针对100 μm和200 μm厚的2种超薄微制品,采用单因素实验,对等规聚丙烯微注塑制品的形态结构进行研究,并分析注射速度对超薄微注塑制品形态结构的影响.研究结果表明,超薄微注塑制品中呈现出2种典型的形态结构,200μn微制品厚度方向呈现出纯剪切层的无芯结构,剪切层内为明显的Shish-Kebab结构;100μtm厚微制品内部形态为含大比例柱晶结构的皮芯结构;广角X射线衍射结果显示无芯结构内形态沿流动方向呈现高度取向,且β晶含量微弱.含柱晶层皮芯结构的取向也较明显,且结构中有明显β晶存在.注射速度对超薄微注塑制品的形态结构、结晶度和取向度都有重要的影响,存在临界注射速度,当注射速度小于该临界速度时,制品内部结晶度、取向度随着注射速度的提高而提高.
参考文献
| [1] | Zhen Lu;K. F. Zhang .Morphology and mechanical properties of polypropylene micro-arrays by micro-injection molding[J].The International Journal of Advanced Manufacturing Technology,2009(5/6):490-496. |
| [2] | M. R. Kamal;J. Chu;S. Derdouri .Morphology of microinjection moulded polyoxymethylene[J].Plastics, Rubber and Composites,2010(7):332-341. |
| [3] | Fanghui Liu;Chao Guo;Xian Wu;Xinyuan Qian;Hong Liu;Jie Zhang .Morphological comparison of isotactic polypropylene parts prepared bymicro-injection molding and conventional injection molding[J].Polymers for advanced technologies,2012(3):686-694. |
| [4] | Lin, X.;Caton-Rose, F.;Ren, D.;Wang, K.;Coates, P. .Shear-induced crystallization morphology and mechanical property of high density polyethylene in micro-injection molding[J].Journal of Polymer Research,2013(4):122-1-122-12. |
| [5] | 李爽 .等规聚丙烯微注塑制品可成型性及形态结构的研究[D].郑州大学,2013. |
| [6] | Lotz B. .alpha and beta phases of isotactic polypropylene: a case of growth kinetics 'phase reentrency' in polymer crystallization[J].Polymer: The International Journal for the Science and Technology of Polymers,1998(19):4561-4567. |
| [7] | I.Dukovski;M.Muthukumar .Langevin dynamics simulations of early stage shish-kebab crystallization of polymers in extensional flow[J].The Journal of Chemical Physics,2003(14):6648-6655. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%