欢迎登录材料期刊网

材料期刊网

高级检索

用热重分析仪、X射线衍射仪、示差扫描量热仪及拉伸试验研究了Co对Ti-49.8Ni(at%, 下同)形状记忆合金相变和形变特性的影响.结果表明,中温退火态Ti-49.8Ni合金冷却/加热时的相变类型为A→R→M/M→A(A-母相,R-R相,M-马氏体相);随退火温度升高,该合金的马氏体相变温度升高, R相变温度先升高后降低;该合金室温相组成为马氏体,具有形状记忆效应(SME).用1%Co置换等量Ti后所得Ti-49.8Ni-1Co合金冷却/加热时的相变类型为A→R→M/M→R→A,相变温度低,室温组成相为母相A,具有超弹性(SE)特性.退火温度低于600 ℃时,Ti-Ni基合金的SME和SE特性良好,退火温度超过600 ℃后,合金氧化加剧,SME和SE特性变差,塑性显著提高.

The effects of Co on the transition and the deformation characteristics of Ti-49.8Ni shape memory alloy were investigated by thermal gravity, X-ray diffraction, differential scanning calorimetry and tensile test. The results indicate that the phase transformation types of intermediate-temperature annealed Ti-49.8Ni alloy during cooling/heating cycle is A→R→M/M→A (A-parent phase, R-R phase, M-martensite phase). With the annealing temperature increasing, the M-phase transformation temperature of Ti-49.8Ni alloy increases, and the R-phase transition temperature increases first and then decreases. The phase of Ti-49.8Ni alloy at room temperature is martensite and shows shape memory effect (SME). After adding 1% Co, the transformation type of Ti-49.8Ni-1Co alloy is A→R→M/M→R→A upon cooling/heating, and the transition temperature of the alloy is low. The phase of Ti-49.8Ni-1Co alloy at room temperature is parent phase, and shows superelasticity (SE). The excellent SME and SE can be obtained in Ti-Ni base alloys when the annealing temperature is below 600 ℃. When the annealing temperature is over 600℃, the oxidation of Ti-Ni alloys speeds up, SME and SE become bad, but the plasticity of the alloy is improved significantly.

参考文献

[1] Humbeeck J V .[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,1999,273-275:134.
[2] Otsuka K;Wayman C M.Shape Memory Materials[M].Cambridge:Cambridge University Press,1998:49.
[3] Hosoda H;Wakashima K;Miyazaki S et al.[J].Materials Research Society Symposium Proceedings,2005,842:353.
[4] 贺志荣,王芳,王永善,夏鹏举,杨波.V和Cr对Ti-Ni超弹性合金相变和形变特性的影响[J].金属学报,2007(12):1293-1296.
[5] 贺志荣,王芳.热处理对Ti-49.8Ni-1.0Co超弹性合金相变行为的影响[J].金属学报,2008(01):23-28.
[6] Hosoda H;Hanada S;Inoue K et al.[J].Intermetallics,1998,6(04):291.
[7] Kishi Y;Yajima Z;Shimizu K et al.[J].Journal of de Physique IV,2001,11(08):101.
[8] Miyazaki S;Nomura K.PROC-IEEE Micro Electro Mechanical Systems[M].Oiso:Piscataway,NJ,1994:176.
[9] Firstov G S;Vitchev R G;Kumar H et al.[J].Biomaterials,2002,23:4863.
[10] 贺志荣.Ti-Ni形状记忆合金多阶段可逆相变的类型及其演化过程[J].金属学报,2007(04):353-357.
[11] Choi M S;Ogawa J;Fukuda T et al.[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2006,438-440:527.
[12] Kishi Y;Yajima Z;Shimizu K .[J].Materials Transactions,2002,43(05):834.
[13] 贺志荣,王芳,周敬恩.Ni含量和热处理对Ti-Ni形状记忆合金相变和形变行为的影响[J].金属热处理,2006(09):17-21.
[14] 贺志荣,张永宏,王永善,周敬恩.Ti49.4Ni50.6超弹性弹簧的相变和形变特性[J].金属学报,2004(01):46-50.
[15] 贺志荣,周敬恩,宫崎修一.固溶时效态Ti-Ni合金相变行为与Ni含量的关系[J].金属学报,2003(06):617-622.
[16] Vaitynathan R;Bourke M A M;Dunand D C .[J].Metallurgical and Materials Transactions,2001,32A:771.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%