建立了氧气高炉煤气不循环利用流程，炉身喷吹循环煤气流程和炉缸喷吹循环煤气流程数学模型，分析了工艺参数对氧气高炉能耗的影响，结果表明：煤气不循环利用流程一次能耗远远高于煤气循环利用流程，不适合进行工业化生产；金属化率对氧气高炉能耗影响很大，金属化率每升高5％，吨铁焦比降低约37kg；煤气循环利用流程各煤气量匹配要合理，炉顶煤气需要能够满足煤气加热和循环利用；带人炉内的氮气量要小，否则循环煤气富氮率大，煤气的还原性下降。
Oxygen blast furnace gas no recycling process, cycle gas inject shaft and cycle gas inject hearth process mathematical model was established. Effect of process parameters on energy consumption of the oxygen blast fur- nace was analyzed. Results show that the primary energy consumption of gas no recycling process is much higher than gas recycling process. It is not suitable for industrial production. Metallization has a great influence on the energy consumption of the oxygen blast furnace. With the metallization increased of 5 ~//00, coke ratio decreased about 37 kg/t（Fe）. Gas generated should meet different use, and top gas can reach the use of heating and recycling. A- mount of nitrogen gas into the furnace to be low, otherwise the rate of nitrogen of cycle gas is high, and reduction of gas down.
参考文献
| [1] | 张建良 .氧气高炉的应用基础研究[D].北京科技大学,2001. |
| [2] | Yotaro Ohno;Hirohisa Hotta;Masahiro Matsuura.De- velopment of Oxygen Blast Furnace Process With Preheating Gas in Jection Into Upper Shaft[J].ISIJ International,1989(08):42. |
| [3] | Tseitlin M A;Lazutkin S E;Styopin G M.A Flow-Chart for Iron Making on Basis of 100% Usage of Process Oxygen and Hot Re- ducing Gases Injection[J].ISIJ International,1994(34):570. |
| [4] | QIN Min-sheng;GAO Zheng kai;WANG Guan-lun et al.Blast Furnace Operation With Full Oxygen Blast[J].Iron- making and Steelmaking,1988,15(06):287. |
| [5] | 尹建威,王凤岐,党玉华,张建良,高征铠.氧气高炉炉身的模拟试验研究[J].钢铁研究学报,2002(02):1-4. |
| [6] | 王筱留.钢铁冶金学(炼铁部分)[M].北京:冶金工业出版社,2006 |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%