基于线性装药结构，在两端面顶部棱线中点同时起爆方式下，相向而行的爆轰波在装药对称面发生对撞，产生更高的爆轰压力作用于中部的药型罩上，使药型罩中形成有利于沿中线闭合的速度梯度，最终形成高速EFP。利用非线性动力学分析软件AUTODYN-3D，设计中间厚两边薄的变壁厚药型罩，边缘壁厚为0.5 mm、罩顶壁厚在1.4~2.4 mm内的6种结构，研究其EFP成型状态和各项性能参数，通过对比分析得出罩顶壁厚在1.6~2.0 mm之间侵彻体成型效果好，侵彻能力强。从而对新型高效毁伤战斗部的设计提供指导意义。
Based on the linear charge structure,initiation simultaneously by two edge midpoints,the opposite direction detonation wave collided in the symmetry plane,producing higher pressure acting on the center of the liner and forming the velocity gradient in the liner. The high velocity Explosively Formed Projectile(EFP)was formed close to the middle of liner. The non?linear dynamic Finite Element Analysis(FEA)program AUTODYN?3D was used to research the formation process of EFP. Liner models with six different thickness,whose edge thickness is 0.5 mm and top thickness is at the range from 1.4 mm to 2.4 mm, were designed. Their penetrator formation and various performance parameters were studied and compared. Results show that top thickness is between 1.6 mm and 2.0 mm,the formation of penetrator is better,and the penetration capacity is higher. This research can provide guidance for the design of new efficient damage warhead.
参考文献
| [1] | 范斌,王志军,王辉.多爆炸成形弹丸成型过程的数值模拟[J].弹箭与制导学报,2010(01):124-126. |
| [2] | 苟瑞君,赵国志.线性成型装药起爆方式的比较[J].火工品,2006(01):42-45. |
| [3] | 杜忠华,段卫毅.起爆方式对LEFP成型及侵彻影响的数值模拟研究[J].南京理工大学学报（自然科学版）,2009(06):756-759. |
| [4] | 高接东 .基于变壁厚药型罩的LEFP成型机理研究[D].南京理工大学,2013. |
| [5] | 陈军,孙承纬,蒲正美,张光升,高宁.爆轰波对碰区产物驱动金属圆管的研究[J].爆炸与冲击,2003(05):442-447. |
| [6] | 张世文,华劲松,刘仓理,韩长生,王德生,孙学林,张振涛.金属圆管内爆轰波相互作用效应的数值模拟研究[J].爆炸与冲击,2004(03):219-225. |
| [7] | 王锋 .基于爆轰波对撞原理的新型EFP研究[D].南京理工大学,2012. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%