采用DSC方法对低粘度环氧树脂基体进行了固化度分析,并研究了环氧树脂浇铸体的拉伸强度、拉伸模量、弯曲强度、弯曲模量和热变形温度与固化度之间的关系.结果表明,浇铸体的最高强度不与最高固化度同步出现,但热变形温度随固化度的增加而升高.
The degree of cure of the low viscosity epoxy resin system is calculated by differential scanning calo-rimetry (DSC) technique. The relation of tensile strength, tensile modulus, flexural strength, flexural modulus and temperature of deflection of the epoxy resin casting matrix to the degree of cure is discussed. The results show that the crest value of tensile and flexural strength does not come with the greatest value of curing degree synchronously, but the temperature of deflection increases with the increase of the degree of cure.
参考文献
| [1] | 刘炳禹.固化条件对容器表观质量及力学性能的影响[J].航天工艺,1994(06):34. |
| [2] | Kim H J;Hang C S .Buckling mad post buckling behavior of composite laminates with a de-lamination[J].Composites Science and Technology,1997,57:555. |
| [3] | 潘祖仁.高分子化学[M].北京:化学工业出版社,1997:215. |
| [4] | Crane L W .Analysis of curing kinetics in polymer composites[J].Journal of Polymer Science,1973,11(08):533. |
| [5] | Mijovm J;Kim J;Slaby J .Cure kinetics of epoxy formulations of the type used in advanced composites[J].Journal of Applied Polymer Science,1984,29(04):1449. |
| [6] | 安静波,王仲莉.不饱和聚酯浇铸体拉伸性能与固化度的关系[J].热固性树脂,1998(02):26. |
| [7] | 郭战胜,杜善义,张博明,张宝艳,陈祥宝.先进树脂基复合材料基体双马来酰亚胺的固化动力学[J].哈尔滨工业大学学报,2004(10):1375-1377,1381. |
| [8] | Raju Thomas et al.Cure kinetics,morphology and miscibility of modified DGEBA-based epoxy resin-effects of a liquid rubber inclusion[J].Sci Direct Polym,2007,48:1695. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%