对热轧25MnV钢石油套管进行了不同工艺的淬火热处理试验，通过组织观察和力学性能测试等手段，对比研究了直接淬水冷却至室温和水-空-水交替淬火两种工艺对合金显微组织与力学性能的影响。结果表明：水一空一水交替淬火可有效减缓石油套管的淬火内应力，所得马氏体＋下贝氏体的复相组织可降低淬火裂纹产生和扩展的趋势，提高了石油套管的使用安全性。经590℃×65min回火后，套管的抗拉强度达到932MPa，屈服强度为870MPa，横向冲击功高达55J，综合力学性能远远超过当前的调质态套管，分析认为这归功于复相组织中微细孪晶马氏体的减少以及部分下贝氏体和少量残留奥氏体等二次析出相的综合作用。
Hot rolled 25MnV steel was quenched by different quenching process. The influence of quenching cooling methods including direct quenching by water cooling to room temperature and water-air alternative quenching on mierostrueture and mechanical properties of the steel was studied by microstrueture observation and mechanical property tests. The results show that under the condition of water-air- water alternative quenching, the quenching internal stress of the experimental steel can be effectively reduced, and the duplex micro structure of martensite and lower bainite decreases the tendency of cracking for the oill casing. After tempering at 590 ~C for 65 min, tensile strength, yield strength and impact energy of the steel reach 932 MPa, 870 MPa and 55 J, respectively, much higher than that of the commercial oil easing steel. It is suggested that the improvement of mechanical properties is attributed to the duplex microstructure of lath martensite, lower bainite small amount of residual austenite in the steel by water-air-water alternative quenching.
参考文献
| [1] | API Spec 5 CT specification for drill pipes[M].American Petroleum Institute,2005:7. |
| [2] | 李亚欣,刘雅政,洪斌,朱洪武,邹喜洋.P110级石油套管淬火组织形态对残余应力的影响[J].钢铁研究学报,2010(08):55-59. |
| [3] | 李亚欣,刘雅政,周乐育,李阳华,邹喜洋.石油套管淬火冷却中三维耦合场的有限元模拟[J].材料热处理学报,2011(01):155-161. |
| [4] | 唐明华,胡双开,刘志义.石油钻井25MnV钢套管调质工艺的改进[J].热加工工艺,2011(12):175-177. |
| [5] | 李安铭,王海瑞.亚温淬火对25MnV钢显微组织和力学性能的影响[J].机械工程材料,2009(12):36-38. |
| [6] | 唐明华,刘志义,胡双开,金潇明,李建中.ZrC/奥氏体相界面形变诱导相变动力学[J].中南大学学报（自然科学版）,2010(01):120-124. |
| [7] | 刘强,石伟.大型锻件水空交替淬火过程的数值模拟[J].大型铸锻件,2009(04):5-9. |
| [8] | 李亚欣,刘雅政,赵金锋,邹喜洋,唐应波.P110级25MnV钢石油套管热处理工艺的优化[J].特殊钢,2009(06):36-38. |
| [9] | 胡赓祥;蔡瑜;戎咏华.材料科学基础[M].上海:上海交通大学出版社,2006 |
| [10] | 赵乃勤.合金固态相变[M].长沙:中南大学出版社,2008 |
| [11] | 韩礼红,姜新越,冯耀荣,蔡和平,王青林.分级热处理对钻杆材料力学行为的影响[J].材料热处理学报,2011(04):97-103. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%