材料期刊网

STUDY IN FO RMATION OF SUB GRAINS AND MICROCRACKS IN WEIDED METAIS UNDER FATIGUE LOAD

S.Z.Dong , J.B.Li , X.H.Zhang and J.Zhang Shenyang University , Shenyang 110044 , China

金属学报(英文版)

With TEM( Transmission Electron Microscope) ,ithasobserved and analyzedthatforming processof Sub grainsand position offormingfatigue microcracksarein Welded metalsofthe16 Mnsteelundertensile tensilestress. Theresultsindicatedthattheforming processof Sub grainsfrom dislocationtanglecellstotheSub grains. Thepositionofformingfatigue micro crackisattheoxidativeinterfaceand granular noncrgstallines and Sub boundaries. Thece mentiteineutectoidsafterfracture may beproduced microcracks.

关键词: fatigueload , null , null , null

Jian ZHANG/Langhong Lou

材料科学技术（英文）

关键词:

Ion sputter erosion in metallic glass-A response to "Comment on: Homogeneity of Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass" by L-Y. Chen, Y-W. Zeng, Q-P. Cao, B-J. Park, Y-M. Chen, K. Hono, U. Vainio, Z-L. Zhang, U. Kaiser, X-D. Wang, and J-Z Jiang J. Mater. Res. 24, 3116 (2009)

Journal of Materials Research

The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.

关键词: room-temperature

The effect of environmental variables on atmospheric corrosion of carbon steel in Shenyang

Chinese Science Bulletin

A study was carried out in order to investigate the effect of contaminants and meteorological variables on the rust layer of carbon steel exposed in Shenyang urban atmosphere. Seven kinds of contaminants and twelve kinds of meteorological parameters were also registered in order to correlate the data with respect to corrosion rate and the stepwise multiple regression analysis was carried out in order to obtain the best regression model. The sum of rainfall time as well as sunshine time and the concentration of H(2)S could stimulate initial atmospheric corrosion of carbon steel. The initial atmospheric corrosion kinetics of carbon steel was observed to follow the cubic equation. The corrosion products were analyzed by XRD and the transformation of phases in different periods was discussed.

关键词: contaminants;meteorological parameters;carbon steel;urban atmospheric;corrosion;stepwise multiple regression;corrosion products;rust;pollution

J(τ_0γ_0/(x_1x_2))行列式与弹塑性J积分不守恒的理论与实验证明

刘叔仪

金属学报

<正> 作为固体脆性断裂判据的J积分,其数值与其积分路径无关,这在文献中叫“守恒性”。这个守恒性已被推广到塑性断裂,这到底有否根据?本文目的是作这个问题的证明。未用原作者的方法,但由两个旋度判据得到应力应变函数行列式给出的一些否定结论,希望这对J积分应用条件的了解有所助益。1.弹塑性J积分守恒的条件 J积分

关键词:

H_2气氛保护热处理1J50组织结构与性能的研究

孙建春 , 盛光敏 , 陈登明 , 周安若 , 朱光俊

功能材料

1J50软磁合金的性能主要是通过H_2热处理获得的,在1130℃和H2气氛保护下对冷轧态1J50软磁合金进行了热处理.运用MATS-2010SA软磁测试仪对处理前后1J50软磁合金的磁性能进行了检测,运用金相显微镜、XRD等手段对处理前后1J50软磁合金的组织结构进行了分析.结果表明,通过H_2热处理,1J50软磁合金的矫顽力显著降低,起始磁导率和最大磁导率提高;组织结构发生明显变化,冷轧态1J50软磁合金组织为孪晶奥氏体,平均晶粒尺寸为200μm,处理过后,晶粒显著长大,平均晶粒尺寸为100μm;由于在600℃时采取了快冷,处理后1J50软磁合金中未出现大量FeNi相和FeNi_3相.

关键词: H2热处理 , 1J50 , 组织结构 , 性能

Response to the Comment on 'Conjectures on exact solution of three-dimensional (3D) simple orthorhombic Ising lattices'

Philosophical Magazine

The error of Equation (15b) in my article [Z.D. Zhang, Phil. Mag. 87 (2007) p.5309] in the application of the Jordan-Wigner transformation does not affect the validity of the putative exact solution, since the solution is not derived directly from that equation. Other objections of Perk's comment [J.H.H. Perk, Phil. Mag. 89 (2009) p.761] are the same as those in Wu et al.'s comments [F.Y. Wu et al., Phil. Mag. 88 (2008) p.3093; p.3103], which do not stand on solid ground and which I have sought to refute in my previous response [Z.D. Zhang, Phil. Mag. 88 (2008) p.3097]. The conjectured solution can be utilized to understand critical phenomena in various systems, whereas the conjectures are open to rigorous proof.

关键词: 3D Ising model;exact solution;conjecture;critical phenomena;ferromagnetism;magnetic phase transition;model;analyticity

X70管线钢J1d和K1a与V型缺口Ak关系研究

朱杰武 , 柳永宁 , 许雁 , 冯耀荣

机械工程材料 doi:10.3969/j.issn.1000-3738.2005.06.007

在不同温度下测试了X70管线钢动态断裂韧度K1d、J1d和止裂韧度K1a以及夏氏V型缺口冲击韧度Ak,对三者的关系进行了分析.结果表明:温度和加载速率都对断裂韧度产生影响;加载速率变化引起的韧-脆断裂转变具有热激活特征,在热激活分析基础上,在应力强度因子速率K=15 MPa·m1/2s-1条件下,得出断裂韧度、止裂韧度和冲击韧度三者的关系:Ak=4.84×106T-2.8K1d(或K1a).可以用小试样Ak数据计算得到K1d和K1a.

关键词: 管线钢 , 断裂韧度 , 止裂韧度 , 韧-脆断裂转变

Proposed magnetic equation of state for the three-dimensional Ising model near criticality: Is the insulating ferromagnet CrBr(3) a candidate?

Physics Letters A

In a magnetic system, consistent with Griffiths analyticity requirements one can parameterize the equation of state near criticality by writing H = r(beta delta)h(theta), T = rt(theta) and the magnetization M = r(beta)m(theta), where T is measured from the critical temperature. For the insulating ferromagnet CrBr(3), the experimental data of Ho and Litster [J.T. Ho, J.D. Litster, Phys. Rev. Lett. 22 (1969) 6031 is well fitted by m(theta) as a linear function of theta [P. Schofield, J.D. Litster, J.T Ho, Phys. Rev. Lett. 23 (1969) 1098]. Also Ho and Litster give beta = 0.368, gamma = 1.215 and delta = 4.3. Those critical experiments are very close to the recent 31) king results of Zhang [Z.D. Zhang, Philos. Mag. 87 (2007) 5309], namely beta = 3/8, gamma = 5/4 and delta = 13/3. We therefore predict that m(theta) will be proportional to theta as a fingerprint of the 3D Ising Hamiltonian. (C) 2009 Elsevier B.V. All rights reserved.

关键词: Critical-point effects;Critical exponents;Ising model;Criticality;Ferromagnet;Magnetic equation of state;critical exponents

Huazhong University of Science and Technology(H.U.S.T)

材料科学技术（英文）

关键词: