J.M Hu
,
J.X. Wu
,
H.M Meng
,
YR. Zhu
,
D.B. Sun and D.J. Yang(Beijing Corrosion and Protection Center
,
Open Laboratory of Corrosion
,
Erosion and Surface Technology
,
University of Science and Technology Beijing
,
Beijing 100083
,
China)
金属学报(英文版)
Titanium based IrO2 +Ta2O5 oxide anodes with different compositions and pyrolysis temperatures were prepared by termodecompoisition method. By using X-ray diffraction (XRD), the structure and texture coefficient of the coatings, TC(hkl), of IrO2 rutile crystal have been tested. It showed that, the crystallization processes of IrO2 and Ta2O5 in xIrO2 +(100-x) Ta2 O5 (x is in mol%) films affected and confined each other.In the mixed system, IrO2 rutile phase existed as a solid solution with Ta, and attained the maximum solubility when x=70mol%, i.e. for the coating of 70% IrO2 +Ta2O5.For the coatings of low iridium content or at low preparing tem pemture, (110) and (101) pwtered orientations were dominant. However, preferred growth of IrO2 weakened with increasing either iridium content or temperature. Three typical surface morphologies were observed by using scanning electron tnicroscopy(SEM). The crystallite size of the mixed oxide coatings were finest for the the film of 70%IrO2 +30%Ta2O5,and decreased with the pyrolysis tempemture. As the results of the finest crystallite segregating on sudece and the maxitnum solid solubility of Ir and Ta component in deposits, the coatings with the composition of 70%IrO2 +Ta2O5 prepared at 450℃ presented the mdrimutn electrocatalgtic activitg for O2 evolution in 0. 5M H2SO4 solution.UP to 550℃, Ti base suffered to oxidation resulting in decreasing anode conductivity,therefore, coatings performed a low activity.
关键词:
titanium based coating anode
,
null
,
null
,
null
,
null
,
null
刘叔仪
金属学报
<正> 作为固体脆性断裂判据的J积分,其数值与其积分路径无关,这在文献中叫“守恒性”。这个守恒性已被推广到塑性断裂,这到底有否根据?本文目的是作这个问题的证明。未用原作者的方法,但由两个旋度判据得到应力应变函数行列式给出的一些否定结论,希望这对J积分应用条件的了解有所助益。1.弹塑性J积分守恒的条件 J积分
关键词:
李铂
,
周建江
,
夏伟杰
,
吴连慧
液晶与显示
doi:10.3788/YJYXS20142904.0605
直线是机载座舱显示画面中最基本的图元,其显示质量对于整个画面的显示效果影响较大,尤其是小角度下直线显示的“麻花”现象一直是影响显示效果的关键问题之一.为了提高小角度下直线的显示效果,本文提出了一种基于Wu算法的亮度渐变改进算法.该算法通过渐进地展现直线从轴方向上的亮度变化过程,减少亮度畸变,有效地改进了显示效果.通过Matlab仿真和FPGA实现,验证了该算法反走样后的小角度直线显示效果明显优于其他算法,而且结合中点画线法后,绘制时间与Wu算法相当.同时该算法还可改善大角度直线和圆弧的显示效果,消除了大角度直线的边缘锯齿,解决了圆弧在小角度部分的虚化问题.因此本文算法可用于对实时性和显示效果要求高的机载座舱显示系统,以缓解飞行员的视觉疲劳.
关键词:
座舱显示
,
反走样
,
改进Wu算法
,
小角度
,
FPGA实现
朱杰武
,
柳永宁
,
许雁
,
冯耀荣
机械工程材料
doi:10.3969/j.issn.1000-3738.2005.06.007
在不同温度下测试了X70管线钢动态断裂韧度K1d、J1d和止裂韧度K1a以及夏氏V型缺口冲击韧度Ak,对三者的关系进行了分析.结果表明:温度和加载速率都对断裂韧度产生影响;加载速率变化引起的韧-脆断裂转变具有热激活特征,在热激活分析基础上,在应力强度因子速率K=15 MPa·m1/2s-1条件下,得出断裂韧度、止裂韧度和冲击韧度三者的关系:Ak=4.84×106T-2.8K1d(或K1a).可以用小试样Ak数据计算得到K1d和K1a.
关键词:
管线钢
,
断裂韧度
,
止裂韧度
,
韧-脆断裂转变
吴连慧
,
周建江
,
夏伟杰
,
陈雅雯
液晶与显示
doi:10.3788/YJYXS20153001.0163
对于光栅化的三角形,其边缘存在明显的锯齿现象,因此需要进行反走样处理.基于Wu直线反走样算法的思想,考虑了水平直线外侧直接添加插值点的算法和三角形三边外侧反走样的算法.综合两者的优点,在绘制光栅化的三角形的同时,边缘叠加Wu反走样直线,并考虑背景像素灰度值的作用.结果表明,改进的三角形光栅化的边缘反走样算法有效提高了三角形光栅化后边缘的显示效果,该算法计算量小,便于FPGA实现,可用于对图形显示质量要求很高的机载显示系统.
关键词:
反走样
,
Wu算法
,
光栅化
,
FPGA
Physical Review B
The Hamiltonian for a four-sublattice Heisenberg ferrimagnet or ferromagnet with different exchange constants (J(ab) = J(cd) not equal J(bc) = J(da)) was established. An extended Bogoliubov transformation was developed by solving an equation group, consisting of 20 equations and 20 unknowns. The procedure for solving the equation group was carried out by introducing a simple way of reducing the numbers of the equations and the unknowns. The spin-wave spectra in the present system have been determined by performing the standard Holstein-Primakoff transformation and the Bogoliubov one. It has been found that the spin-wave spectra of the present system depend on the exchange constants and that the degeneracy of the spin-wave spectra remains. The results for a special case (J(ab) = J(bc)) i.e., an antiferromagnet are discussed briefly. The spin-wave spectra of the four-sublattice Heisenberg antiferromagnet are found to be degenerative also and they are linear in k for small k.
关键词:
model
胡跃鑫
,
冯玉林
,
姜伟
应用化学
doi:10.3724/SP.J.1095.2011.00521
采用不同尺寸的碳酸钙粒子增韧高密度聚乙烯,研究了不同温度下共混体系的临界粒子间距与碳酸钙粒子尺寸和含量之间的关系,确定了温度是Wu氏增韧理论临界粒子间判据适用性的重要影响因素.结果表明,在17℃下,临界粒子间距与碳酸钙粒子的尺寸和含量无关,该条件下Wu氏增韧理论临界粒子间距判据是适用的;而随着温度的升高,发现临界粒子间距依赖于碳酸钙粒子的尺寸,表明高温条件下,Wu氏增韧理论临界粒子间距判据不再适用.
关键词:
聚合物增韧
,
粒子间距
,
脆韧转变
Physical Review B
The quadratic Holstein-Primakoff spin-wave Hamiltonian for three-sublattice Heisenberg systems with different exchange constants (J(ab)=J(bc)not equal J(ca)) was diagonalized by a three-step procedure. The classical ground state was examined and the effects of quantum fluctuation on the ground state were discussed. The 0 K spin reorientation angles due to quantum fluctuations were found to originate from the asymmetry of the system. As an extended application of the spin-wave study of the multisublattice systems, the spin-wave spectra of a Heisenberg superlattice, which has four or three magnetic atoms or spins, in each magnetic unit cell in the x direction, were solved analytically in terms of creation and annihilation operators. It has been found that the spin-wave spectra of the present superlattice systems depend on the exchange constants J and J(1), and that the degeneracy of the spin-wave spectra remains for the superlattice of four atomic layers and is partially removed for the superlattice of three atomic layers mainly due to the asymmetry of the system. Another type of splitting of the energy level occurs which differs for those levels with different degeneracies. The mixing of the interface and the bulk modes were found for the spin-wave dispersion of the superlattices. It was predicted that even for different superlattices having the same exchange constants (either J or J'), i.e., without the oscillation of the exchange coupling, the asymmetry can lead to the oscillation of magnetic properties, such as magnetization and giant magnetoresistance.
关键词:
ferromagnetic superlattices;reorientation transitions;magnetic;superlattices;modes;temperatures;film
Y.G. Cao
,
X.Y. Sun
金属学报(英文版)
J-integral and crack opening displacement δ(COD) were important parameters for characterization of fractures in engineering materials. The relationship between J-integral and COD has been investigated for a long time and was enerally represented as J = m σyδ, where σy is the yield strength and m is a function of specimen geometry and material properties. To determine the value of m, extensive studies and experiments have been performed. The method that used the fracture-surface topography analysis (FRASTA) for determining J-integral from fracture surfaces of materials was introduced. On the basis of the relationship between COD and fracture surface average profile, the relationship between J-integral and COD was deduced and compared with the generally used equation. The method was experimentally confirmed to be able to provide a new way to determine the relationship between J-integral and COD.
关键词:
FRASTA
,
null
,
null
