室温下，对AZ31镁合金轧制板材依次沿轧向(RD)、横向(TD)和法向(ND)压缩，依据压缩路径的不同，分别对应RD、RD-ND、RD-TD和RD-TD-ND 4种压缩方式，分析上述压缩过程镁合金的力学性能和织构变化，并对上述压缩变形后的镁合金分别进行室温沿RD方向拉伸变形，分析不同压缩变形方式对拉伸力学性能的影响。结果表明：RD-TD压缩过程中对应的{1012}-{1012}二次孪晶大幅度提高屈服强度，试样经RD-TD压缩后产生强烈的{1011}锥面织构和{1010}柱面织构。镁合金经RD方向压缩后，在后续的RD方向拉伸变形中{1012}解孪晶的启动明显提高塑性。
The rolled AZ31 Magnesium alloy sheet was sequentially compressed along rolling direction (RD), transverse direction (TD) or normal direction (ND) at room temperature, the compressions RD, RD-ND, RD-TD and RD-TD-ND were correspondingly defined according to the difference of compression paths, and the mechanical property and texture evolution were analyzed for former compressions. The magnesium alloy sheets experienced the former compressions were then stretched along RD at room temperature, respectively, and the influence of compression method on the subsequent tensile mechanical properties was analyzed. The results predict that the yielding strength greatly increases during TD compression of RD-TD compression due to activations of {10 1 2}-{10 1 2} secondary twin, and the intensive{10 1 1} pyramidal texture and {10 1 0} prismatic texture form within the magnesium sheet after RD-TD compression. The plasticity of AZ31 magnesium alloy sheet stretched along RD followed by the RD compression is obviously improved due to activation of {10 1 2} detwinning.
参考文献
| [1] | Biswas, S.;Kim, D.-I.;Suwas, S..Asymmetric, symmetric rolling of magnesium: Evolution of microstructure, texture, mechanical properties[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2012:19-30. |
| [2] | Jae-Hyung Cho;Hyoung-Wook Kim;Suk-Bong Kang.Bending behavior, and evolution of texture and microstructure during differential speed warm rolling of AZ31B magnesium alloys[J].Acta materialia,201114(14):5638-5651. |
| [3] | 李振;蔡庆伍;江海涛;孟强.异速比对异步轧制AZ31镁合金板材组织和织构的影响[J].北京科技大学学报,2010(8):1017-1022. |
| [4] | 何运斌;潘清林;刘晓艳;李文斌.镁合金等通道转角挤压过程中的晶粒细化机制[J].中国有色金属学报,2011(8):1785-1793. |
| [5] | 毛萍莉;于金程;刘正;董阳;席通.挤压态 Mg-Gd-Y 镁合金动态压缩力学性能与失效行为[J].中国有色金属学报,2013(4):889-897. |
| [6] | 张雷;杨续跃;霍庆欢;田放;张玉晶;周小杰;陈佳.AZ31镁合金板材低温双向反复弯曲变形及退火过程的组织演化[J].金属学报,2011(8):990-996. |
| [7] | Jiejun He;Tianmo Liu;Yin Zhang.Twin characteristics and flow stress evolution in extruded magnesium alloy AZ31 subjected to multiple loads[J].Journal of Alloys and Compounds: An Interdisciplinary Journal of Materials Science and Solid-state Chemistry and Physics,2013:536-542. |
| [8] | Yunchang Xin;Xiaojun Zhou;Houwen Chen;Jian-Feng Nie;Hong Zhang;Yuanyuan Zhang;Qing Liu.Annealing hardening in detwinning deformation of Mg-3Al-lZn alloy[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2014:287-291. |
| [9] | Xin, Y.;Zhou, X.;Liu, Q..Suppressing the tension-compression yield asymmetry of Mg alloy by hybrid extension twins structure[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2013:9-13. |
| [10] | Park, S.H.;Hong, S.-G.;Lee, J.H.;Lee, C.S..Multiple twinning modes in rolled Mg-3Al-1Zn alloy and their selection mechanism[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2012:401-406. |
| [11] | Park, S.H.;Hong, S.-G.;Lee, C.S..Enhanced stretch formability of rolled Mg-3Al-1Zn alloy at room temperature by initial {10-12}twins[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2013:271-276. |
| [12] | Jeong Hun Lee;Taekyung Lee;Seok Weon Song;Sung Hyuk Park;Chong Soo Lee.Enhancing yield strength by suppressing detwinning in a rolled Mg-3Al-1Zn alloy with {1012} twins[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2014:328-333. |
| [13] | D. Sarker;D.L.Chen.Dependence of compressive deformation on pre-strain and loading direction in an extruded magnesium alloy: Texture, twinning and de-twinning[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2014:134-144. |
| [14] | Yunchang Xin;Maoyin Wang;Zhen Zeng.Strengthening and toughening of magnesium alloy by {10-12} extension twins[J].Scripta materialia,20121(1):25-28. |
| [15] | Lou XY;Li M;Boger RK;Agnew SR;Wagoner RH.Hardening evolution of AZ31B Mg sheet[J].International Journal of Plasticity,200726(26):44-86. |
| [16] | Y.N. Wang;J.C. Huang.The role of twinning and untwinning in yielding behavior in hot-extruded Mg-Al-Zn alloy[J].Acta materialia,20073(3):897-905. |
| [17] | L. Wu;A. Jain;D.W. Brown.Twinning--detwinning behavior during the strain-controlled low-cycle fatigue testing of a wrought magnesium alloy, ZK60A[J].Acta Materialia,20084(4):688-695. |
| [18] | A. Jain;S.R. Agnew.Modeling the temperature dependent effect of twinning on the behavior of magnesium alloy AZ31B sheet[J].Materials Science & Engineering. A, Structural Materials: Properties, Microstructure and Processing,20071-2(1-2):29-36. |
| [19] | Proust, G;Tome, CN;Jain, A;Agnew, SR.Modeling the effect of twinning and detwinning during strain-path changes of magnesium alloy AZ31[J].International Journal of Plasticity,20095(5):861-880. |
| [20] | D.Sarker;J.Friedman;D.L.Chen.De-twinning and Texture Change in an Extruded AM30 Magnesium Alloy during Compression along Normal Direction[J].材料科学技术（英文版）,2015(3):264-268. |
| [21] | Wang, H.;Raeisinia, B.;Wu, P.D.;Agnew, S.R.;Tomé, C.N..Evaluation of self-consistent polycrystal plasticity models for magnesium alloy AZ31B sheet[J].International Journal of Solids and Structures,201021(21):2905-2917. |
| [22] | Wang, H.;Wu, P.D.;Wang, J.;Tomé, C.N..A crystal plasticity model for hexagonal close packed (HCP) crystals including twinning and de-twinning mechanisms[J].International Journal of Plasticity,2013:36-52. |
| [23] | 杨续跃;张雷.镁合金温变形过程中的孪生及孪晶交叉[J].金属学报,2009(11):1303-1308. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%