通过对X52钢进行热处理获得三种不同组织。SEM观察发现三种组织分别为铁素体/带状珠光体、马氏体/贝氏体和针状铁素体/回火马氏体。通过动电位极化、线性极化电阻、氢致开裂(HIC)实验和硫化物应力腐蚀开裂(SSC)实验,研究了不同热处理对X52钢在H2S环境中的腐蚀与开裂行为的影响。结果表明马氏体/贝氏体显微组织由于位错密度很高且脆性大,因而腐蚀速率及HIC和SSC敏感性很高。铁素体/带状珠光体组织和针状铁素体/回火马氏体组织腐蚀速率及HIC和SSC敏感性很低。针状铁素体/回火马氏体组织由于不含带状组织且晶粒细小以及碳化物的析出,因此其HIC和SSC抗性优于铁素体/带状珠光体组织。
Three different microstructures of X52 pipeline steel were obtained through different heat treatments. SEM results showed that the three different microstructures were ferrite/band pearlite, martensite/bainite and acicular ferrite/tempered martensite. The effects of microstructures on corrosion and cracking behavior of X52 steel in the H2S-containing solution were studied through potentiodynamic polarization measurements, linear polarization resistance measurements, hydrogen induced cracking (HIC) tests and sulfide stress cracking (SSC) tests. The results showed that martensite/bainite had the highest corrosion rate as well as highest susceptibility to suffer HIC and SSC of all the three microstructures due to its high density tangled dislocation and its high brittlement. Both of ferrite/band pearlite and acicular ferrite/tempered martensite had lower corrosion rate and better HIC and SSC resistance compared to martensite/bainite. However, the acicular ferrite/tempered martensite microstructure had higher resistance of HIC and SSC than ferrite/band pearlite due to the elimination of band structures, grain refinement and the precipitation of fine carbides in the matrix.
参考文献
[1] | |
[2] | |
[3] | |
[4] | |
[5] | |
[6] | |
[7] | |
[8] | |
[9] | Beidokhti B, Dolati A, Koukabi A H. Effects of alloying elements and microstructure on the susceptibility of the welded HSLA steel to hydrogen-induced cracking and sulfide stress cracking [J]. Mater. Sci. Eng., 2009, A507(1/2): 167-173[2] Lucio-Garcia M A, Gonzalez J G, Casales M. Effect of heat treatment on H2S corrosion of a micro-alloyed C-Mn steel [J].Corros. Sci., 2009, 51(10): 2380-2386[3] Ramirez E, Gonzalez-Rodriguez J G, Torres-Islas A, et al. Effect of microstructure on the sulphide stress cracking susceptibility of a high strength pipeline steel [J]. Corros. Sci., 2008, 50(12): 3534-3541[4] Carneiro R A, Ratnapuli R C, Cunhua-lins V F. The influence of chemical composition and microstructure of API pipeline steels on hydrogen induced cracking and sulfide stress corrosion cracking [J]. Mater. Sci. Eng., 2003, A357(1/2): 104-110[5] Zhao M C, Shan Y Y, Xiao F R, et al. Investigation on the H2S-resistant behavior of acicular ferrite and ultrafine ferrite [J]. Mater. Lett., 2002, 57(1): 141-145[6] Gyu T P, Sung U K, Hwan G J, et al. Effect of microstructure on the hydrogen trapping efficiency and hydrogen induced cracking of pipeline steel [J]. Corros. Sci., 2008, 50(7):1865-1871[7] Fragiel A, Serna S, Campillo B, et al. Dissimilar mechanical properties-microstructures microalloyed pipeline steels cracking performance under sour environment [J]. Mater. Sci. Eng.,2007, A467(1/2): 1-7[8] Fragiel A, Serna S, Perez R. Electrochemical study of two microalloyed pipeline steels in H2S environments [J]. Int. J.Hydrogen Energy, 2005, 30(12): 1303-1309[9] Kane R D. Roles of H2S in the behavior of engineering alloy [J]. Int. Mater. Rev., 1985, 30(11): 291-301[10] Arzola S, Mendoza-Florez J, Duran-Romero R, et al. Electrochemical behavior of API X70 steel in hydrogen sulfide-containing solutions [J]. Corrosion, 2006, 62(5): 433-442[11] Huang H H, Tsay W T, Lee J T. Electrochemical behavior of the simulated heat affected zone of A516 carbon steel in H2S solution [J]. Electrochim. Acta, 1996, 41(7/8): 1191-1199[12] Bhargava G, Ramanarayanan T A, Smith S N, et al. Inhibition of iron corrosion by imidazole: an electrochemical and surface science study [J]. Corrosion, 2009, 65(5): 308-317[13] Bernstein I M. Hydrogen-induced cracking in iron: morphology and crack path dependence [J]. Metall. Mater. Trans.,1970, 1(11)B: 3143-3150[14] Mclntyre D R, Boah J K. Review of sour service definitions[J]. Mater. Performance. 1996, 35(88): 54-58[15] Hanninen H E, Lee T C, Robertson I M, et al. In situ observations on the role of hydrogen on deformation and fracture of A5338 pressure vessel steel [J]. J. Mater. Eng.Perform., 1993, 2(6): 807-817[16] Oriani R A. Hydrogen embrittlement of steels [J]. Annu.Rev. Mater. Sci., 1978, 8: 327-357[17] Li M, Li X G, Chen H. A review on corrosion behavior and mechanism of metals wet H2S [J]. Corros. Sci. Prot. Technol.,2005, 17(2): 107-111   |
- 下载量()
- 访问量()
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%