欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(30101)
  • 图书()
  • 专利()
  • 新闻()

MAGNETIC PHASE DIAGRAM OF SmMn_2(Ge_(1-x)Si_x)_2 SYSTEM

Y.G. Wang , F.M Yang , C.P. Chen , N Tang , and Q.D. Wang (State Key Laboratory of Magnetism , Institute of Physics , Chinese Academy of Sciences , P.O. Box 603 , Beijing 100080 , China)(Department of Materials Science and Engineering , Zheiang University Hangzhou 310027 , China)

金属学报(英文版)

The magnetic phase diagram (x,T) of the SmMn2(Ge1-xSix)2 system has been studied by susceptibility and magnetization measurement. With increasing silicon concentration the temperature region of ferromagnetic ordering decreases on the phaae diagram.

关键词: magnetic phase diagram , null , null , null

P92钢C-曲线的评价

段宝玉 , 刘宗昌 , 任慧平 , 霍文霞

兵器材料科学与工程

研究P91、P92钢的过冷奥氏体转变具有重要理论意义和工程应用价值.汇总了P91、P92钢的CCT图和TTT图,对这些C-曲线进行分析和评价,指出存在的缺点,展示了P92钢的新的TTT图.P92钢的等温转变组织形貌较为特殊:珠光体组织为纤维状,下贝氏体呈颗粒状.

关键词: P91钢 , P92钢 , CCT图 , TTT图 , 珠光体 , 贝氏体

Chen系统的状态变量周期性反馈控制

李开明 , 李亚洲 , 冯维贵 , 林长

量子电子学报 doi:10.3969/j.issn.1007-5461.2007.05.014

采用非线性反馈控制,用附加了带参数的正弦项对Chen系统进行了有效的控制.随着参数k的逐渐增大,系统的动力学行为呈现出一系列的变化.数值研究结果表明:随控制参数的增大,驱动信号的强度渐大,混沌系统由混沌运动到周期轨道,最终到一相点.

关键词: 混沌 , Chen系统 , 不动点 , Lyapunov指数 , 反馈控制

P2O5对C6A4MS-C2S-C4AF系中β-C2S稳定作用研究

马德伟 , 杨利群 , 徐先宇

材料科学与工程学报 doi:10.3969/j.issn.1673-2812.2001.02.020

本文研究了C6A4MS-C2S-C4AF系中R2O5对β-C2S的稳定性问题.结果表明:P2O5的掺入能有效抑制β-C2S转变为γ-C2S,稳定β-C2S;少量P2O5对C6A4MS的形成无抑制作用.

关键词: P2O5 , C6A4MS-C2S-C4AF系统 , β-C2S稳定

Surface oxidation of molten Sn-0.07 wt% P in air at 280 degrees C

Journal of Materials Research

In this article, we describe oxidation of molten Sn-0.07 wt% P alloy exposed in air at 280 degrees C. Although oxidation can be effectively reduced by the addition of trace phosphorus, the oxide film has a poor protection for the molten alloy with a high P concentration. The oxide film was analyzed by x-ray photoelectron spectroscopy. Comparing the results with the low P sample, there was a high phosphorous content in the film and a new Sn-P compound on the surface of the high P sample. It is assumed that the poor protection against oxidation of the film could be due to volatility of phosphorus in the Sn-P alloy at the temperature.

关键词: sn

C/C复合材料石墨化度P1模型的表征及测定

张赟 , 邓海金 , 李明 , 李东生 , 姜海

材料工程 doi:10.3969/j.issn.1001-4381.2001.04.008

C/C复合材料的石墨化度反映了材料中碳结构与理想石墨晶体结构的接近程度,并且是影响其性能的一个重要结构参数。石墨化度P1是一种能够比较准确地表示碳材料石墨程度结构的参数。本文利用P1的基本模型,编制了相应的计算程序,通过X光衍射(XRD)分析,计算了不同热处理温度C/C复合材料石墨化度P1,结果表明它可以较好的表征C/C复合材料的石墨化程度。并进一步讨论了热处理温度(HTT)与石墨化度的关系。

关键词: C/C复合材料 , 石墨化度

The effect of C-Al (Ga) codoping on p-type tendency in zinc oxide by first-principles

Optical Materials

The electronic structures of C, C-Al and C-Ga doped ZnO were investigated from the first-principles based on density functional theory (DFT). It was found that the C-doped ZnO where 1/8 Os are substituted by C is p-type with hole carriers locating nearby valence band maximum. Moreover, the Madelung energy increases in this case. Incorporating the reactive donor Al or Ga into C-doped ZnO system at Zn sites, not only enhances the C acceptor concentration, but also gets a shallower C acceptor energy level in the band gap in p-type codoped ZnO crystals and decreases the Madelung energy. (c) 2009 Elsevier B.V. All rights reserved.

关键词: Codoping;First-principles;ZnO;Electronic structures;zno

电沉积RE-Ni-W-P-B4C-PTFE

郭忠诚 , 陈凌 , 杨显万 , 翟大成

电镀与涂饰 doi:10.3969/j.issn.1004-227X.2000.03.001

研究了RE-Ni-W-P-B4C-PTFE复合镀层的性能.结果表明:热处理温度对RE-Ni-W-P-B4C-PTFE复合镀层的硬度影响很大,当温度达到400℃时,复合镀层的硬度达到极大值(1145 Hv);在同一热处理温度下,当保温时间达到3小时,镀层的硬度值最佳.当热处理温度达到300℃时,RE-Ni-W-P-B4C-PTFE复合镀层的耐磨性最好.高温氧化试验表明:RE-Ni-W-P-B4C-PTFE复合镀层随氧化时间和温度的延长,被氧化的程度增加.

关键词: 电沉积 , RE-Ni-W-P-B4C-PTFE复合镀层 , 性能

MAGNETIC PROPERTIES AND STRUCTURES OF NANO-CRYSTALLINE Fe-P-C-Mo-Cu-Si ALLOYS

Y.F. Gao , J.Tan , G.D. Liu , C.L.Zhang , T.Liuand R.Z Ma (Rapidly Quenched Materials Research and Development Centre , Central Iron & Steel Research Institute , Beijing 100081 , China)(Metal Physics Department , University of Science and Technology Beijing , Beijing 100083 , China)

金属学报(英文版)

A mostly single bcc phase with grain sizes of 15-20 nm was prepared by crystallization of amorphous Fe-P-C-Mo-Cu-Si alloys.The Bs value (H=10000 Oe) reaches 1.595 T for Fe(79.5) P(12)C6Cu(0.5)Mo(0.5)Si(1.5) alloys. The low core loss of 0.14 w/kg at 1.3 T and 50 Hz was confirmed for the bcc Fe(79.5)P(12)C6Cu(0.5)Mo(0.5)Si(1.5) alloy.The structures of the alloy annealed at different temperatures have been investigated by means of Xray diffraction and transmission electron microscope. The relationship between the structure and magnetic properties of the alloy is discussed.

关键词: : amorphous alloy , null , null

Fe70Cr10P13C7合金激光非晶化研究

杨永强 , 阎毓禾 , 王茂才

腐蚀学报(英文)

Fe70Cr10P13C7是一种可形成非晶态的合金,它除具有比一般结构钢高得多的断裂强度外,还具有特别突出的耐腐蚀性能。用2~5kw连续波CO2激光在40Cr钢基体上首先获得晶态的Fe70Cr10P13C7宽带熔覆层,而后获得多道搭接的厚约0.2mm的非晶层。该非晶层动电位极化曲线表明,非晶态Fe70Cr10P13C7的耐腐蚀性高于1Cr18Ni9Ti不锈钢和加Cr的Ni-Nb非晶合金。

关键词: 激光非晶化 , Fe70Cr10P13C7 alloy , corrosion resistance

  • 首页
  • 上一页
  • 1
  • 2
  • 3
  • 4
  • 5
  • 下一页
  • 末页
  • 共3011页
  • 跳转 Go

出版年份

刊物分类

相关作者

相关热词