针对宝钢股份炼钢厂一炼钢分厂1号和3号连铸机频繁发生板坯表面纵裂缺陷。综合分析了板坯表面纵裂产生的原因以及影响因素，制定并采取了相应的控制措施。在实际钢种设计中尽量避开叫（C）为0．09％～O．15％区间范围内的钢种；降低钢中叫（s），增加w（Mn），从而提高vo（Mn）／w（S）；降低钢中夹杂物含量，提高钢水纯净度；适度调整保护渣的成分，提高保护渣的粘度，降低碱度。采取这些措施，铸坯表面的纵裂状况得到了明显改善。
In the light of the situation that longitudinal cracks on wide slab frequently occur in the No. 1 and No. 3 caster of the No. 1 Steelmaking Plant, the causes of cracks forming and influencing factors were analyzed and then conrresponding measures had been taken. In the design of steel grades, the steels with w(C)0.09 %-0. 15% should be chosen as few as possible. Other measures included: decreasing the amount of inclusions, enhancing the purity of molten steel, adjusting the compositions of mould flux, increasing the viscosity of mould flux and decreasing its basicity. Thanks to these measures, the longitudinal cracks on the slab have been improved significantly in the plant.
参考文献
| [1] | 侯葵,马立军,邓志勇.连铸宽板坯表面纵裂纹的成因及预防措施[J].连铸,2008(04):25-29. |
| [2] | 阮晓明.宝钢耐候钢连铸实践[J].钢铁,2001(02):20-22. |
| [3] | 魏刚武.炼钢厂连铸板坯纵裂纹研究[J].南钢科技与管理,2010(01):16-18. |
| [4] | 叶锦渭;陈亚贤.宝钢含碳量0.08%～0,20%的连铸板坯表面纵裂纹现状分析[J].宝钢技术,1992(06):7-8. |
| [5] | 袁爽;健建龙;宋素格.包晶钢Q235B表面纵裂纹分析[J].冶金丛刊,2010(01):9-11. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%