欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(30264)
  • 图书()
  • 专利()
  • 新闻()

THERMODYNAMIC PARAMETERS IN THE NUCLEATION OF LIQUID IRON

C.Huang , B.Song , J.H.Mao , Q.Lin , P.Zhao

金属学报(英文版)

By using of electrolytic pure iron, the specimens containing different oxide content were made in a Mo wire furnace. The DTA method was employed to measure the undercooling of liquid iron during solidification. The relations between the cleanness of liquid iron and undercooling, thermodynamic driving force of nucleation, the nucleus forming energy, as well as the critical radius of nucleus have been investigated. The results showed that with the increase of cleanness of liquid iron the undercooling and thermodynamic driving force increased, while the nucleus forming energy and critical radius of nucleus decreased.

关键词: pure iron , null , null

H_2气氛保护热处理1J50组织结构与性能的研究

孙建春 , 盛光敏 , 陈登明 , 周安若 , 朱光俊

功能材料

1J50软磁合金的性能主要是通过H_2热处理获得的,在1130℃和H2气氛保护下对冷轧态1J50软磁合金进行了热处理.运用MATS-2010SA软磁测试仪对处理前后1J50软磁合金的磁性能进行了检测,运用金相显微镜、XRD等手段对处理前后1J50软磁合金的组织结构进行了分析.结果表明,通过H_2热处理,1J50软磁合金的矫顽力显著降低,起始磁导率和最大磁导率提高;组织结构发生明显变化,冷轧态1J50软磁合金组织为孪晶奥氏体,平均晶粒尺寸为200μm,处理过后,晶粒显著长大,平均晶粒尺寸为100μm;由于在600℃时采取了快冷,处理后1J50软磁合金中未出现大量FeNi相和FeNi_3相.

关键词: H2热处理 , 1J50 , 组织结构 , 性能

DLC膜厚度对镁基表面DLC/MAO复合膜层性能的影响

杨巍 , 汪爱英 , 柯培玲 , 代伟 , 张学谦

材料工程 doi:10.3969/j.issn.1001-4381.2012.04.019

采用线性离子束沉积技术于AZ80镁合金微弧氧化(MAO)陶瓷层表面沉积不同厚度的类金刚石碳(DLC)膜,形成DLC/MAO复合膜层.对比研究4种膜基系统的表面结构特征、力学性能以及摩擦学性能差异.结果表明:随DLC膜厚度增加,复合膜层表面微孔数量减少,孔径减小,但凹凸不平趋势增加,且DLC膜表面颗粒特征更加明显,表现为DLC-80min/MAO/AZ80膜基系统具有最小的表面粗糙度,最大的硬度H、弹性模量E及H/E值;不同厚度DLC/MAO/AZ80膜基系统平均摩擦因数较MAO/AZ80显著降低;DLC膜厚度增加导致3种复合膜基系统的表面微观结构改变,使得摩擦因数与磨痕形貌存在差异;各膜基系统表面磨痕处均形成了Fe的转移层,由于表层DLC膜“裸露”的大量C对磨损界面具有很好的润滑作用,而使得镁合金基体获得有效保护.

关键词: 镁合金 , 微弧氧化 , 类金刚石碳膜 , 微观结构 , 性能

β-二酮钛配合物/MAO催化合成间规聚苯乙烯及其热性能

阎卫东 , 刘立新 , 姜涛 , 李丹 , 周鼐 , 胡友良

应用化学 doi:10.3969/j.issn.1000-0518.2001.02.008

以β-二酮钛配合物/MAO催化苯乙烯间规聚合.80 C,β-二酮钛浓度为4.3×10-4mol/L,β-二酮钛与MAO的物质的量比为500时,聚合活性为6.2×l05g/(mol·h).该催化剂对温度的稳定性较高.所得聚合物的熔点在267C左右.测定了所得间规聚苯乙烯的基本热性能.

关键词: 间规聚苯乙烯 , 苯乙烯 , 间规聚合 , β-二酮钛配合物 , 热性能

The preparation and corrosion behaviors of MAO coating on AZ91D with rare earth conversion precursor film

Applied Surface Science

A novel kind of micro-arc oxidation (MAO) coating was prepared on magnesium alloy surface coated with rare earth conversion film (RE-film) in an alkaline aluminum oxidation electrolyte by AC power source. Inspection of scanning electron microscopy (SEM), X-ray diffraction (XRD) and Fourier transform infrared (FTIR) microspectroscopy, the structure and composition of MAO coating formed on AZ91D with RE-film under different applied voltages were investigated and the performance of the optimized MAO coating compared with the MAO coating directly formed on magnesium alloy. As the pretreatment of magnesium alloy with RE-film, the cerium oxides can be incorporated into the MAO coatings, reduce porosity of the MAO coating surface and enhance the thickness of MAO coating. These structure features and the cerium oxides incorporated into the MAO coating result in greatly improved corrosion resistance. Base on electrochemistry impedance spectroscopy (EIS) measurement, the electronic structure and composition analysis of the MAO coating, a double-layer structure, with a compact inner layer and a porous outer layer, of the coating was proposed for understanding its corrosion process. (C) 2010 Elsevier B.V. All rights reserved.

关键词: Magnesium alloy;Rare earth conversion film;Micro-arc oxidation;Porosity;az31 magnesium alloys;micro-arc oxidation;mg-al alloys;electrolyte;resistance;cerium;phosphate

Product/metal ratio (PMR): A novel criterion for the evaluation of electrolytes on micro-arc oxidation (MAO) of Mg and its alloys

Science China-Technological Sciences

Product/metal ratio (PMR) was introduced as a novel criterion for the evaluation of electrolytes on micro-arc oxidation (MAO) of Mg and its alloys. The criterion initially sprang from Pilling-Bedworth ratio (PBR), focused on the roles of electrolytes for the compactness of the fabricated coatings, and took attention on properties of reactants/products during MAO. Meanwhile, based on our experiments as well as the results from literatures, the effects of electrolyte additives on morphologies and compositions of the fabricated MAO coatings of Mg alloys were exploited for verification and supplement of the initial criterion. In combination of the initial PMR criterion and experimental verification, PMR could be represented by special mode (PMR (s)=V (oxide products)/V (alloy substrates)) and general mode (PMR (g)= PMR (s)+ PMR (d)). The ideal PMR (s) should be between 1 and 2, while PMR (d) is related to the coating deposition during MAO. PMR (d) is a supplement to PMR (s) when the effect of the overlaying property (O) of the coatings and the effective deposition (D) of electrolyte composites are considered (PMR (d)=f(O, D). O is related to the melting point (MP) and boiling point (BP) of the MAO products. D is related to the effective reactions between alloy substrates and electrolytes during MAO.

关键词: micro-arc oxidation;Mg alloys;Pilling-Bedworth ratio;product/metal;ratio;az91d magnesium alloy;electrochemical corrosion behavior;silicate-containing electrolytes;ceramic coatings;potassium fluoride;resistance;films;surface;microstructure;technology

Electrochemical corrosion behavior of composite coatings of sealed MAO film on magnesium alloy AZ91D

Electrochimica Acta

Protective composite coatings were prepared on magnesium alloy AZ91D by micro-arc oxidation (MAO) treatment plus a top coating with sealing agent using multi-immersion technique under low-pressure conditions. The corrosion resistance of AZ91D alloy with composite coatings was superior evidently to that with merely MAO film. SEM observations revealed that the sealing agent was integrated with MAO film by physically interlocking; therewith covered uniformly the surface as well as penetrated into pores and rnicro-cracks of MAO film. The anti-corrosion properties in 3.5% NaCl solution of the composite coatings were evaluated by using electrochemical impedance spectroscopy (EIS) and potentiodynamic polarization measurements. Based on the results of chronopotentiometric (E similar to t) and EIS measurements for long time immersion in 3.5% NaCl solution, appropriate equivalent circuits for the composite coatings system were proposed. It follows that due to the blocking effect of the sealing agent in pores and cracks in MAO film, the composite coatings can suppress the corrosion process by holding back the transfer or diffusion of electrolyte and corrosion products between the composite coatings and solution during immersion. (c) 2005 Elsevier Ltd. All rights reserved.

关键词: composite coatings;MAO film;sealing;magnesium alloy AZ91D;EIS;micro-arc oxidation;impedance spectroscopy;interfacial factors;phosphate coatings;alkaline-solutions;aluminum-alloys;nacl solution;anodic films;mg alloys;part 2

The effect of phosphate on MAO of AZ91D magnesium using AC power source

Materials and Corrosion-Werkstoffe Und Korrosion

A rapid and convenient anodization technology with AC power source to obtain the MAO films formed on magnesium alloy AZ91D in phosphate bath (base electrolyte + Na3PO4) with or without aluminate and silicate was studied. The corrosion resistance of the anodic films was studied by electrochemical impedance spectroscopy (EIS) and potentiodynamic polarization techniques and the microstructure and composition of films were examined by SEM and XRD. The results show that Na3PO4 can promote the occurrence of sparking during the MAO process, while abundant heat generated by sparking might enhance the formation of the glassy phase of the compound when the electrolyte contains the additives of NaAlO2 and Na2SiO3 simultaneously. The optimized MAO film is ivory-white smooth by naked eye, while presents porous and microcracks in microscopic scale. The anodic film formed in the alkaline solution with optimized parameters possesses superior corrosion resistance by electrochemical test. The XRD pattern shows that the components of the anodized film consist of MgO, MgAlO2, and MgSiO3. No oxide crystal with P element can be found.

关键词: micro-arc oxidation;electrochemical impedance spectroscopy;koh-aluminate solutions;corrosion protection;ceramic coatings;alloys;anodization;parameters;resistance;behavior

Spin waves in a four-sublattice Heisenberg ferrimagnet or ferromagnet with different exchange constants (J(ab)=J(cd)not equal J(bc)=J(da))

Physical Review B

The Hamiltonian for a four-sublattice Heisenberg ferrimagnet or ferromagnet with different exchange constants (J(ab) = J(cd) not equal J(bc) = J(da)) was established. An extended Bogoliubov transformation was developed by solving an equation group, consisting of 20 equations and 20 unknowns. The procedure for solving the equation group was carried out by introducing a simple way of reducing the numbers of the equations and the unknowns. The spin-wave spectra in the present system have been determined by performing the standard Holstein-Primakoff transformation and the Bogoliubov one. It has been found that the spin-wave spectra of the present system depend on the exchange constants and that the degeneracy of the spin-wave spectra remains. The results for a special case (J(ab) = J(bc)) i.e., an antiferromagnet are discussed briefly. The spin-wave spectra of the four-sublattice Heisenberg antiferromagnet are found to be degenerative also and they are linear in k for small k.

关键词: model

双-(β-酮萘胺)镍(Ⅱ)/MAO催化剂体系催化苯乙烯聚合

刘永明 , 贺晓慧 , 陈义旺 , 伍青

催化学报

采用双-(β-酮萘胺)镍(Ⅱ)为主催化剂,以甲基铝氧烷(MAO)为助催化剂,在甲苯溶剂中进行了苯乙烯聚合实验,并考察了聚合温度、Al/Ni摩尔比、单体浓度和聚合时间等因素对聚合反应的影响. 结果表明,双-(β-酮萘胺)镍(Ⅱ)/MAO催化剂显示出很高的催化活性,可催化苯乙烯聚合得到中等分子量和分子量分布较窄(Mw/Mn<1.6)的聚苯乙烯. 采用核磁共振氢谱、核磁共振碳谱、傅里叶变换红外光谱、差示扫描量热法和广角X射线衍射技术对聚合产物进行了表征. 结果表明,所得聚合物为无规聚苯乙烯.

关键词: , 络合物 , 后过渡金属催化剂 , 苯乙烯 , 聚合 , 聚苯乙烯

  • 首页
  • 上一页
  • 1
  • 2
  • 3
  • 4
  • 5
  • 下一页
  • 末页
  • 共3027页
  • 跳转 Go

出版年份

刊物分类

相关作者

相关热词