欢迎登录材料期刊网

材料期刊网

高级检索

本文研究了东丽T700与国产碳纤维增强环氧树脂基拉挤杆在20℃和60℃蒸馏水浸泡下的水吸收与剪切性能变化.结果表明,随着温度升高,水扩散速率提高,且沿纤维方向的水扩散系数高于垂直方向.浸泡7d后,碳纤维拉挤杆的剪切强度均发生明显下降,但随着浸泡时间延长,20℃水浸泡试样的剪切强度反而有所上升,而60℃水浸泡试样的剪切强度继续缓慢下降.比较而言,国产碳纤维增强拉挤杆的剪切强度相对较高,界面粘结强度大,但耐水性能相对较差,浸泡后期的强度下降更为明显.

参考文献

[1] V. M. Karbhari;C. Stachowski;L. Wu .Durability of Pultruded E-Glass/Vinylester under Combined Hygrothermal Exposure and Sustained Bending[J].Journal of Materials in Civil Engineering,2007(8):665-673.
[2] Temperature as an Accelerating Factor for Long-Term Durability Testing of FRPs:Should There Be Any Limitations?[J].Journal of composites for construction,2010(4):361-367.
[3] Alvarez V;Vazquez A;De La Osa O .Cyclic water absorption behavior of glass-vinylester and glass-epoxy composites[J].Journal of Composite Materials,2007(10):1275-1289.
[4] de la Osa O;Alvarez V;Vazquez A .Effect of hygrothermal history on water and mechanical properties of glass/vinylester composites[J].Journal of Composite Materials,2006(22):2009-2023.
[5] Yunhua Yu;Peng Li;Gang Sui .Effects of Hygrothermal Aging on the Thermal-Mechanical Properties of Vinylester Resin and its Pultruded Carbon Fiber Composites[J].Polymer Composites,2009(10):1458-1464.
[6] Guijun Xian;Hui Li;Xiansheng Su .Water Absorption and Hygrothermal Ageing of Ultraviolet Cured Glass-Fiber Reinforced Acrylate Composites[J].Polymer Composites,2012(7):1120-1128.
[7] Celine A.Mahieux.Environmental Degradation in Industrial Composites[J].ELSEVIER,2006:17-133.
[8] M.C.Lee;N.A.Peppas .Models of Moisture Transport and Moisture-Induced Stresses in Epoxy Composites[J].Journal of Composite Materials,1993,27(12):1146-1171.
[9] S. Marouani;L. Curtil;P. Hamelin .Ageing of carbon/epoxy and carbon/vinylester composites used in the reinforcement and/or the repair of civil engineering structures[J].Composites, Part B. Engineering,2012(4):2020-2030.
[10] Santhosh, K.;Muniraju, M.;Shivakumar, N.D.;Raguraman, M. .Hygrothermal durability and failure modes of FRP for marine applications[J].Journal of Composite Materials,2012(15):1889-1896.
[11] 吕小军,张琦,马兆庆,许俊华,肖文萍.湿热老化对碳纤维/环氧树脂基复合材料力学性能影响研究[J].材料工程,2005(11):50-53,57.
[12] 于祺,陈平,陆春.纤维增强复合材料的界面研究进展[J].绝缘材料,2005(02):50-56.
[13] Acha, B.A.;Carlsson, L.A. .Evaluation of cure state of vinylester resins[J].Journal of Applied Polymer Science,2013(6):4777-4784.
[14] Mezghani, K. .Long term environmental effects on physical properties of vinylester composite pipes[J].Polymer Testing,2012(1):76-82.
[15] 任慧韬.纤维增强复合材料的耐久性能试验研究[J].,2005(10):521-526.
[16] F.Rosselli;M.H.Santare.Comparison of the short beam shear (SBS) and interlaminar shear device (ISD) tests[J].COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING,1997:587-594.
[17] Chi-Hung Shen;George S.Springer .Moisture Absorption and Desorption of Composite Materials[J].Journal of Composite Materials,1976,1(10):2-20.
[18] Vistasp M. Karbhari;Guijun Xian .Hygrothermal effects on high V_F pultruded unidirectional carbon/epoxy composites: Moisture uptake[J].Composites, Part B. Engineering,2009(1):41-49.
[19] 李晓艳 .FRP拉挤制品用环氧树脂基体的湿热耐久性能研究[D].哈尔滨工业大学,2012.
[20] Michael W Nielsen;Jacob W Schmidt;Jacob H H?gh;Jacob P Waldbj?rn;Jesper H Hattel;Tom L Andersen;Christen M Markussen .Life cycle strain monitoring in glass fibre reinforced polymer laminates using embedded fibre Bragg grating sensors from manufacturing to failure[J].Journal of Composite Materials,2014(3):365-381.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%