欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(8661)
  • 图书()
  • 专利()
  • 新闻()

Effects of Thermal Cycle on Mechanical Properties and Fractography in HAZ of HQ130 Steel

B. Liu , J.X. Qu , W.J. Sun

金属学报(英文版)

The effect of di®erent peak temperature (Tp) and cooling time (t8=5) on hardness, impact toughness and fracture morphology in the heat-affected zone (HAZ) of HQ130 steel was studied by using welding thermo-simulation test. Experimental results show that the impact toughness and hardness decrease with the decrease of Tp or increase of t8=5 under the condition of a single thermal cycle. There is a brittle zone in the vicinity of Tp=800±C,where the impact toughness is considerably low. There is softened zone in vicinity of Tp=700±C,Where the hardness decreases but the toughness increases. In the practical application of multi-layer and multi-pass welding, the welding heat input should be strictly limited (t8=5<=20s) so as to reduce the softness and brittleness in the HAZ of HQ130 steel.

关键词: high strength steel , null , null , null

S355J2W耐候钢的耐腐蚀性能

鲁二敬 , 卢峰华 , 许鸿吉 , 谢明 , 钮旭晶

机械工程材料

通过周期浸润腐蚀试验,对比研究了S355.12W耐候钢和Q345R低合金钢在NariSOs溶液中的耐腐蚀性能,并用扫描电镜对腐蚀产物进行了观察和分析。结果表明:在相同试验条件下,S355J2W耐候钢的腐蚀速率低于Q345R钢的;S355J2W耐候钢会在表面形成黑褐色锈层,而Q345R钢表面形成橘红色易剥落的疏松锈层;S355J2W耐候钢腐蚀产物微观形貌为沿放射性方向生长的针状晶体,Q345R钢为颗粒状聚合物堆积而成,形状无规则,颗粒之间有较大的空隙。

关键词: S355J2W耐候钢 , 周期浸润腐蚀试验 , 耐腐蚀性能

S355J2W+N钢激光-MAG复合焊与MAG焊对比

谷晓鹏 , 段珍珍 , 邓钢 , 谷晓燕

材料工程 doi:10.11868/j.issn.1001-4381.2015.02.004

利用激光-MAG复合焊和MAG焊进行了厚板S355J2W+N低碳钢的焊接实验,分析了两种焊接方法接头的微观组织和力学性能.结果表明:复合焊和MAG焊焊缝接头均由焊缝区、过热区、重结晶区和不完全重结晶区构成,复合焊接头截面呈“高脚杯”状特点,焊缝填充量和热影响区宽度较MAG焊明显减小.复合焊由于冷却速率快,过热区魏氏组织略有增多,硬度高于MAG焊,抗拉强度和弯曲性能与MAG焊相比,无显著差异,均能够满足生产标准的要求.

关键词: S355J2W+N , 激光 , MAG , 复合焊 , 接头组织 , 性能

Spin waves in a four-sublattice Heisenberg ferrimagnet or ferromagnet with different exchange constants (J(ab)=J(cd)not equal J(bc)=J(da))

Physical Review B

The Hamiltonian for a four-sublattice Heisenberg ferrimagnet or ferromagnet with different exchange constants (J(ab) = J(cd) not equal J(bc) = J(da)) was established. An extended Bogoliubov transformation was developed by solving an equation group, consisting of 20 equations and 20 unknowns. The procedure for solving the equation group was carried out by introducing a simple way of reducing the numbers of the equations and the unknowns. The spin-wave spectra in the present system have been determined by performing the standard Holstein-Primakoff transformation and the Bogoliubov one. It has been found that the spin-wave spectra of the present system depend on the exchange constants and that the degeneracy of the spin-wave spectra remains. The results for a special case (J(ab) = J(bc)) i.e., an antiferromagnet are discussed briefly. The spin-wave spectra of the four-sublattice Heisenberg antiferromagnet are found to be degenerative also and they are linear in k for small k.

关键词: model

关于J积分和应变能间的关系式

金属学报

J积分的临界值J_(Ic)(张开型)目前被广泛用作中低强度钢的断裂准则.根据线弹性断裂力学理论和弹塑性断裂力学的实验规律,现提出一个新的J积分和应变能间的关系式:J=2/B(W-α)[U—U_o+(M~2ψ)/(BE′W~2)],其中ψ与跨距S/W和裂纹深度α/W有关·此式对于跨距和裂纹深度没有限制,因而作为弯曲试样的J积分计算公式,具有较为广泛的适用范围·当α/W=0时,J=0,从物理意义上看也比较合理,为了便利计算,并列出ψ值表,可以查找。

关键词:

使用安捷伦J&W DB-35ms超高惰性色谱柱和DB-XLB色谱柱对水中低于μg·L-1级的有机氯农药和除草剂进行GC/μECD法分析

Doris Smith , Ken Lynam

环境化学

本文中使用安捷伦SPEC C18AR固相萃取膜盘成功萃取了水中的有机氯农药残留和除草剂.使用双柱配置的GC/μECD系统进行检测,安捷伦J&W DB-35ms UI超高惰性色谱柱作为分析柱,DB-XLB色谱柱为确认柱.该方法为浓度接近或低于最大污染限值的含氯有机物提供了高度灵敏的分析方法.根据预估的分析物萃取浓度,方法使用的校准范围为1-100 ng· mL-1.分别对0.01 μg·L-1的加标水样和一个自来水水样进行了萃取和分析,结果证明可满足水中的有机氯农药残留和除草剂的测定.

关键词: 有机氯农药 , 除草剂 , 色谱柱

J与U间的正确关系

陈篪

金属学报

<正> 目前,J_(Ⅰc)的测试引起了国内外的厂泛重视。三点弯曲试样得到了最广泛的应用。我们曾导出 J=(2U/B(W-a) (1)的关系,式中U是试样的应变能。Rice等在[2]中所建议的是另一关系 J=2/(B(W-a)integral from n=0 to △aPd△_a (2)其中 △_a=△-△_0 (3)△_0是同尺寸的无裂纹试样加载到同一载荷P时的位移。(1)和(2)式虽形式相近但内容不同究竟何者更为正确,很有必要加以澄清。 我们的推导是以U=B(W-a)~2f(△)或其等效关系P=B(W-a)~2φ(△)为出发点的,这里不再重复。Rice则假定

关键词:

高分子专利j

高分子材料科学与工程

专利名称:具有改进的抗冲击性、尺寸稳定性和吹塑成形性能的热塑性ABS树脂组合物专利申请号:CN200580040787.3公开号:CN101065413申请日:2005.03.31公开日:2007.10.31申请人j韩国第一毛织株式会社根据本发明的热塑性ABS树脂组合物包括:(a)2

关键词: 专利名称 , 高分子 , 树脂组合物 , 专利申请号 , 尺寸稳定性 , 抗冲击性 , 株式会社 , 成形性能

Study on the Relationship Between J-Integral and COD

Y.G. Cao , X.Y. Sun

金属学报(英文版)

J-integral and crack opening displacement δ(COD) were important parameters for characterization of fractures in engineering materials. The relationship between J-integral and COD has been investigated for a long time and was enerally represented as J = m σyδ, where σy is the yield strength and m is a function of specimen geometry and material properties. To determine the value of m, extensive studies and experiments have been performed. The method that used the fracture-surface topography analysis (FRASTA) for determining J-integral from fracture surfaces of materials was introduced. On the basis of the relationship between COD and fracture surface average profile, the relationship between J-integral and COD was deduced and compared with the generally used equation. The method was experimentally confirmed to be able to provide a new way to determine the relationship between J-integral and COD.

关键词: FRASTA , null , null

浅析CTOD和J积分的关系

周峰峦 , 郭震

物理测试 doi:10.13228/j.boyuan.issn1001-0777.20160084

推导了CTOD和J积分的关系,并且从试验角度利用三点弯曲试样进行CTOD试验,根据ASTM E1820对GB/T 21143-2014中公式34进行了评价,研究表明,在小屈服范围内,采用裂纹嘴张开位移可以同时得到CTOD和J积分,从而可以简化J积分的试验装置.

关键词: J积分 , CTOD , 小屈服

  • 首页
  • 上一页
  • 1
  • 2
  • 3
  • 4
  • 5
  • 下一页
  • 末页
  • 共867页
  • 跳转 Go

出版年份

刊物分类

相关作者

相关热词