相变模型和本构方程比Liang和Rogers及其它现存马氏体相变模型和本构方程能更准确地描述形状记忆合金的相变行为和力学行为.

关键词: 形状记忆合金 , DSC , 马氏体相变模型 , 本构方程

  • 首页
  • 上一页
  • 1
  • 2
  • 下一页
  • 末页
  • 共2页
  • 跳转 Go

出版年份

刊物分类

相关作者

相关热词