无机粘结固体润滑膜与有机粘结膜相比耐高温性能优良.喷涂制备了磷酸二氢铝粘结石墨固体润滑膜,在M-2000磨损试验机上测试了涂膜在载荷100N干摩擦条件下的环块接触磨损性能并通过扫描电镜观察了磨损前后表面形貌.磨损试验表明,涂膜经过高温烘烤有利于脱除部分水分,组织更致密,其中纯石墨涂膜经过高温烘烤之后磨损量和磨损率均最低,在50min试验周期内磨损率为0.038mg/m(单位行程磨损量);在涂膜中适当添加无机颗粒有利于形成海岛结构增强体,阻止裂纹扩展.
参考文献
[1] | Xian GJ;Walter R;Haupert F .A synergistic effect of nano-TiO2 and graphite on the tribological performance of epoxy matrix composites[J].Journal of Applied Polymer Science,2006(3):2391-2400. |
[2] | Suresha B;Chandramohan G;Renukappa NM;Siddaramaiah .Mechanical and tribological properties of glass-epoxy composites with and without graphite particulate filler[J].Journal of Applied Polymer Science,2007(4):2472-2480. |
[3] | Qiao H B et al.A study on friction and wear characteristics of nanometer Al2O3/PEEK composites under the dry sliding condition[J].Tribology International,2007,40(01):105. |
[4] | 刘]文超 .Research on preparation and proper ties of phosphate bonder and high temperature methal substrate anti-wear ceramic coatings(磷酸盐结合剂及金属基高温耐磨陶瓷涂层的制备与性能的研究)[D].长沙:湖南大学,2001. |
[5] | 温诗铸.纳米摩擦学[M].北京:清华大学出版社,1998:85. |
[6] | Weng D;Jokiel P;Uebleis A et al.Corrosion and protec tion characteristics of zinc and manganese phosphate coa tings[J].Surface and Coatings Technology,1996,88(1-3):147. |
[7] | 乔红斌 .Research on solid lubricating composite films for the surface of gears in the azimuthal drive reducer of therotor-turret(转塔方位动力减速器齿轮复合型固体润滑膜研究)[D].上海:上海大学,2006. |
[8] | 贾江议,李洛利,白剑伟.磷酸二氢铝对Al2O3-SiO2系浇注料性能的影响[J].陶瓷,2008(05):29-31. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%